This is the first patch in a series of eight which address
pagemap_lru_lock contention, and which simplify the VM locking
hierarchy.

Most testing has been done with all eight patches applied, so it would
be best not to cherrypick, please.

The workload which was optimised was: 4x500MHz PIII CPUs, mem=512m, six
disks, six filesystems, six processes each flat-out writing a large
file onto one of the disks.  ie: heavy page replacement load.

The frequency with which pagemap_lru_lock is taken is reduced by 90%.

Lockmeter claims that pagemap_lru_lock contention on the 4-way has been
reduced by 98%.  Total amount of system time lost to lock spinning went
from 2.5% to 0.85%.

Anton ran a similar test on 8-way PPC, the reduction in system time was
around 25%, and the reduction in time spent playing with
pagemap_lru_lock was 80%.

	http://samba.org/~anton/linux/2.5.30/standard/
versus
	http://samba.org/~anton/linux/2.5.30/akpm/

Throughput changes on uniprocessor are modest: a 1% speedup with this
workload due to shortened code paths and improved cache locality.

The patches do two main things:

1: In almost all places where the kernel was doing something with
   lots of pages one-at-a-time, convert the code to do the same thing
   sixteen-pages-at-a-time.  Take the lock once rather than sixteen
   times.  Take the lock for the minimum possible time.

2: Multithread the pagecache reclaim function: don't hold
   pagemap_lru_lock while reclaiming pagecache pages.  That function
   was massively expensive.

One fallout from this work is that we never take any other locks while
holding pagemap_lru_lock.  So this lock conceptually disappears from
the VM locking hierarchy.


So.  This is all basically a code tweak to improve kernel scalability.
It does it by optimising the existing design, rather than by redesign.
There is little conceptual change to how the VM works.

This is as far as I can tweak it.  It seems that the results are now
acceptable on SMP.  But things are still bad on NUMA.  It is expected
that the per-zone LRU and per-zone LRU lock patches will fix NUMA as
well, but that has yet to be tested.


This first patch introduces `struct pagevec', which is the basic unit
of batched work.  It is simply:

struct pagevec {
	unsigned nr;
	struct page *pages[16];
};

pagevecs are used in the following patches to get the VM away from
page-at-a-time operations.

This patch includes all the pagevec library functions which are used in
later patches.

nlmsvc_notify_blocked() is only called via the fl_notify() pointer which
is only called immediately after we already did a locks_delete_block(),
so calling posix_unblock_lock() here is always a NOP.

This patch from Pat Mochel cleans up the hell that was mtrr.c
into something a lot more modular and easy to understand, by
doing the implementation-per-file as has been done to various
other things by Pat and myself over the last months.

It's functionally identical from a kernel internal point of view,
and a userspace point of view, and is basically just a very large
code clean up.

one of the debugging tests triggered a false-positive BUG() when a
detached thread was straced.

it is much cleaner to pass in the address of the user-space VM lock -
this will also enable arbitrary implementations of the stack-unlock, as
the fifth clone() parameter.

It's referenced by mips and mips64 (both far out of date), but never
actually defined anywhere.

into home.transmeta.com:/home/torvalds/v2.5/linux

Update ES1371 to new synchronize_irq() API.

line_length, type and visual moved from display struct to the fb_info's fix
structure during last fbdev updates. Unfortunately generic code was not updated
together, so now every fbdev driver is broken.

Characters 0x80-0x9F from ISO encodings are U+0080-U+009F, so map
them both ways. Otherwise you cannot use chars 0x80-0x9F in filenames
on filesystems using NLS.

into home.transmeta.com:/home/torvalds/v2.5/linux

into home.transmeta.com:/home/torvalds/v2.5/linux

We don't need to reenable interrupts before calling panic.

into mulgrave.(none):/home/jejb/BK/scsi-for-linus-2.5

into mulgrave.(none):/home/jejb/BK/scsi-for-linus-2.5

Moves some functions that are only used by usbfs to be private, and
documents some of the interface issues that need to be cleaned up.

into mulgrave.(none):/home/jejb/BK/scsi-for-linus-2.5

support using work done by Kai Makisara (on st driver, posted
2002/7/29).

