ARM: dts: at91: sama5d27_som1_ek: remove not connected CAN0

CAN0 is not connected on the sama5d27_som1_ek board, so remove
it from DT.
Signed-off-by: Nicolas Ferre <nicolas.ferre@microchip.com>
[claudiu.beznea@microchip.com: change subject to match the desired prefix]
Signed-off-by: Claudiu Beznea <claudiu.beznea@microchip.com>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>

arch/arm/boot/dts/at91-sama5d27_som1_ek.dts

@@ -172,12 +172,6 @@ watchdog@f8048040 {
 				status = "okay";
 			};
 
-			can0: can@f8054000 {
-				pinctrl-names = "default";
-				pinctrl-0 = <&pinctrl_can0_default>;
-				status = "disabled"; /* Conflict with isc. */
-			};
-
 			uart3: serial@fc008000 {
 				atmel,use-dma-rx;
 				atmel,use-dma-tx;
@@ -276,12 +270,6 @@ i2c1: i2c@fc028000 {
 
 			pinctrl@fc038000 {
 
-				pinctrl_can0_default: can0_default {
-					pinmux = <PIN_PC10__CANTX0>,
-						 <PIN_PC11__CANRX0>;
-					bias-disable;
-				};
-
 				pinctrl_can1_default: can1_default {
 					pinmux = <PIN_PC26__CANTX1>,
 						 <PIN_PC27__CANRX1>;