- 28 Jun, 2005 39 commits
-
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
Dominik Brodowski <linux@dominikbrodowski.net> Signed-off-by:
Andrew Morton <akpm@osdl.org> Signed-off-by:
Linus Torvalds <torvalds@osdl.org>
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Add pcmcia_device_id table. Signed-off-by:
-
Dominik Brodowski authored
Always rescan the devices upon echo'ing something to available_resources_setup_done. This is needed for proper "coldplug" support. Signed-off-by:
-
Dominik Brodowski authored
From: Adrian Bunk <bunk@stusta.de> This patch contains the following cleanups: - make needlessly global code static - remove the following unneeded EXPORT_SYMBOL's: - ds.c: pcmcia_report_error - ds.c: pcmcia_bus_type Signed-off-by:
Adrian Bunk <bunk@stusta.de> Signed-off-by:
-
Dominik Brodowski authored
Use the firmware method to load replacement CIS tables. It is recommended that the /lib/firmware/cis/ points to /etc/pcmcia/cis or the other way round so that both old-style cardmgr and new-style hotplug/firmware can access these "overwrite" files Signed-off-by:
-
Dominik Brodowski authored
Create PCMCIA entries in modules.alias Signed-off-by:
-
Dominik Brodowski authored
The "func_id"-based matching is very fuzzy and can lead to false positives. Therefore, it should be tried to avoid relying on these matches. Until most/all existing func_id-based matches are replaced by manf_id/card_id/prod_id matches (a patch which will ask to send the appropriate card information to the PCMCIA mailing list will be added once other, more pressing issues are adressed), we need to emulate cardmgr behaviour by allowing func_id matches if no manf_id/card_id/prod_id match occurs. This can only be done in userspace because of modules possibly loaded with long delays. So, add a per-device sysfs file for this purpose. Signed-off-by:
Brice Goglin <Brice.Goglin@ens-lyon.org> Signed-off-by:
-
Dominik Brodowski authored
If a card doesn't provide _any_ information about itself, assume it is a so-called "anonymous" card. pcmciamtd will bind to it if it is configured to do so. Signed-off-by:
-
Dominik Brodowski authored
The one thing which surprises me in this patch that cis->Length needs to be set to count+1. Without it, it doesn't work, but with it, it doesn't make sense to me. Signed-off-by:
-
Dominik Brodowski authored
Export the CIS to userspace using a sysfs binary file in /sys/class/pcmcia_socket/pcmcia_scoket%n/ Signed-off-by:
-
Dominik Brodowski authored
Add another match flag for devices needing a CIS override. The driver will only probe/attach if the CIS has been replaced before. Signed-off-by:
-
Dominik Brodowski authored
Check for invalid crc32 hashes in drivers' id_tables if CONFIG_PCMCIA_DEBUG is set. Signed-off-by:
-
Dominik Brodowski authored
The actual matching of pcmcia drivers and pcmcia devices. The original version of this was written by David Woodhouse. Signed-off-by:
-
Dominik Brodowski authored
Generate hotplug event for PCMCIA sockets being registered. Signed-off-by:
Dominik Brodowski <linux@dominikbrodowski.de> Signed-off-by:
-
Dominik Brodowski authored
Export information to /sbin/hotplug for PCMCIA devices: card_id, manf_id, func_id, bus_id (like pcmcia1.0) and crc32-hashes of the prod_id strings. Why not the prod_id strings themselves? a) They may contain all sorts of strange and difficult to handle characters, like " ". b) It's impossible to pass multiple strings to userspace. Signed-off-by:
-
Ivan Kokshaysky authored
On Mon, Jun 20, 2005 at 07:15:34PM +1000, Grant Coady wrote: > Yenta: CardBus bridge found at 0000:00:0b.0 [1179:0001] > yenta 0000:00:0b.0: Preassigned resource 0 busy, reconfiguring... In -mm1 the cardbus resources might be assigned in pci_assign_unassigned_resources() pass. From your dmesg: PCI: Bus 2, cardbus bridge: 0000:00:0b.0 IO window: 00002000-00002fff IO window: 00003000-00003fff PREFETCH window: 12000000-13ffffff MEM window: 14000000-15ffffff Then yenta_allocate_res() tries to assign these resources again and, naturally, fails. This adds check for already assigned cardbus resources. Signed-off-by:
-
Linus Torvalds authored
git did actually warn me about the fact that I hadn't actually done an "update-cache" on these two files, but the warning was at the bottom of a list of all the files that _did_ change in the merge, so I never noticed. My bad.
