net: dsa: bcm_sf2: Prevent GPHY shutdown for kexec'd kernels

For a kernel that is being kexec'd we re-enable the integrated GPHY in
order for the subsequent MDIO bus scan to succeed and properly bind to
the bcm7xxx PHY driver. If we did not do that, the GPHY would be shut
down by the time the MDIO driver is probing the bus, and it would fail
to read the correct PHY OUI and therefore bind to an appropriate PHY
driver. Later on, this would cause DSA not to be able to successfully
attach to the PHY, and the interface would not be created at all.
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/dsa/bcm_sf2.c

@@ -30,6 +30,7 @@
 #include <linux/etherdevice.h>
 #include <net/switchdev.h>
 #include <linux/platform_data/b53.h>
+#include <linux/kexec.h>
 
 #include "bcm_sf2.h"
 #include "bcm_sf2_regs.h"
@@ -1133,6 +1134,18 @@ static int bcm_sf2_sw_remove(struct platform_device *pdev)
 	return 0;
 }
 
+static void bcm_sf2_sw_shutdown(struct platform_device *pdev)
+{
+	struct bcm_sf2_priv *priv = platform_get_drvdata(pdev);
+
+	/* For a kernel about to be kexec'd we want to keep the GPHY on for a
+	 * successful MDIO bus scan to occur. If we did turn off the GPHY
+	 * before (e.g: port_disable), this will also power it back on.
+	 */
+	if (priv->hw_params.num_gphy == 1)
+		bcm_sf2_gphy_enable_set(priv->dev->ds, kexec_in_progress);
+}
+
 #ifdef CONFIG_PM_SLEEP
 static int bcm_sf2_suspend(struct device *dev)
 {
@@ -1163,6 +1176,7 @@ MODULE_DEVICE_TABLE(of, bcm_sf2_of_match);
 static struct platform_driver bcm_sf2_driver = {
 	.probe	= bcm_sf2_sw_probe,
 	.remove	= bcm_sf2_sw_remove,
+	.shutdown = bcm_sf2_sw_shutdown,
 	.driver = {
 		.name = "brcm-sf2",
 		.of_match_table = bcm_sf2_of_match,