can: Driver for the Microchip MCP251x SPI CAN controllers

Signed-off-by: Christian Pellegrin <chripell@fsfe.org>
Signed-off-by: Wolfgang Grandegger <wg@grandegger.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/can/Kconfig

@@ -102,6 +102,12 @@ config CAN_TI_HECC
 	  Driver for TI HECC (High End CAN Controller) module found on many
 	  TI devices. The device specifications are available from www.ti.com
 
+config CAN_MCP251X
+	tristate "Microchip MCP251x SPI CAN controllers"
+	depends on CAN_DEV && SPI
+	---help---
+	  Driver for the Microchip MCP251x SPI CAN controllers.
+
 config CAN_DEBUG_DEVICES
 	bool "CAN devices debugging messages"
 	depends on CAN

drivers/net/can/Makefile

@@ -12,5 +12,6 @@ obj-y				+= usb/
 obj-$(CONFIG_CAN_SJA1000)	+= sja1000/
 obj-$(CONFIG_CAN_AT91)		+= at91_can.o
 obj-$(CONFIG_CAN_TI_HECC)	+= ti_hecc.o
+obj-$(CONFIG_CAN_MCP251X)	+= mcp251x.o
 
 ccflags-$(CONFIG_CAN_DEBUG_DEVICES) := -DDEBUG

include/linux/can/platform/mcp251x.h

+#ifndef __CAN_PLATFORM_MCP251X_H__
+#define __CAN_PLATFORM_MCP251X_H__
+
+/*
+ *
+ * CAN bus driver for Microchip 251x CAN Controller with SPI Interface
+ *
+ */
+
+#include <linux/spi/spi.h>
+
+/**
+ * struct mcp251x_platform_data - MCP251X SPI CAN controller platform data
+ * @oscillator_frequency:       - oscillator frequency in Hz
+ * @model:                      - actual type of chip
+ * @board_specific_setup:       - called before probing the chip (power,reset)
+ * @transceiver_enable:         - called to power on/off the transceiver
+ * @power_enable:               - called to power on/off the mcp *and* the
+ *                                transceiver
+ *
+ * Please note that you should define power_enable or transceiver_enable or
+ * none of them. Defining both of them is no use.
+ *
+ */
+
+struct mcp251x_platform_data {
+	unsigned long oscillator_frequency;
+	int model;
+#define CAN_MCP251X_MCP2510 0
+#define CAN_MCP251X_MCP2515 1
+	int (*board_specific_setup)(struct spi_device *spi);
+	int (*transceiver_enable)(int enable);
+	int (*power_enable) (int enable);
+};
+
+#endif /* __CAN_PLATFORM_MCP251X_H__ */