- 15 Nov, 2005 19 commits
-
-
Andi Kleen authored
Adding __initdata_* to asm-generic/sections.h Replaces a lot of open coded externs in arch/x86_64/* I had to change __bss_end to __bss_stop to match the other architectures. Signed-off-by:
Andi Kleen <ak@suse.de> Signed-off-by:
Linus Torvalds <torvalds@osdl.org>
-
Andi Kleen authored
It is for physical addresses, not for PFNs. Pointed out by Tejun Heo. Cc: htejun@gmail.com Signed-off-by:
-
Siddha, Suresh B authored
We should zap the low mappings, as soon as possible, so that we can catch kernel bugs more effectively. Previously early boot had NULL mapped and didn't trap on NULL references. This patch introduces boot_level4_pgt, which will always have low identity addresses mapped. Druing boot, all the processors will use this as their level4 pgt. On BP, we will switch to init_level4_pgt as soon as we enter C code and zap the low mappings as soon as we are done with the usage of identity low mapped addresses. On AP's we will zap the low mappings as soon as we jump to C code. Signed-off-by:
Suresh Siddha <suresh.b.siddha@intel.com> Signed-off-by:
Ashok Raj <ashok.raj@intel.com> Signed-off-by:
-
Andi Kleen authored
Not go from the CPU number to an mapping array. Mode number is often used now in fast paths. This also adds a generic numa_node_id to all the topology includes Suggested by Eric Dumazet Signed-off-by:
-
Andi Kleen authored
Fix arch/x86_64/kernel/aperture.c: In function #iommu_hole_init#: arch/x86_64/kernel/aperture.c:199: warning: #aper_order# may be used uninitialized in this function Signed-off-by:
-
Suresh Siddha authored
According to cpuid instruction in IA32 SDM-Vol2, when computing cpu model, we need to consider extended model ID for family 0x6 also. AK: Also added fixes/simplifcation from Petr Vandrovec Signed-off-by:
-
Ashok Raj authored
Remove duplicate __cpuinit in smp.c. Already defined in init.h which is already included. Signed-off-by:
-
Andi Kleen authored
Signed-off-by:
-
Andi Kleen authored
Has been introduced for x86-64 at some point to save memory in struct page, but has been obsolete for some time. Just remove it. Signed-off-by:
-
Andi Kleen authored
pfn_to_page really requires pfn_valid to be true now, no question. Some people stumbled over it, but it was misleading and wrong. Signed-off-by:
-
James Cleverdon authored
Here's a patch that builds on Natalie Protasevich's IRQ compression patch and tries to work for MPS boots as well as ACPI. It is meant for a 4-node IBM x460 NUMA box, which was dying because it had interrupt pins with GSI numbers > NR_IRQS and thus overflowed irq_desc. The problem is that this system has 270 GSIs (which are 1:1 mapped with I/O APIC RTEs) and an 8-node box would have 540. This is much bigger than NR_IRQS (224 for both i386 and x86_64). Also, there aren't enough vectors to go around. There are about 190 usable vectors, not counting the reserved ones and the unused vectors at 0x20 to 0x2F. So, my patch attempts to compress the GSI range and share vectors by sharing IRQs. Cc: "Protasevich, Natalie" <Natalie.Protasevich@unisys.com> Signed-off-by:
-
Jacob Shin authored
MC4_MISC - DRAM Errors Threshold Register realized under AMD K8 Rev F. This register is used to count correctable and uncorrectable ECC errors that occur during DRAM read operations. The user may interface through sysfs files in order to change the threshold configuration. bank%d/error_count - reads current error count, write to clear. bank%d/interrupt_enable - set/clear interrupt enable. bank%d/threshold_limit - read/write the threshold limit. APIC vector 0xF9 in hw_irq.h. 5 software defined bank ids in mce.h. new apic.c function to setup threshold apic lvt. defaults to interrupt off, count enabled, and threshold limit max. sysfs interface created on /sys/devices/system/threshold. AK: added some ifdefs to make it compile on UP Signed-off-by:
Jacob Shin <jacob.shin@amd.com> Signed-off-by:
