r8169: move setting OCP base to generic init code

Move setting the ocp_base to rtl_init_one(). Where supported the value
is always the same, and if not supported it doesn't hurt.
Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/realtek/r8169_main.c

@@ -75,6 +75,8 @@
 #define R8169_TX_RING_BYTES	(NUM_TX_DESC * sizeof(struct TxDesc))
 #define R8169_RX_RING_BYTES	(NUM_RX_DESC * sizeof(struct RxDesc))
 
+#define OCP_STD_PHY_BASE	0xa400
+
 #define RTL_CFG_NO_GBIT	1
 
 /* write/read MMIO register */
@@ -847,8 +849,6 @@ static void r8168_mac_ocp_modify(struct rtl8169_private *tp, u32 reg, u16 mask,
 	r8168_mac_ocp_write(tp, reg, (data & ~mask) | set);
 }
 
-#define OCP_STD_PHY_BASE	0xa400
-
 static void r8168g_mdio_write(struct rtl8169_private *tp, int reg, int value)
 {
 	if (reg == 0x1f) {
@@ -5189,8 +5189,6 @@ static int r8169_mdio_register(struct rtl8169_private *tp)
 
 static void rtl_hw_init_8168g(struct rtl8169_private *tp)
 {
-	tp->ocp_base = OCP_STD_PHY_BASE;
-
 	RTL_W32(tp, MISC, RTL_R32(tp, MISC) | RXDV_GATED_EN);
 
 	if (!rtl_udelay_loop_wait_high(tp, &rtl_txcfg_empty_cond, 100, 42))
@@ -5215,8 +5213,6 @@ static void rtl_hw_init_8168g(struct rtl8169_private *tp)
 
 static void rtl_hw_init_8125(struct rtl8169_private *tp)
 {
-	tp->ocp_base = OCP_STD_PHY_BASE;
-
 	RTL_W32(tp, MISC, RTL_R32(tp, MISC) | RXDV_GATED_EN);
 
 	if (!rtl_udelay_loop_wait_high(tp, &rtl_rxtx_empty_cond, 100, 42))
@@ -5353,6 +5349,7 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
 	tp->msg_enable = netif_msg_init(debug.msg_enable, R8169_MSG_DEFAULT);
 	tp->supports_gmii = ent->driver_data == RTL_CFG_NO_GBIT ? 0 : 1;
 	tp->eee_adv = -1;
+	tp->ocp_base = OCP_STD_PHY_BASE;
 
 	/* Get the *optional* external "ether_clk" used on some boards */
 	rc = rtl_get_ether_clk(tp);