-
Alan Cox authored
Old ISA/VESA systems sometimes put tertiary IDE controllers at addresses 0x1e8, 0x168, 0x1e0 or 0x160. Linux thus probes these addresses on x86 systems. Unfortunately some PCI systems now use these addresses for other purposes which leads to users seeing minute plus hangs during boot or even crashes. The following patch (again has been in Fedora for a while) only probes the obscure legacy ISA ports on machinea that are pre-PCI. This seems to keep everyone happy and if there is someone with that utterly weird corner case the ide= command line still provides a get out of jail card. Unsurprisingly we've not found anyone so affected. Signed-off-by:
Alan Cox <alan@redhat.com> Acked-by:
Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl> Signed-off-by:
-
Alan Cox authored
This lets you throw out the iteraid stuff that has ended up back in due to stupid goings on in the IDE world. Its the same heavily tested code shipped in Fedora/Red Hat products but without the other dependancies on the Bartlomiej IDE layer. Pre-requisite: the ide-disk patch I sent to handle pure LBA devices. Obviously you lose things like hot unplug with the Bartlomiej IDE layer at the moment but that won't matter to most users. The patch does the following - Add IT8211/12 to pci_ids.h - Add Makefile/Kconfig entry - Add it8212 driver No core IDE code is touched by this diff Embedded system testing and the ability to force raid mode off by David Howells Made possible by the ite reference code, documentation and also several clarifications and pieces of assistance provided by ITE themselves Signed-off-by:
-
Alan Cox authored
You can't install the base kernel on a Stratus box because of the overuse of __init. Affects both IDE layers identically. It isn't the only misuser of __init so more review of other drivers (or fixing ide_register code to know about hotplug v non-hotplug chipsets) would be good. Original issue found by Stratus and their patch was the inspiration for this trivial one. Signed-off-by:
-
Alan Cox authored
The highpoint driver is unreadable, buggy and crashes on some chipsets. The -ac one is more readable (but not ideal) and doesn't crash all over the place. Been in Fedora for some time. Backported from the Fedora one to the old Bartlomiej IDE core. No other dependencies. Signed-off-by:
-
Alan Cox authored
The ide-generic driver gives you DMA at bios tuned speed so can actually run a lot of unsupported devices quite well. It has a pci table so that it doesn't grab disks owned by other drivers but no way to override this. The patch adds an option ide-generic-all which makes the driver grab everything going that is IDE class. The diff is messy because I put the special case as case 0 to make the if conditional and long term maintenance easier. This has been in Fedora for some time. Signed-off-by:
-
Alan Cox authored
Pretty much theoretical for non MMIO thankfully. We _must_ use OUTBSYNC for commands or they may be posted and thus ruin the 400nS required delay. Signed-off-by:
-
Alan Cox authored
Been in Red Hat products for ages Signed-off-by:
-
Alan Cox authored
Years old bug, has to be fixed for it8212 to work Signed-off-by:
-
- 27 Jun, 2005 1 commit
-
-
Keshavamurthy Anil S authored
Not safe to insert kprobes on IVT code. This patch checks to see if the address on which Kprobes is being inserted is in ivt code and if it is in ivt code then refuse to register kprobe. Signed-off-by:
Anil S Keshavamurthy <anil.s.keshavamurthy@intel.com> Acked-by:
David Mosberger <davidm@napali.hpl.hp.com> Signed-off-by:
-