-
Jan Beulich authored
Signed-off-by:
Jan Beulich <jbeulich@novell.com> Signed-off-by:
-
Andi Kleen authored
The VM needs to know about lost memory in zones to accurately balance dirty pages. This patch accounts mem_map in there too, which fixes a constant errror of a few percent. Also some other misc mappings and the kernel text itself are accounted too. Signed-off-by:
-
Andi Kleen authored
Signed-off-by:
-
Andi Kleen authored
The code should deal with an additional empty zone, so fix up the #error. Signed-off-by:
-
Andi Kleen authored
IA64 traditionally had a 4GB DMA32 zone. Set the compatibility flag to keep old drivers working. For new drivers it would be better to use ZONE_DMA32 now. Cc: tony.luck@intel.com Signed-off-by:
-
Andi Kleen authored
Add a new 4GB GFP_DMA32 zone between the GFP_DMA and GFP_NORMAL zones. As a bit of historical background: when the x86-64 port was originally designed we had some discussion if we should use a 16MB DMA zone like i386 or a 4GB DMA zone like IA64 or both. Both was ruled out at this point because it was in early 2.4 when VM is still quite shakey and had bad troubles even dealing with one DMA zone. We settled on the 16MB DMA zone mainly because we worried about older soundcards and the floppy. But this has always caused problems since then because device drivers had trouble getting enough DMA able memory. These days the VM works much better and the wide use of NUMA has proven it can deal with many zones successfully. So this patch adds both zones. This helps drivers who need a lot of memory below 4GB because their hardware is not accessing more (graphic drivers - proprietary and free ones, video frame buffer drivers, sound drivers etc.). Previously they could only use IOMMU+16MB GFP_DMA, which was not enough memory. Another common problem is that hardware who has full memory addressing for >4GB misses it for some control structures in memory (like transmit rings or other metadata). They tended to allocate memory in the 16MB GFP_DMA or the IOMMU/swiotlb then using pci_alloc_consistent, but that can tie up a lot of precious 16MB GFPDMA/IOMMU/swiotlb memory (even on AMD systems the IOMMU tends to be quite small) especially if you have many devices. With the new zone pci_alloc_consistent can just put this stuff into memory below 4GB which works better. One argument was still if the zone should be 4GB or 2GB. The main motivation for 2GB would be an unnamed not so unpopular hardware raid controller (mostly found in older machines from a particular four letter company) who has a strange 2GB restriction in firmware. But that one works ok with swiotlb/IOMMU anyways, so it doesn't really need GFP_DMA32. I chose 4GB to be compatible with IA64 and because it seems to be the most common restriction. The new zone is so far added only for x86-64. For other architectures who don't set up this new zone nothing changes. Architectures can set a compatibility define in Kconfig CONFIG_DMA_IS_DMA32 that will define GFP_DMA32 as GFP_DMA. Otherwise it's a nop because on 32bit architectures it's normally not needed because GFP_NORMAL (=0) is DMA able enough. One problem is still that GFP_DMA means different things on different architectures. e.g. some drivers used to have #ifdef ia64 use GFP_DMA (trusting it to be 4GB) #elif __x86_64__ (use other hacks like the swiotlb because 16MB is not enough) ... . This was quite ugly and is now obsolete. These should be now converted to use GFP_DMA32 unconditionally. I haven't done this yet. Or best only use pci_alloc_consistent/dma_alloc_coherent which will use GFP_DMA32 transparently. Signed-off-by:
-
Andi Kleen authored
Rerun and enable autofs 4, relayfs and softdog Signed-off-by:
-
- 05 Nov, 2005 6 commits
-
-
Jeff Garzik authored
Use ata_pad_{alloc,free} in two drivers, to factor out common code. Add ata_pad_{alloc,free} to two other drivers, which needed the padding but had not been updated. -
