Commit f8b7f1f8 authored by Andrzej Hajda's avatar Andrzej Hajda Committed by Inki Dae

dt-bindings: exynos5433-decon: add TE interrupt binding

DECON command mode can use hardware trigger where transmission
is triggered automatically, or software trigger - where TE interrupt
handler should trigger transmission.
DECON will use software trigger if TE interrupt is specified.
Signed-off-by: default avatarAndrzej Hajda <a.hajda@samsung.com>
Signed-off-by: default avatarInki Dae <inki.dae@samsung.com>
parent a8875f82
...@@ -10,7 +10,8 @@ Required properties: ...@@ -10,7 +10,8 @@ Required properties:
- reg: physical base address and length of the DECON registers set. - reg: physical base address and length of the DECON registers set.
- interrupt-names: should contain the interrupt names depending on mode of work: - interrupt-names: should contain the interrupt names depending on mode of work:
video mode: "vsync", video mode: "vsync",
command mode: "lcd_sys". command mode: "lcd_sys",
command mode with software trigger: "lcd_sys", "te".
- interrupts or interrupts-extended: list of interrupt specifiers corresponding - interrupts or interrupts-extended: list of interrupt specifiers corresponding
to names privided in interrupt-names, as described in to names privided in interrupt-names, as described in
interrupt-controller/interrupts.txt interrupt-controller/interrupts.txt
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment