Merge branch 'lan78xx-Read-configuration-from-Device-Tree'

Phil Elwell says:

====================
lan78xx: Read configuration from Device Tree

The Microchip LAN78XX family of devices are Ethernet controllers with
a USB interface. Despite being discoverable devices it can be useful to
be able to configure them from Device Tree, particularly in low-cost
applications without an EEPROM or programmed OTP.

This patch set adds support for reading the MAC address and LED modes from
Device Tree.

v4:
- Rename nodes in bindings doc.

v3:
- Move LED setting into PHY driver.

v2:
- Use eth_platform_get_mac_address.
- Support up to 4 LEDs, and move LED mode constants into dt-bindings header.
- Improve bindings document.
- Remove EEE support.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>

Documentation/devicetree/bindings/net/microchip,lan78xx.txt

+Microchip LAN78xx Gigabit Ethernet controller
+
+The LAN78XX devices are usually configured by programming their OTP or with
+an external EEPROM, but some platforms (e.g. Raspberry Pi 3 B+) have neither.
+The Device Tree properties, if present, override the OTP and EEPROM.
+
+Required properties:
+- compatible: Should be one of "usb424,7800", "usb424,7801" or "usb424,7850".
+
+Optional properties:
+- local-mac-address:   see ethernet.txt
+- mac-address:         see ethernet.txt
+
+Optional properties of the embedded PHY:
+- microchip,led-modes: a 0..4 element vector, with each element configuring
+  the operating mode of an LED. Omitted LEDs are turned off. Allowed values
+  are defined in "include/dt-bindings/net/microchip-lan78xx.h".
+
+Example:
+
+/* Based on the configuration for a Raspberry Pi 3 B+ */
+&usb {
+	usb-port@1 {
+		compatible = "usb424,2514";
+		reg = <1>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		usb-port@1 {
+			compatible = "usb424,2514";
+			reg = <1>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			ethernet: ethernet@1 {
+				compatible = "usb424,7800";
+				reg = <1>;
+				local-mac-address = [ 00 11 22 33 44 55 ];
+
+				mdio {
+					#address-cells = <0x1>;
+					#size-cells = <0x0>;
+					eth_phy: ethernet-phy@1 {
+						reg = <1>;
+						microchip,led-modes = <
+							LAN78XX_LINK_1000_ACTIVITY
+							LAN78XX_LINK_10_100_ACTIVITY
+						>;
+					};
+				};
+			};
+		};
+	};
+};

MAINTAINERS

@@ -14571,7 +14571,9 @@ M:	Woojung Huh <woojung.huh@microchip.com>
 M:	Microchip Linux Driver Support <UNGLinuxDriver@microchip.com>
 L:	netdev@vger.kernel.org
 S:	Maintained
+F:	Documentation/devicetree/bindings/net/microchip,lan78xx.txt
 F:	drivers/net/usb/lan78xx.*
+F:	include/dt-bindings/net/microchip-lan78xx.h
 
 USB MASS STORAGE DRIVER
 M:	Alan Stern <stern@rowland.harvard.edu>

drivers/net/phy/microchip.c

@@ -20,6 +20,8 @@
 #include <linux/ethtool.h>
 #include <linux/phy.h>
 #include <linux/microchipphy.h>
+#include <linux/of.h>
+#include <dt-bindings/net/microchip-lan78xx.h>
 
 #define DRIVER_AUTHOR	"WOOJUNG HUH <woojung.huh@microchip.com>"
 #define DRIVER_DESC	"Microchip LAN88XX PHY driver"
@@ -70,6 +72,8 @@ static int lan88xx_probe(struct phy_device *phydev)
 {
 	struct device *dev = &phydev->mdio.dev;
 	struct lan88xx_priv *priv;
+	u32 led_modes[4];
+	int len;
 
 	priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
 	if (!priv)
@@ -77,6 +81,27 @@ static int lan88xx_probe(struct phy_device *phydev)
 
 	priv->wolopts = 0;
 
+	len = of_property_read_variable_u32_array(dev->of_node,
+						  "microchip,led-modes",
+						  led_modes,
+						  0,
+						  ARRAY_SIZE(led_modes));
+	if (len >= 0) {
+		u32 reg = 0;
+		int i;
+
+		for (i = 0; i < len; i++) {
+			if (led_modes[i] > 15)
+				return -EINVAL;
+			reg |= led_modes[i] << (i * 4);
+		}
+		for (; i < ARRAY_SIZE(led_modes); i++)
+			reg |= LAN78XX_FORCE_LED_OFF << (i * 4);
+		(void)phy_write(phydev, LAN78XX_PHY_LED_MODE_SELECT, reg);
+	} else if (len == -EOVERFLOW) {
+		return -EINVAL;
+	}
+
 	/* these values can be used to identify internal PHY */
 	priv->chip_id = phy_read_mmd(phydev, 3, LAN88XX_MMD3_CHIP_ID);
 	priv->chip_rev = phy_read_mmd(phydev, 3, LAN88XX_MMD3_CHIP_REV);

drivers/net/usb/lan78xx.c

@@ -37,6 +37,8 @@
 #include <linux/irqchip/chained_irq.h>
 #include <linux/microchipphy.h>
 #include <linux/phy.h>
+#include <linux/of_mdio.h>
+#include <linux/of_net.h>
 #include "lan78xx.h"
 
 #define DRIVER_AUTHOR	"WOOJUNG HUH <woojung.huh@microchip.com>"
@@ -1652,12 +1654,15 @@ static void lan78xx_init_mac_address(struct lan78xx_net *dev)
 	addr[5] = (addr_hi >> 8) & 0xFF;
 
 	if (!is_valid_ether_addr(addr)) {
-		/* reading mac address from EEPROM or OTP */
-		if ((lan78xx_read_eeprom(dev, EEPROM_MAC_OFFSET, ETH_ALEN,
-					 addr) == 0) ||
-		    (lan78xx_read_otp(dev, EEPROM_MAC_OFFSET, ETH_ALEN,
-				      addr) == 0)) {
-			if (is_valid_ether_addr(addr)) {
+		if (!eth_platform_get_mac_address(&dev->udev->dev, addr)) {
+			/* valid address present in Device Tree */
+			netif_dbg(dev, ifup, dev->net,
+				  "MAC address read from Device Tree");
+		} else if (((lan78xx_read_eeprom(dev, EEPROM_MAC_OFFSET,
+						 ETH_ALEN, addr) == 0) ||
+			    (lan78xx_read_otp(dev, EEPROM_MAC_OFFSET,
+					      ETH_ALEN, addr) == 0)) &&
+			   is_valid_ether_addr(addr)) {
 			/* eeprom values are valid so use them */
 			netif_dbg(dev, ifup, dev->net,
 				  "MAC address read from EEPROM");
@@ -1674,12 +1679,6 @@ static void lan78xx_init_mac_address(struct lan78xx_net *dev)
 
 		ret = lan78xx_write_reg(dev, RX_ADDRL, addr_lo);
 		ret = lan78xx_write_reg(dev, RX_ADDRH, addr_hi);
-		} else {
-			/* generate random MAC */
-			random_ether_addr(addr);
-			netif_dbg(dev, ifup, dev->net,
-				  "MAC address set to random addr");
-		}
 	}
 
 	ret = lan78xx_write_reg(dev, MAF_LO(0), addr_lo);
@@ -1762,6 +1761,7 @@ static int lan78xx_mdiobus_write(struct mii_bus *bus, int phy_id, int idx,
 
 static int lan78xx_mdio_init(struct lan78xx_net *dev)
 {
+	struct device_node *node;
 	int ret;
 
 	dev->mdiobus = mdiobus_alloc();
@@ -1790,7 +1790,13 @@ static int lan78xx_mdio_init(struct lan78xx_net *dev)
 		break;
 	}
 
+	node = of_get_child_by_name(dev->udev->dev.of_node, "mdio");
+	if (node) {
+		ret = of_mdiobus_register(dev->mdiobus, node);
+		of_node_put(node);
+	} else {
 		ret = mdiobus_register(dev->mdiobus);
+	}
 	if (ret) {
 		netdev_err(dev->net, "can't register MDIO bus\n");
 		goto exit1;
@@ -2079,6 +2085,28 @@ static int lan78xx_phy_init(struct lan78xx_net *dev)
 	mii_adv = (u32)mii_advertise_flowctrl(dev->fc_request_control);
 	phydev->advertising |= mii_adv_to_ethtool_adv_t(mii_adv);
 
+	if (phydev->mdio.dev.of_node) {
+		u32 reg;
+		int len;
+
+		len = of_property_count_elems_of_size(phydev->mdio.dev.of_node,
+						      "microchip,led-modes",
+						      sizeof(u32));
+		if (len >= 0) {
+			/* Ensure the appropriate LEDs are enabled */
+			lan78xx_read_reg(dev, HW_CFG, &reg);
+			reg &= ~(HW_CFG_LED0_EN_ |
+				 HW_CFG_LED1_EN_ |
+				 HW_CFG_LED2_EN_ |
+				 HW_CFG_LED3_EN_);
+			reg |= (len > 0) * HW_CFG_LED0_EN_ |
+				(len > 1) * HW_CFG_LED1_EN_ |
+				(len > 2) * HW_CFG_LED2_EN_ |
+				(len > 3) * HW_CFG_LED3_EN_;
+			lan78xx_write_reg(dev, HW_CFG, reg);
+		}
+	}
+
 	genphy_config_aneg(phydev);
 
 	dev->fc_autoneg = phydev->autoneg;

include/dt-bindings/net/microchip-lan78xx.h

+/* SPDX-License-Identifier: GPL-2.0 */
+#ifndef _DT_BINDINGS_MICROCHIP_LAN78XX_H
+#define _DT_BINDINGS_MICROCHIP_LAN78XX_H
+
+/* LED modes for LAN7800/LAN7850 embedded PHY */
+
+#define LAN78XX_LINK_ACTIVITY           0
+#define LAN78XX_LINK_1000_ACTIVITY      1
+#define LAN78XX_LINK_100_ACTIVITY       2
+#define LAN78XX_LINK_10_ACTIVITY        3
+#define LAN78XX_LINK_100_1000_ACTIVITY  4
+#define LAN78XX_LINK_10_1000_ACTIVITY   5
+#define LAN78XX_LINK_10_100_ACTIVITY    6
+#define LAN78XX_DUPLEX_COLLISION        8
+#define LAN78XX_COLLISION               9
+#define LAN78XX_ACTIVITY                10
+#define LAN78XX_AUTONEG_FAULT           12
+#define LAN78XX_FORCE_LED_OFF           14
+#define LAN78XX_FORCE_LED_ON            15
+
+#endif

include/linux/microchipphy.h

@@ -70,4 +70,7 @@
 #define	LAN88XX_MMD3_CHIP_ID			(32877)
 #define	LAN88XX_MMD3_CHIP_REV			(32878)
 
+/* Registers specific to the LAN7800/LAN7850 embedded phy */
+#define LAN78XX_PHY_LED_MODE_SELECT		(0x1D)
+
 #endif /* _MICROCHIPPHY_H */