Changelog:
    Changes since 3.5.26 (20020708)
        - re-add direct IO using Kai Makisara's work
        - re-tab to 8, start using C99-isms
        - simplify memory management

Like Kai's patch, this one needs kernel/ksyms.c altered
to export get_user_pages(). Kai's worker routines
st_map_user_pages() and st_unmap_user_pages() are duplicated
as is. Hopefully these routines will find a home in
a library soon.

The re-tabbing makes the patches rather large so here
are 2 urls:
This tarball contains sg.h and sg.c 
	http://www.torque.net/sg/p/sg3527.tgz
This gzipped patch is against lk 2.5.31 and touches
kernel/ksyms.c as well
	http://www.torque.net/sg/p/sg_3527_lk2531.diff.gz

Testing is ongoing, everything works apart from "zero
copy" copy. That uses mmap-ed IO on the read side and
direct IO on the write side. Not too many people would
be using that I suspect.

Doug Gilbert

Linus,
Below is a patch to a file that documents the interface
between the scsi mid level and lower level (HBA) drivers.

The main change is documenting "autosense". bios_param()'s
interface has changed.

Doug Gilbert

support for per driver parameters added in lk 2.5.31

1.62 changes:
  - driverfs support for these options (more to come):
    /driverfs/bus/scsi/drivers/scsi_debug/delay [rw]
    /driverfs/bus/scsi/drivers/scsi_debug/num_devs [r]
    /driverfs/bus/scsi/drivers/scsi_debug/opts [rw]
  - start using some C99
  - fdisk requires EINVAL from unsupported ioctls
    (scsi_debug previously used ENOTTY)

1.61 changes:
  - simulate delayed responses, controlled by
    'scsi_debug_delay'
  - support REPORT LUNS
  - support more MODE SENSE pages
  - [following Doug Ledford's suggestion] do autosense
    (i.e. set Scsi_Cmnd::sense_buffer array appropriately
     when a status of CHECK CONDITION is set)
  - minor driverfs support
  - start adding error injection logic, see
    "scsi_debug_every_nth"

Doug Gilbert

The device_root device was only a placeholder device that provided a head
for the global device list, and a parent directory for root bridge devices.

This removes the device and replaces with an explicit global_device_list 
and a separate root directory. We never used any of the other fields in 
device_root, and we special cased it. So, it's better off dead.

This just adds an if switch to irq_balance which the compiler optimises
away anyway.

This patch that adds a prctl so that processes can set their
floating-point exception mode on PPC and on PPC64.  We need this
because the FP exception mode is controlled by bits in the machine
state register, which can only be accessed by the kernel, and because
the exception mode setting interacts with the lazy FPU save/restore
that the kernel does.

The patch allows userspace to issue printk's, via sys_syslog().

The main use of this is within hpa's klibc - initial userspace needs a
way of logging information and this API allows that information to be
captured into the printk ringbuffer.  It ends up in /var/log/messages.

Messages are truncated at 1024 characters by printk's vsprintf().

Requires CAP_SYS_ADMIN.

JFS needs this.

Please apply the four of four tested patches that update
2.5.31 with these I2C changes:
 o Support for SMBus 2.0 PEC Packet Error Checking
 o New adapter-i2c-frodo for SA 1110 board
 o New adapter-i2c-rpx for embeded MPC8XX
 o Replace depreciated cli()&sti() with spin_{un}lock_irq()
 o Updated documentation

Please apply the three of four tested patches that update
2.5.31 with these I2C changes:
 o Support for SMBus 2.0 PEC Packet Error Checking
 o New adapter-i2c-frodo for SA 1110 board
 o New adapter-i2c-rpx for embeded MPC8XX
 o Replace depreciated cli()&sti() with spin_{un}lock_irq()
 o Updated documentation

Please apply the two of four tested patches that update
2.5.31 with these I2C changes:
 o Support for SMBus 2.0 PEC Packet Error Checking
 o New adapter-i2c-frodo for SA 1110 board
 o New adapter-i2c-rpx for embeded MPC8XX
 o Replace depreciated cli()&sti() with spin_{un}lock_irq()
 o Updated documentation