Commit d6020787 authored by Brice Goglin's avatar Brice Goglin Committed by Jeff Garzik

[PATCH] myri10ge - Use dev_info() when printing parameters after probe

Displaying the interface name when listing the device parameters
at the end of myri10ge_probe is not a good idea since udev might
rename the interface soon afterwards.
Print the bus id instead, using dev_info().
Signed-off-by: default avatarBrice Goglin <brice@myri.com>
Signed-off-by: default avatarJeff Garzik <jeff@garzik.org>
parent 18ac5443
...@@ -2734,9 +2734,8 @@ static int myri10ge_probe(struct pci_dev *pdev, const struct pci_device_id *ent) ...@@ -2734,9 +2734,8 @@ static int myri10ge_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
dev_err(&pdev->dev, "register_netdev failed: %d\n", status); dev_err(&pdev->dev, "register_netdev failed: %d\n", status);
goto abort_with_irq; goto abort_with_irq;
} }
dev_info(dev, "%s IRQ %d, tx bndry %d, fw %s, WC %s\n",
printk(KERN_INFO "myri10ge: %s: %s IRQ %d, tx bndry %d, fw %s, WC %s\n", (mgp->msi_enabled ? "MSI" : "xPIC"),
netdev->name, (mgp->msi_enabled ? "MSI" : "xPIC"),
pdev->irq, mgp->tx.boundary, mgp->fw_name, pdev->irq, mgp->tx.boundary, mgp->fw_name,
(mgp->mtrr >= 0 ? "Enabled" : "Disabled")); (mgp->mtrr >= 0 ? "Enabled" : "Disabled"));
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment