drivers/net/phy/phy.c is broken on s390; it uses enable_irq() and friends
and these do not exist on s390.  Marked as broken for now.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

driver is non-modular
Signed-off-by: Al Viro <viro@parcelfarce.linux.theplanet.co.uk>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Add support for the netpoll api for use by netconsole, kgdb, etc.
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

mv643xx_eth_get_config_reg() was reading the wrong register.
mv643xx_eth_set_config_reg() was or'ing instead of setting the
register.  These functions are trivial and both are called only from
mv643xx_eth_set_rx_mode() when changing to/from promiscuous mode.
Remove both functions and do the operations directly in
mv643xx_eth_set_rx_mode().

Also, maintain promiscuous mode setting across port resets.
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

The mv643xx chips support per port bandwith limits.  This patch
disables the bandwidth limits by clearing the MTU register.
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

This patch corrects the accounting of outstanding tx skbs.  It fixes
a bug that causes "Error on Queue Full" messages seen since scatter-gather
was enabled by using the hardware tcp/udp checksum generator.
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

This patch fixes an skb memory leak under heavy receive load
(whenever the more packets have been received than the NAPI budget
allows to be processed).
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

The sis191 is the gigabit brother of the sis190. SiS's driver suggests
that the register set is backward compatible: this should hopefully
give a basic driver.

The device should allow the usual features from a modern ethernet
adapter (802.1q, SG, Jumbo frames, TSO, checksum offload). So far
the relevant register layout is not documented. SiS's driver does
not provide these features either (at least not for Linux).
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Don't ask.
The patch is based on SiS's GPLed driver.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

This patch does three things:
- widen the access to the StationControl register (note the SIS_W16
  versus SIS_W32 change);
- default to 10Mbps half duplex when the LPA can not be evaluated
  (reg31->ctl is identical for both). It can be argued that it makes
  sense as the lowest common denominator when everything else failed.
  Btw it works better than the current code. :o)
- remove some enums: they do not document anymore.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Extracted from SiS's GPLed driver. From the few pdf available at SiS's,
it seems that the 965 and the 966 south bridge include this interface
whereas the 965L (and anything below) does not. It is expected to be a
sis191 related feature and should not hurt the existing sis190 driver.
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

link changes reporting does not work when the driver masks its irq event
Signed-off-by: Arnaud Patard <apatard@mandriva.com>
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

When building with  CONFIG_PHYLIB=y on Itanium, I see:
 `mdio_bus_exit' referenced in section `.init.text' of
drivers/built-in.o: defined in discarded section `.exit.text' of
drivers/built-in.o

I believe that mdio_bus_exit should not be declared __exit, because it is
referencesd from __init sections in, say, phy_init().
Signed-off-by: Peter Chubb <peterc@gelato.unsw.edu.au>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

- make two needlessly global functions static

- kill an ancient version variable
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Cc: Jeff Garzik <jgarzik@pobox.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

added missing include of dma-mapping.h
Signed-off-by: Al Viro <viro@parcelfarce.linux.theplanet.co.uk>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Signed-off-by: Al Viro <viro@parcelfarce.linux.theplanet.co.uk>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

added missing include of dma-mapping.h, removed bogus ptrace.h (what the
hell was it doing there, in the first place?)
Signed-off-by: Al Viro <viro@parcelfarce.linux.theplanet.co.uk>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Signed-off-by: Al Viro <viro@parcelfarce.linux.theplanet.co.uk>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Signed-off-by: Al Viro <viro@parcelfarce.linux.theplanet.co.uk>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

NULL noise removal, __iomem annotations, use of if_mii() instead of
open-coding it.
Signed-off-by: Al Viro <viro@parcelfarce.linux.theplanet.co.uk>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

Automated merge from

	master.kernel.org:/pub/scm/linux/kernel/git/wim/linux-2.6-watchdog

failed due to duplicate different changes to Kconfig file. Manually fixed
up. Hopefully.

Fix reboot with a disconnected 3270 console.
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

On s390 the lock value used for spinlocks consists of the lower 32 bits of the
PSW that holds the lock.  If this address happens to be on a four gigabyte
boundary the lock is left unlocked.  This allows other cpus to grab the same
lock and enter a lock protected code path concurrently.  In theory this can
happen if the vmalloc area for the code of a module crosses a 4 GB boundary.
Signed-off-by: Heiko Carstens <heiko.carstens@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Use TIF bit to tell if a process is running in 31 bit mode instead of checking
the addressing mode bits of the PSW.
Signed-off-by: Heiko Carstens <heiko.carstens@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

crypto device driver update:

 - Suppress syslog messages for some return codes.

 - Fix incorrect bounds checking in /proc interface.

 - Remove hotplug calls.

 - Remove linux version checks.

 - Remove device workqueue on module unload.
Signed-off-by: Eric Rossman <edrossma@us.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

There is a race in pfault_interrupt.  That function gets called two times for
each pfault notification.  Once with a subcode of 0 to indicate that a real
page is not available and once with a subcode of 0x80 to indicate that the
page is present again.

Since the two external interrupts can be delivered on two different cpus the
order in which the two calls are made is unpredictable.  It is possible that
the subcode 0x80 interrupt is completed before the subcode 0x00 interrupt has
done the wake_up() call.

To avoid calling wake_up() on an already removed task structure proper task
structure reference counting is needed.  Increase the reference counter in the
subcode 0x00 interrupt before setting pfault_wait to zero and return the
reference after the wake_up call.
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Common i/o layer changes:

- Collect the irb at the correct subchannel when waiting for the clear
  interrupt during subchannel cleaning befor reIPL - don't stop at the first
  interrupt that comes in.

- Change "extern __inline__" to "static inline".

- Remove unneeded qdio includes.
Signed-off-by: Cornelia Huck <cohuck@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Add support for diag 250 access to dasd devices for 64 bit kernels.  In
addition fix detach/attach for diag disks.  The VM control block needs to get
recreated by a call to mdsk_init_io.
Signed-off-by: Horst Hummel <horst.hummel@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

Reintroduce a read-only copy of the devmap features in the device struct.
This is necessary to solve a deadlock on the dasd_devmap_lock which is
acquired by dasd_get_features called from the dasd tasklet.  The current
implementation of devmap doesn't allow to call any devmap function from
interrupt or softirq context.
Signed-off-by: Horst Hummel <horst.hummel@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

debug feature changes/bug fixes:

- Use get_clock() function instead of private inline assembly.

- Use 'struct timeval' instead of 'struct timespec' for call to
  tod_to_timeval().  Now the microsecond part of the timestamp is correct
  again.

- Fix a locking problem: when creating a snapshot of the current content
  of the debug areas, lock the entire debug_info object.
Signed-off-by: Michael Holzheu <holzheu@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

The new machine check handler still has a few bugs.

1) The system entry time has to be stored in the machine check handler,

2) the machine check return psw may not be stored at the usual place
   because it might overwrite the return psw of the interrupted context,

3) the return address for the call to s390_handle_mcck in the i/o interrupt
   handler is not correct,

4) the system call cleanup has to take the different save area of the
   machine check handler into account,

5) the machine check handler may not call UPDATE_VTIME before
   CREATE_STACK_FRAME, and

6) the io leave path needs a critical section cleanup to make sure that the
   TIF_MCCK_PENDING bit is really checked before switching back to user space.
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>