mtd: rawnand: add NVIDIA Tegra NAND Flash controller driver

Add support for the NAND flash controller found on NVIDIA
Tegra 2 SoCs. This implementation does not make use of the
command queue feature. Regular operations using ->exec_op()
use PIO mode for data transfers. Raw, ECC and OOB read/writes
make use of the DMA mode for data transfer.
Signed-off-by: Lucas Stach <dev@lynxeye.de>
Signed-off-by: Stefan Agner <stefan@agner.ch>
Reviewed-by: Dmitry Osipenko <digetx@gmail.com>
Reviewed-by: Boris Brezillon <boris.brezillon@bootlin.com>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>

MAINTAINERS

@@ -14054,6 +14054,13 @@ M:	Laxman Dewangan <ldewangan@nvidia.com>
 S:	Supported
 F:	drivers/input/keyboard/tegra-kbc.c
 
+TEGRA NAND DRIVER
+M:	Stefan Agner <stefan@agner.ch>
+M:	Lucas Stach <dev@lynxeye.de>
+S:	Maintained
+F:	Documentation/devicetree/bindings/mtd/nvidia-tegra20-nand.txt
+F:	drivers/mtd/nand/raw/tegra_nand.c
+
 TEGRA PWM DRIVER
 M:	Thierry Reding <thierry.reding@gmail.com>
 S:	Supported

drivers/mtd/nand/raw/Kconfig

@@ -530,4 +530,14 @@ config MTD_NAND_MTK
 	  Enables support for NAND controller on MTK SoCs.
 	  This controller is found on mt27xx, mt81xx, mt65xx SoCs.
 
+config MTD_NAND_TEGRA
+	tristate "Support for NAND controller on NVIDIA Tegra"
+	depends on ARCH_TEGRA || COMPILE_TEST
+	help
+	  Enables support for NAND flash controller on NVIDIA Tegra SoC.
+	  The driver has been developed and tested on a Tegra 2 SoC. DMA
+	  support, raw read/write page as well as HW ECC read/write page
+	  is supported. Extra OOB bytes when using HW ECC are currently
+	  not supported.
+
 endif # MTD_NAND

drivers/mtd/nand/raw/Makefile

@@ -56,6 +56,7 @@ obj-$(CONFIG_MTD_NAND_HISI504)	        += hisi504_nand.o
 obj-$(CONFIG_MTD_NAND_BRCMNAND)		+= brcmnand/
 obj-$(CONFIG_MTD_NAND_QCOM)		+= qcom_nandc.o
 obj-$(CONFIG_MTD_NAND_MTK)		+= mtk_ecc.o mtk_nand.o
+obj-$(CONFIG_MTD_NAND_TEGRA)		+= tegra_nand.o
 
 nand-objs := nand_base.o nand_bbt.o nand_timings.o nand_ids.o
 nand-objs += nand_amd.o