sdhci: Add quirk for controllers with no end-of-busy IRQ

The Samsung SDHCI (and FSL eSDHC) controller block seems to fail
to generate an INT_DATA_END after the transfer has completed and
the bus busy state finished.

Changes in e809517f to use the
new busy method are the cause of the behaviour change.
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>

drivers/mmc/host/sdhci.c

@@ -1291,8 +1291,11 @@ static void sdhci_cmd_irq(struct sdhci_host *host, u32 intmask)
 		if (host->cmd->data)
 			DBG("Cannot wait for busy signal when also "
 				"doing a data transfer");
-		else
+		else if (!(host->quirks & SDHCI_QUIRK_NO_BUSY_IRQ))
 			return;
+
+		/* The controller does not support the end-of-busy IRQ,
+		 * fall through and take the SDHCI_INT_RESPONSE */
 	}
 
 	if (intmask & SDHCI_INT_RESPONSE)

drivers/mmc/host/sdhci.h

@@ -208,6 +208,8 @@ struct sdhci_host {
 #define SDHCI_QUIRK_BROKEN_TIMEOUT_VAL			(1<<12)
 /* Controller has an issue with buffer bits for small transfers */
 #define SDHCI_QUIRK_BROKEN_SMALL_PIO			(1<<13)
+/* Controller does not provide transfer-complete interrupt when not busy */
+#define SDHCI_QUIRK_NO_BUSY_IRQ				(1<<14)
 
 	int			irq;		/* Device IRQ */
 	void __iomem *		ioaddr;		/* Mapped address */