arm64: dts: ls1028a: fix memory node

While enabling EDAC support for the LS1028A it was discovered that the
memory node has a wrong endianness setting as well as a wrong interrupt
assignment. Fix both.

This was tested on a sl28 board. To force ECC errors, you can use the
error injection supported by the controller in hardware (with
CONFIG_EDAC_DEBUG enabled):

 # enable error injection
 $ echo 0x100 > /sys/devices/system/edac/mc/mc0/inject_ctrl
 # flip lowest bit of the data
 $ echo 0x1 > /sys/devices/system/edac/mc/mc0/inject_data_lo

Fixes: 8897f325 ("arm64: dts: Add support for NXP LS1028A SoC")
Signed-off-by: Michael Walle <michael@walle.cc>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi

@@ -197,8 +197,8 @@ soc: soc {
 		ddr: memory-controller@1080000 {
 			compatible = "fsl,qoriq-memory-controller";
 			reg = <0x0 0x1080000 0x0 0x1000>;
-			interrupts = <GIC_SPI 144 IRQ_TYPE_LEVEL_HIGH>;
-			big-endian;
+			interrupts = <GIC_SPI 17 IRQ_TYPE_LEVEL_HIGH>;
+			little-endian;
 		};
 
 		dcfg: syscon@1e00000 {