Commit d9fb5660 authored by Ralf Baechle's avatar Ralf Baechle

MIPS: Loongson: Do not register 8250 platform device from module.

If CONFIG_SERIAL_8250 is set to m, the Loongson seria.ko module might get
unloaded while the serial driver modules are still loaded resulting in
stale references to the destroyed platform_device instance.

Anyway, platform devices should always be registered indicated what
devices are present, _not_ what drivers have been configured.
Signed-off-by: default avatarRalf Baechle <ralf@linux-mips.org>
Reported-by: default avatarPaul Gortmaker <paul.gortmaker@windriver.com>
Patchwork: https://patchwork.linux-mips.org/patch/10538/
parent 34b1252b
...@@ -3,15 +3,13 @@ ...@@ -3,15 +3,13 @@
# #
obj-y += setup.o init.o cmdline.o env.o time.o reset.o irq.o \ obj-y += setup.o init.o cmdline.o env.o time.o reset.o irq.o \
bonito-irq.o mem.o machtype.o platform.o bonito-irq.o mem.o machtype.o platform.o serial.o
obj-$(CONFIG_PCI) += pci.o obj-$(CONFIG_PCI) += pci.o
# #
# Serial port support # Serial port support
# #
obj-$(CONFIG_EARLY_PRINTK) += early_printk.o obj-$(CONFIG_EARLY_PRINTK) += early_printk.o
loongson-serial-$(CONFIG_SERIAL_8250) := serial.o
obj-y += $(loongson-serial-m) $(loongson-serial-y)
obj-$(CONFIG_LOONGSON_UART_BASE) += uart_base.o obj-$(CONFIG_LOONGSON_UART_BASE) += uart_base.o
obj-$(CONFIG_LOONGSON_MC146818) += rtc.o obj-$(CONFIG_LOONGSON_MC146818) += rtc.o
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment