start_thread() will become a bit heavier with the xstate freeing to be
added in, so move it out-of-line in preparation.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This adds some VBR sanity checks in the sh_bios code to ensure that the
BIOS VBR is in range before blindly trapping in to it. This permits
boards with varying boot loader configurations to always leave support
for sh-bios enabled and it will just be disabled at run-time if not
found.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This splits out the unaligned access counters and userspace bits in to
their own generic interface, which will allow them to be wired up on sh64
too.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Now that the sh-sci earlyprintk is taken care of by the sh-sci driver
directly, there's no longer any reason for having a split-out
early_printk framework. sh_bios is the only other thing that uses it, so
we just migrate the leftovers in to there. As it's possible to have
multiple early_param()'s for the same string, there's not much point in
having this split out anymore anyways, particularly since the sh_bios
dependencies are still special-cased within sh-sci itself.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

sh_bios_char_out() is not used by anything in-tree these days, so just
get rid of it.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This was conditionalized on CONFIG_EARLY_PRINTK, which has subsequently
gone away. Now that the serial driver always supports the early console,
make sure we always establish the mapping.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This moves the VBR handling out of the main trap handling code and in to
the sh-bios helper code. A couple of accessors are added in order to
permit other kernel code to get at the VBR value for state save/restore
paths.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

As SH has a very sparse IRQ map by default, all new CPUs and boards
benefit from using sparseirq by default. Despite this, there are still a
few stragglers (mostly due to using a fixed IRQ range for their FPGA
IRQ mappings), and these still need to be converted over one by one. As
these are now in the minority, and we do not want to encourage this sort
of brain-damage in newer board ports, we force sparseirq on.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This gets rid of the arbitrary set of vectors used by the SE7722 FPGA
interrupt controller and switches over to a completely dynamic set.
No assumptions regarding a contiguous range are made, and the platform
resources themselves need to be filled in lazily.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

The LL/SC and IRQ versions were using generic stubs while the GRB version
was just reimplementing what it already had for the standard cmpxchg()
code. As we have optimized cmpxchg() implementations that are decoupled
from the atomic code, simply falling back on the generic wrapper does the
right thing. With this in place the GRB case is unaffected while the
LL/SC case gets to use its optimized cmpxchg().
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

pgtable_cache_init() has been moved out-of-line, so we also need a dummy
definition for it on nommu to fix up the build.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

We previously had 2 quicklists, one for the PGD case and one for PTEs.
Now that the PGD/PMD cases are handled through slab caches due to the
multi-level configurability, only the PTE quicklist remains. As such,
reduce NR_QUICK to its appropriate size and bump down the PTE quicklist
index.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Commit f6151dfe introduces build
breakage, so this patch fixes it together with some printk formatting
cleanup.
Signed-off-by: Daisuke HATAYAMA <d.hatayama@jp.fujitsu.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

This has the adverse effect of converting many 29bit configs to 32bit
mode, while this is a change that needs to be done manually for each
platform. Turn it off by default in order to cut down on spurious bug
reports.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

While the PMB is available on SH-4A parts, SH4AL-DSP parts exclude it
altogether. As such, explicitly disable PMB support for these parts. If
this changes in the future for newer subtypes, this will have to be made
more fine-grained.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

We also switched away from quicklists and instead moved to slab
caches. After benchmarking both implementations the difference is
negligible. The slab caches suit us better though because the size of a
pgd table is just 4 entries when we're using a 3-level page table layout
and quicklists always deal with pages.
Signed-off-by: Matt Fleming <matt@console-pimps.org>

If the page is not mapped into any process's address space then aliases
cannot exist in the cache. So reduce the amount of flushing we perform.
Signed-off-by: Matt Fleming <matt@console-pimps.org>

The previous expressions were wrong which made free_pmd_range() explode
when using anything other than 4KB pages (which is why 8KB and 64KB
pages were disabled with the 3-level page table layout).

The problem was that pmd_offset() was returning an index of non-zero
when it should have been returning 0. This non-zero offset was used to
calculate the address of the pmd table to free in free_pmd_range(),
which ended up trying to free an object that was not aligned on a page
boundary.

Now 3-level page tables should work with 4KB, 8KB and 64KB pages.
Signed-off-by: Matt Fleming <matt@console-pimps.org>

Apply some TLC to the SH64 header files and remove some functions that
are not used anymore.
Signed-off-by: Matt Fleming <matt@console-pimps.org>

As CPUs are migrated over to more fully-featured clock frameworks of
their own and off of the legacy CPG code, they no longer have any real
need for defining the PCLK value. The PCLK define in itself is already
fairly misleading, as many boards get their input clocks from different
sources, making this value fairly arbitrary anyways.

Outside of the legacy CPG clock framework, the only place where this
value is used is for deriving CLOCK_TICK_RATE, which we set back to the
legacy PIT value that it was before the PCLK definitions were added in
the first place.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

* 'sysctl' of git://git.kernel.org/pub/scm/linux/kernel/git/ak/linux-misc-2.6:
  SYSCTL: Add a mutex to the page_alloc zone order sysctl
  SYSCTL: Print binary sysctl warnings (nearly) only once

* 'hwpoison' of git://git.kernel.org/pub/scm/linux/kernel/git/ak/linux-mce-2.6:
  HWPOISON: Add PROC_FS dependency to hwpoison injector v2

* 'release' of git://git.kernel.org/pub/scm/linux/kernel/git/lenb/linux-acpi-2.6: (34 commits)
  classmate-laptop: add support for Classmate PC ACPI devices
  hp-wmi: Fix two memleaks
  acer-wmi, msi-wmi: Remove needless DMI MODULE_ALIAS
  dell-wmi: do not keep driver loaded on unsupported boxes
  wmi: Free the allocated acpi objects through wmi_get_event_data
  drivers/platform/x86/acerhdf.c: check BIOS information whether it begins with string of table
  acerhdf: add new BIOS versions
  acerhdf: limit modalias matching to supported
  toshiba_acpi: convert to seq_file
  asus_acpi: convert to seq_file
  ACPI: do not select ACPI_DOCK from ATA_ACPI
  sony-laptop: enumerate rfkill devices using SN06
  sony-laptop: rfkill support for newer models
  ACPI: fix OSC regression that caused aer and pciehp not to load
  MAINTAINERS: add maintainer for msi-wmi driver
  fujitu-laptop: fix tests of acpi_evaluate_integer() return value
  arch/x86/kernel/cpu/cpufreq/acpi-cpufreq.c: avoid cross-CPU interrupts by using smp_call_function_any()
  ACPI: processor: remove _PDC object list from struct acpi_processor
  ACPI: processor: change acpi_processor_set_pdc() interface
  ACPI: processor: open code acpi_processor_cleanup_pdc
  ...

* 'upstream-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jlbec/ocfs2:
  ocfs2/trivial: Use le16_to_cpu for a disk value in xattr.c
  ocfs2/trivial: Use proper mask for 2 places in hearbeat.c
  Ocfs2: Let ocfs2 support fiemap for symlink and fast symlink.
  Ocfs2: Should ocfs2 support fiemap for S_IFDIR inode?
  ocfs2: Use FIEMAP_EXTENT_SHARED
  fiemap: Add new extent flag FIEMAP_EXTENT_SHARED
  ocfs2: replace u8 by __u8 in ocfs2_fs.h
  ocfs2: explicit declare uninitialized var in user_cluster_connect()
  ocfs2-devel: remove redundant OCFS2_MOUNT_POSIX_ACL check in ocfs2_get_acl_nolock()
  ocfs2: return -EAGAIN instead of EAGAIN in dlm
  ocfs2/cluster: Make fence method configurable - v2
  ocfs2: Set MS_POSIXACL on remount
  ocfs2: Make acl use the default
  ocfs2: Always include ACL support

* 'for-linus' of master.kernel.org:/home/rmk/linux-2.6-arm:
  VIDEO: cyberpro: pci_request_regions needs a persistent name
  ARM: dma-isa: request cascade channel after registering it
  ARM: footbridge: trim down old ISA rtc setup
  ARM: fix PAGE_KERNEL
  ARM: Fix wrong shared bit for CPU write buffer bug test
  ARM: 5857/1: ARM: dmabounce: fix build
  ARM: 5856/1: Fix bug of uart0 platfrom data for nuc900
  ARM: 5855/1: putc support for nuc900
  ARM: 5854/1: fix compiling error for NUC900
  ARM: 5849/1: ARMv7: fix Oprofile events count
  ARM: add missing include to nwflash.c
  ARM: Kill CONFIG_CPU_32
  ARM: Convert VFP/Crunch/XscaleCP thread_release() to exit_thread()
  ARM: 5853/1: ARM: Fix build break on ARM v6 and v7

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/bp/bp:
  edac, pci: remove pesky debug printk
  amd64_edac: restrict PCI config space access
  amd64_edac: fix forcing module load/unload
  amd64_edac: make driver loading more robust
  amd64_edac: fix driver instance freeing
  amd64_edac: fix K8 chip select reporting

* 'sh/for-2.6.33' of git://git.kernel.org/pub/scm/linux/kernel/git/lethal/sh-2.6:
  sh: Ensure all PG_dcache_dirty pages are written back.
  sh: mach-ecovec24: setup.c detailed correction
  serial: sh-sci: Convert tremaining ctrl_xxx I/O routines to __raw_xxx.
  serial: sh-sci: earlyprintk zero uartclk fix
  sh: Only use bl bit toggling for sleeping idle.
  sh: Restore bl bit toggling in idle loop.
  sh: Fix up MAX_DMA_CHANNELS definition when DMA is disabled.
  sh: dmaengine support for SH7785
  sh: dmaengine support for sh7724.

Don't pass a name pointer from the kernel stack, it will not survive
and will result in corrupted /proc/iomem output.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

We can't request the cascade channel before it's been registered, so
move it afterwards.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

This fixes a "start_kernel(): bug: interrupts were enabled early".

rtc_cmos now takes care of initializing the ISA RTC and reading the
current time and date from it; there's no need to repeat that here,
thereby causing interrupts to be enabled too early.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

PAGE_KERNEL should not be executable; any area marked executable can
be prefetched into the instruction cache.  We don't want vmalloc areas
to be read in this way.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Do not spam the logs needlessly with the sole info that
edac_pci_dev_parity_clear is being called.
Signed-off-by: Borislav Petkov <borislav.petkov@amd.com>

Do not access F2x19[0,4] on K8 since they're undefined there.
Signed-off-by: Borislav Petkov <borislav.petkov@amd.com>

Clear the override flag after force-loading the module.
Signed-off-by: Borislav Petkov <borislav.petkov@amd.com>

Currently, the module does not initialize fully when the DIMMs aren't
ECC but remains still loaded. Propagate the error when no instance of
the driver is properly initialized and prevent further loading.

Reorganize and polish error handling in amd64_edac_init() while at it.
Signed-off-by: Borislav Petkov <borislav.petkov@amd.com>

Fix use-after-free errors by pushing all memory-freeing calls to the end
of amd64_remove_one_instance().
Reported-by: Darren Jenkins <darrenrjenkins@gmail.com>
LKML-Reference: <1261370306.11354.52.camel@ICE-BOX>
Signed-off-by: Borislav Petkov <borislav.petkov@amd.com>