They cause quite bad performance regressions on Netburst
This is temporary until we can get new optimized functions
for these CPUs.

This undoes changes that were done in 2.6.15 and in 2.6.16-rc1,
essentially bringing the code back to 2.6.14 level. Only change
is I renamed the X86_FEATURE_K8_C flag to X86_FEATURE_REP_GOOD
and fixed the check for the flag and also fixed some comments.
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This avoids BUG_ONs in the low level allocator when an illegal
GFP mask is added.
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

At resume time, TSC's value or something similar might be changed a lot
against suspend time. This could make system gets a very big lost ticks.
See http://bugzilla.kernel.org/show_bug.cgi?id=5825

Signed-off-by: Shaohua Li<shaohua.li@intel.com>
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

They all have problems with IRQ 0 routing, so just use the APIC on them.

Can be overwritten with "noapicmaintimer"
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Another piece from the no-idle-tick patch.

This can be enabled with the "apicmaintimer" option.

This is mainly useful when the PIT/HPET interrupt is unreliable.
Note there are some systems that are known to stop the APIC
timer in C3. For those it will never work, but this case
should be automatically detected.

It also only works with PM timer right now. When HPET is used
the way the main timer handler computes the delay doesn't work.

It should be a bit more efficient because there is one less
regular interrupt to process on the boot processor.

Requires earlier bugfix from Venkatesh
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Bug in apic timer removal on C3 patch. We should switch to IPI from APIC timer
only when C3 state is valid.
Signed-off-by: Venkatesh Pallipadi <venkatesh.pallipadi@intel.com>
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Avoids some ifdef mess later.
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

A kprobe executes IRET early and that could cause NMI recursion
and stack corruption.
Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Andi Kleen <ak@suse.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Remove private inode tests from security_inode_alloc and security_inode_free,
as we otherwise end up leaking inode security structures for private inodes.
Signed-off-by: Stephen Smalley <sds@tycho.nsa.gov>
Acked-by: James Morris <jmorris@namei.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

ARCH_CAMELOT (excalibur) got removed; remove it from the AT91 defconfigs
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

Prevent SERIAL_8250_RUNTIME_UARTS being larger than SERIAL_8250_NR_UARTS.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

The mount path had incorrectly asked the locking code to wait for recovery
completion, which deadlocks things because recovery waits for mount to
complete first.
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

this changes if() BUG(); constructs to BUG_ON() which is
cleaner, contains unlikely() and can better optimized away.
Signed-off-by: Eric Sesterhenn <snakebyte@gmx.de>
Signed-off-by: Joel Becker <joel.becker@oracle.com>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

configfs always made item and attribute ownership root.root and
permissions based on a umask of 022.  Add ->setattr() to allow
chown(2)/chmod(2), and persist the changes for the lifetime of the
items and attributes.
Signed-off-by: Joel Becker <joel.becker@oracle.com>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

Signed-off-by: Joel Becker <joel.becker@oracle.com>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

Fix a couple of compile warnings found when compiling on a ppc64 build box.
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

this changes if() BUG(); constructs to BUG_ON() which is
cleaner, contains unlikely() and can better optimized away.
Signed-off-by: Eric Sesterhenn <snakebyte@gmx.de>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

fs/ocfs2/dlm/dlmrecovery.c does now use msleep(), and does therefore
need to #include <linux/delay.h> for getting the prototype of this
function.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

Semaphore to mutex conversion.

The conversion was generated via scripts, and the result was validated
automatically via a script as well.
Signed-off-by: Arjan van de Ven <arjan@infradead.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

* fix a hang which can occur during shutdown migration
* do not allow nodes to join during recovery
* when restarting lock mastery, do not ignore nodes which come up
* more than one node could become recovery master, fix this
* sleep to allow some time for heartbeat state to catch up to network
* extra debug info for bad recovery state problems
* make DLM_RECO_NODE_DATA_DONE a valid state for non-master recovery nodes
* prune all locks from dead nodes on $RECOVERY lock resources
* do NOT automatically add new nodes to mle nodemaps until they have properly
  joined the domain
* make sure dlm_pick_recovery_master only exits when all nodes have synced
* properly handle dlmunlock errors in dlm_pick_recovery_master
* do not propagate network errors in dlm_send_begin_reco_message
* dead nodes were not being put in the recovery map sometimes, fix this
* dlmunlock was failing to clear the unlock actions on DLM_DENIED
Signed-off-by: Kurt Hackel <kurt.hackel@oracle.com>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

  Update ocfs2.txt to add "cluster aware lockf" under missing features.
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

ip_io_sem is now ip_io_mutex.
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

 Including <asm/signal.h> results in compilation failure on ia64 due to
 not including <linux/compiler.h>

 Including <linux/signal.h> corrects the problem.

 Please apply.
Signed-off-by: Jeff Mahoney <jeffm@suse.com>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

Functions called by __init funtions mustn't be __exit.

Reported by Jan-Benedict Glaw <jbglaw@lug-owl.de>.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

Signed-off-by: Joel Becker <joel.becker@oracle.com>
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>

Remove the CONFIG_PDC202XX_FORCE=n case.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Acked-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

I just purchased a HighPoint Rocket 1520 SATA controller.  There seems to
be no libata driver (yet), but there is an ide driver, hpt366.  When the
driver gets loaded, it causes a kernel NULL pointer dereference in
pci_bus_clock_list.  It seems to be because the driver is waiting for clock
stabilization in init_hpt37x() which never comes.  The driver just
continues on with the pci drvdata set to NULL, instead of a valid clock
entry.  The following patch prevents the NULL dereference from happening,
but instead exit with an error.
Acked-by: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Cc: Alan Cox <alan@lxorguk.ukuu.org.uk>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Alan Cox <alan@redhat.com>
Acked-by: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Restore a missing space in a log message, which was accidentally
removed by a previous change: 3e087b57Signed-off-by: Jean Delvare <khali@linux-fr.org>
Cc: Tejun Heo <htejun@gmail.com>
Cc: Jens Axboe <axboe@suse.de>
Acked-by: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Since there's no longer any external user, we can make __ide_end_request()
static.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Acked-by: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Signed-off-by: Ingo Molnar <mingo@elte.hu>
Acked-by: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Cc: Alan Cox <alan@lxorguk.ukuu.org.uk>
Cc: Rogio Brito <rbrito@ime.usp.br>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

This patch stops CompactFlash devices being marked as removable.  They are
not removable (as defined by Linux) as the media and device are
inseparable.  When a card is removed, the whole device is removed from the
system and never sits in a media-less state.

This stops some nasty udev device creation/destruction loops.

Further, once this change is made, there is no need for ide to can be
removed from ide_drive_t.
Signed-off-by: Richard Purdie <rpurdie@rpsys.net>
Acked-by: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Cc: Alan Cox <alan@lxorguk.ukuu.org.uk>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

CONFIG_BLK_DEV_IDECS docu mentions everything and the kitchen sink, yet
fails to list the most important/widespread (IMHO) device: Compact Flash
PCMCIA adapters.

This incomplete description recently caused me to deselect the ide_cs
module, causing great pain soon thereafter when I realized why I had
actually enabled it some years ago.

Updates:
- make sure to mention Compact Flash adapters
- fix some random typos in ide Kconfig
Signed-off-by: Andreas Mohr <andi@lisas.de>
Acked-by: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>