Jeff Garzik authored
-
Calin A. Culianu authored
This adds support for the Nvidia Geforce 7800 series of cards to the nvidiafb framebuffer driver. All it does is add the PCI device id for the 7800, 7800 GTX, 7800 GO, and 7800 GTX GO cards to the module device table for the nvidiafb.ko driver, so that nvidiafb.ko will actually work on these cards. I also added the relevant PCI device ids to linux/pci_ids.h I tested it on my 7800 GTX here and it works like a charm. I now can get framebuffer support on this card! Woo hoo!! Nothing like 200x75 text mode to make your eyes BLEED. ;) Signed-off-by: -
Linus Torvalds authored
-
Linus Torvalds authored
-
Linus Torvalds authored
-
- 04 Nov, 2005 15 commits
-
-
Paul Mackerras authored
We can't currently use asm-ppc/page.h in vmlinux.lds.S, so until we have a merged page.h, define PAGE_SIZE and KERNELBASE locally. Also gets rid of some dynamic executable cruft that we had for 32-bit. With -Ttext=$(KERNELBASE) this didn't cause any problem, but when we changed to putting . = KERNELBASE in the vmlinux.lds.S this cruft caused the text to get linked at 0xa0 instead of 0xc0000000. Oops. Signed-off-by:Paul Mackerras <paulus@samba.org>
-
Paul Mackerras authored
This also moves setup_cpu_maps to setup-common.c (calling it smp_setup_cpu_maps) and uses it on both 32-bit and 64-bit. Signed-off-by: -
Chuck Lever authored
Fix some dprintk's so that NLM, NFS client, and RPC client compile cleanly if CONFIG_SYSCTL is disabled. Test plan: Compile kernel with CONFIG_NFS enabled and CONFIG_SYSCTL disabled. Signed-off-by:
Chuck Lever <cel@netapp.com> Signed-off-by:
Trond Myklebust <Trond.Myklebust@netapp.com>
-
Chuck Lever authored
The sunrpc module should build properly even when CONFIG_SYSCTL is disabled. Reported by Jan-Benedict Glaw. Test plan: Compile kernel with CONFIG_NFS as a module and built-in, and CONFIG_SYSCTL enabled and disabled. Signed-off-by:
-
Trond Myklebust authored
Now that we have a method of dealing with delegation recalls, actually enable the caching of posix and BSD locks. Signed-off-by: -
Trond Myklebust authored
Delegations allow us to cache posix and BSD locks, however when the delegation is recalled, we need to "flush the cache" and send the cached LOCK requests to the server. This patch sets up the mechanism for doing so. Signed-off-by: -
Trond Myklebust authored
Signed-off-by: -
Trond Myklebust authored
I missed this one... Any form of rename will result in a delegation recall, so it is more efficient to return the one we hold before trying the rename. Signed-off-by: -
Trond Myklebust authored
Ensure that we retry the failed operation... Signed-off-by: -
Trond Myklebust authored
RFC 3530 states that for OPEN_DOWNGRADE "The share_access and share_deny bits specified must be exactly equal to the union of the share_access and share_deny bits specified for some subset of the OPENs in effect for current openowner on the current file. Setattr is currently violating the NFSv4 rules for OPEN_DOWNGRADE in that it may cause a downgrade from OPEN4_SHARE_ACCESS_BOTH to OPEN4_SHARE_ACCESS_WRITE despite the fact that there exists no open file with O_WRONLY access mode. Fix the problem by replacing nfs4_find_state() with a modified version of nfs_find_open_context(). Signed-off-by: -
Trond Myklebust authored
We must not remove the nfs4_state structure from the inode open lists before we are in sequence lock. Signed-off-by: -
David S. Miller authored
At header fixup time, it is not yet legal to ioremap() PCI device registers, yet that is what this quirk code needs to do. Signed-off-by:David S. Miller <davem@davemloft.net>
-
Oleg Nesterov authored
Do not transfer remaining time slice to another cpu on process exit. Signed-off-by:
Oleg Nesterov <oleg@tv-sign.ru> Acked-by:
Ingo Molnar <mingo@elte.hu> Signed-off-by:
-
Linus Torvalds authored
-
Linus Torvalds authored
-
