Commit dec2165f authored by Sonic Zhang's avatar Sonic Zhang Committed by David S. Miller

stmmac: hardware TX COE doesn't work when force_thresh_dma_mode is set

Clear the TX COE bit when force_thresh_dma_mode is set even hardware
dma capability says support.

Tested on BF609.
Signed-off-by: default avatarSonic Zhang <sonic.zhang@analog.com>
Acked-by: default avatarGiuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent c405abe2
...@@ -2755,7 +2755,11 @@ static int stmmac_hw_init(struct stmmac_priv *priv) ...@@ -2755,7 +2755,11 @@ static int stmmac_hw_init(struct stmmac_priv *priv)
priv->plat->enh_desc = priv->dma_cap.enh_desc; priv->plat->enh_desc = priv->dma_cap.enh_desc;
priv->plat->pmt = priv->dma_cap.pmt_remote_wake_up; priv->plat->pmt = priv->dma_cap.pmt_remote_wake_up;
priv->plat->tx_coe = priv->dma_cap.tx_coe; /* TXCOE doesn't work in thresh DMA mode */
if (priv->plat->force_thresh_dma_mode)
priv->plat->tx_coe = 0;
else
priv->plat->tx_coe = priv->dma_cap.tx_coe;
if (priv->dma_cap.rx_coe_type2) if (priv->dma_cap.rx_coe_type2)
priv->plat->rx_coe = STMMAC_RX_COE_TYPE2; priv->plat->rx_coe = STMMAC_RX_COE_TYPE2;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment