- 12 Apr, 2006 13 commits
-
-
Andreas Schwab authored
The ixgb driver is using pci_alloc_consistent, thus is should also use pci_set_consistent_dma_mask. This allows the driver to work on SGI systems. In case of an error during probing it should also disable the device again. Signed-off-by:
Andreas Schwab <schwab@suse.de> Signed-off-by:
Jeff Garzik <jeff@garzik.org>
-
Stephen Hemminger authored
Sky2 driver will oops referencing bad memory if used on a dual port card. The problem is accessing past end of MIB counter space. Applies for both 2.6.17 and 2.6.16 (with fuzz) Signed-off-by:
Stephen Hemminger <shemminger@osdl.org> Signed-off-by:
-
Dale Farnsworth authored
After resetting the hardware on a tx_timeout, call netif_wake_queue() only if we have free tx descriptors. Also, attempt to recover if mv643xx_eth_start_xmit() is called when there are fewer free tx descriptors than expected. The BUG_ON() call we are replacing was hit on a tx_timeout that called netif_wake_queue(), indirectly via netif_device_attach(), even though we did not have enough free tx descriptors. Signed-off-by:
Dale Farnsworth <dale@farnsworth.org> Signed-off-by:
-
Brent Cook authored
Fix the tx interrupt handler to free completed tx descriptors even when NAPI is enabled. Otherwise, the tx queue would fill up resulting in poor performance and "NETDEV WATCHDOG: <iface>: transmit timed out" messages. Signed-off-by:
Brent Cook <bcook@bpointsys.com> Signed-off-by:
-
Randy Dunlap authored
If CONFIG_HOTPLUG=n, gcc doesn't like some __initdata to be const (rodata) and other __initdata not const, so make the non-const __initdata const. gcc errors: drivers/net/bnx2.c:66: error: version causes a section type conflict drivers/net/starfire.c:338: error: version causes a section type conflict drivers/net/typhoon.c:137: error: version causes a section type conflict drivers/net/natsemi.c:241: error: version causes a section type conflict Signed-off-by:
Randy Dunlap <rdunlap@xenotime.net> Signed-off-by:
Andrew Morton <akpm@osdl.org> Signed-off-by:
-
Adrian Bunk authored
Remove drivers/net/hydra.h which is both unused and covered by a 4 clause BSD licence (not by the UCB). Signed-off-by:
Adrian Bunk <bunk@stusta.de> Acked-By:
Geert Uytterhoeven <geert@linux-m68k.org> Signed-off-by:
-
Adrian Bunk authored
Signed-off-by:
Roger Luethi <rl@hellgate.ch> Signed-off-by:
-
Jeff Garzik authored
-
Gary Zambrano authored
Signed-off-by: -
Gary Zambrano authored
Disable default tx pause frame support. The b44 controller has a bug that generates excessive tx pause frames. Signed-off-by:
Gary Zambrano <zambrano@broadcom.com> Signed-off-by:
-
Roger Luethi authored
Patch suggested by Yang Wu (pin xue <pinxue@gmail.com>). Signed-off-by:
-
Komuro authored
Signed-off-by: komurojun-mbn@nifty.com Signed-off-by: -
Stephen Hemminger authored
This patch fixes the problem of some Dlink cards picking the wrong driver. It looks like these cards use Yukon 1 chipset, not Yukon 2. Signed-off-by:
-
- 11 Apr, 2006 27 commits
-
-
Oleg Nesterov authored
Commit e56d0903 [PATCH] RCU signal handling made this BUG_ON() unsafe. This code runs under ->siglock, while switch_exec_pids() takes tasklist_lock. Signed-off-by:
Oleg Nesterov <oleg@tv-sign.ru> Signed-off-by:
Linus Torvalds <torvalds@osdl.org>
-
git://git.kernel.org/pub/scm/linux/kernel/git/sam/kbuildLinus Torvalds authored
* git://git.kernel.org/pub/scm/linux/kernel/git/sam/kbuild: kconfig: fix typo in change count initialization kconfig: recenter menuconfig kconfig: revert conf behaviour change kconfig: fix default value for choice input kbuild: fix NULL dereference in scripts/mod/modpost.c kbuild: fix mode of checkstack.pl and other files. kbuild: rebuild initramfs if content of initramfs changes kbuild: properly pass options to hostcc when doing make O=.. kbuild: modules_install for external modules must not remove existing modules kbuild: fix make dir/ ver_linux: don't print reiser4progs version if none found kbuild: mips: fix sed regexp to generate asm-offset.h kbuild: fix building single targets with make O=.. single-target kbuild: use relative path to -I kbuild: fix unneeded rebuilds in drivers/net/chelsio after moving source tree kbuild: fix unneeded rebuilds in drivers/media/video after moving source tree kbuild: fix garbled text in modules.txt
-
git://git.kernel.org/pub/scm/linux/kernel/git/aegl/linux-2.6Linus Torvalds authored
* 'release' of git://git.kernel.org/pub/scm/linux/kernel/git/aegl/linux-2.6: [IA64] Prefetch mmap_sem in ia64_do_page_fault() [IA64] Failure to resume after INIT in user space [IA64] Pass more data to the MCA/INIT notify_die hooks [IA64] always map VGA framebuffer UC, even if it supports WB [IA64] fix bug in ia64 __mutex_fastpath_trylock [IA64] for_each_possible_cpu: ia64 [IA64] update HP CSR space discovery via ACPI [IA64] Wire up new syscalls {set,get}_robust_list [IA64] 'msg' may be used uninitialized in xpc_initiate_allocate() [IA64] Wire up new syscall sync_file_range()
-
mao, bibo authored
In vsyscall function do_vgettimeofday(), some functions are declared as inlined, which is a hint for gcc to compile the function inlined but it not forced. Sometimes compiler does not compile the function as inlined, so here inline is replaced by __always_inline prefix. It does not happen in gcc compiler actually, but it possibly happens. Signed-off-by:
bibo mao <bibo.mao@intel.com> Signed-off-by:
-
Andi Kleen authored
Surprising that it still worked at all with this - yes it was tested. Signed-off-by:
Andi Kleen <ak@suse.de> Signed-off-by:
-
Andi Kleen authored
Nobody should pass NULL here. Could in theory make it a BUG, but the NULL pointer oops will do as well. Signed-off-by:
-
Andi Kleen authored
It's not actually needed and would break non power of two number of cores. Follows similar earlier x86-64 patch. Signed-off-by:
-
Siddha, Suresh B authored
Commit c818a181 didn't do the expected thing. This fix will remove the additional sync(cpuid) before RDTSC on Intel platforms.. Signed-off-by:
Suresh Siddha <suresh.b.siddha@intel.com> Signed-off-by:
-
Andi Kleen authored
As pointed out by Linus it is useless now because entry.S should handle it correctly in all cases. Signed-off-by:
-
Andi Kleen authored
When nolapic was passed or the local APIC was disabled for another reason ACPI would still parse the IO-APICs until these were explicitely disabled with noapic. Usually this resulted in a non booting configuration unless "nolapic noapic" was used. I also disabled the local APIC parsing in this case, although that's only cosmetic (suppresses a few printks) This hopefully makes nolapic work in all cases. Cc: Len Brown <len.brown@intel.com> Signed-off-by:
-
git://brick.kernel.dk/data/git/linux-2.6-blockLinus Torvalds authored
* 'splice' of git://brick.kernel.dk/data/git/linux-2.6-block: [PATCH] vfs: add splice_write and splice_read to documentation [PATCH] Remove sys_ prefix of new syscalls from __NR_sys_* [PATCH] splice: warning fix [PATCH] another round of fs/pipe.c cleanups [PATCH] splice: comment styles [PATCH] splice: add Ingo as addition copyright holder [PATCH] splice: unlikely() optimizations [PATCH] splice: speedups and optimizations [PATCH] pipe.c/fifo.c code cleanups [PATCH] get rid of the PIPE_*() macros [PATCH] splice: speedup __generic_file_splice_read [PATCH] splice: add direct fd <-> fd splicing support [PATCH] splice: add optional input and output offsets [PATCH] introduce a "kernel-internal pipe object" abstraction [PATCH] splice: be smarter about calling do_page_cache_readahead() [PATCH] splice: optimize the splice buffer mapping [PATCH] splice: cleanup __generic_file_splice_read() [PATCH] splice: only call wake_up_interruptible() when we really have to [PATCH] splice: potential !page dereference [PATCH] splice: mark the io page as accessed
-
Matthias Urlichs authored
Since the arrays are declared as in_urbs[N_IN_URB] and out_urbs[N_OUT_URB], both for loops go one over the end of the array. This fixes coverity id #555. Signed-off-by:
Eric Sesterhenn <snakebyte@gmx.de> Signed-Off-By:
Matthias Urlichs <smurf@smurf.noris.de> Signed-Off-By:
-
Antonino A. Daplas authored
Since the visual STATIC_PSEUDOCOLOR has a read-only colormap, use logos with 16 colors only since these logos use the console palette. This has a higher likelihood that the logo will display correctly. Signed-of-by:
Antonino Daplas <adaplas@pol.net> Signed-off-by:
-
Antonino A. Daplas authored
Bugzilla Bug 6299: A pixel size of 8 bits produces wrong logo colors in x86_64. The driver has 2 methods for setting the color map, using the protected mode interface provided by the video BIOS and directly writing to the VGA registers. The former is not supported in x86_64 and the latter is enabled only in i386. Fix by enabling the latter method in x86_64 only if supported by the BIOS. If both methods are unsupported, change the visual of vesafb to STATIC_PSEUDOCOLOR. Signed-off-by:
-
Andrew Morton authored
sparc32 lacks vga.h, so lots of fbdev drivers won't compile. There are no sparc32 systems with PCI slots, so it's a bit moot. The patch gives sparc32 a copy of the sparc64 vga.h. It fixes sparc32 allmodconfig without mucking up fbdev Kconfig and gives us wider compile coverage. Cc: "Antonino A. Daplas" <adaplas@pol.net> Acked-by:
"David S. Miller" <davem@davemloft.net> Signed-off-by:
-
Andrew Morton authored
Heaps of build errors - disable it to keep sparc32 allmodconfig happy. Signed-off-by:
-
Adrian Bunk authored
Fix an obvious of-by-one error spotted by the Coverity checker. Signed-off-by:
-
NeilBrown authored
Keep unused openowners around for at least one lease period, to avoid the need for as many open confirmations and to allow handing out more delegations. Signed-off-by:
J. Bruce Fields <bfields@citi.umich.edu> Signed-off-by:
Neil Brown <neilb@suse.de> Signed-off-by:
-
NeilBrown authored
It's very easy for the server to DOS itself by just giving out too many delegations. For now we just solve the problem with a dumb hard limit. Eventually we'll want a smarter policy. Signed-off-by:
-
NeilBrown authored
We should be shutting down rpciod for the callback channel when we shut down the server. Also note that we do rpciod_up() and create the callback client *before* setting cb_set--the cb_set only determines whether the initial null was succesful. So cb_set is not a reliable determiner of whether we need to clean up, only cb_client is. Signed-off-by:
-
NeilBrown authored
Some obvious cleanup. Signed-off-by:
-
NeilBrown authored
We need to make sure the laundromat work doesn't reschedule itself just when we try to cancel it. Also, we shouldn't be waiting for it to finish running while holding the state lock, as that's a potential deadlock. Signed-off-by:
-
J. Bruce Fields authored
Every caller of svc_take_page ignores its return value and assumes it succeeded. So just WARN() instead of returning an ignored error. This would have saved some time debugging a recent nfsd4 problem. If there are still failure cases here, then the result is probably that we overwrite an earlier part of the reply while xdr-encoding. While the corrupted reply is a nasty bug, it would be worse to panic here and create the possibility of a remote DOS; hence WARN() instead of BUG(). Signed-off-by:
-
NeilBrown authored
We're using svc_take_page here to get another page for the tail in case one wasn't already allocated. But there isn't always guaranteed to be another page available. Also fix a typo that made us check the tail buffer for space when we meant to be checking the head buffer. Signed-off-by:
-
NeilBrown authored
Fix corruption on readdir encoding with 64k pages. Signed-off-by:
-
NeilBrown authored
In v4 we grab an extra page just for the padding of returned data. The formula that the rpc server uses to allocate pages for the response doesn't take into account this extra page. Instead of adjusting those formulae, we adopt the same solution as v2 and v3, and put the "tail" data in the same page as the "head" data. Signed-off-by:
-
NeilBrown authored
Since nfsd_setuser() is already called from any operation that uses the current filehandle (because it's called from fh_verify), there's no reason to call it from putrootfh. Signed-off-by:
Andy Adamson <andros@citi.umich.edu> Signed-off-by:
-
