Commit 26ffaf36 authored by Yaniv Rosner's avatar Yaniv Rosner Committed by David S. Miller

bnx2x: Fix LED blink rate for 578xx

Adjust blink rate on 578xx to fit its clock rate.
Signed-off-by: default avatarYaniv Rosner <yanivr@broadcom.com>
Signed-off-by: default avatarEilon Greenstein <eilong@broadcom.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent b903d324
......@@ -45,6 +45,9 @@
#define MCPR_IMC_COMMAND_READ_OP 1
#define MCPR_IMC_COMMAND_WRITE_OP 2
/* LED Blink rate that will achieve ~15.9Hz */
#define LED_BLINK_RATE_VAL_E3 354
#define LED_BLINK_RATE_VAL_E1X_E2 480
/***********************************************************/
/* Shortcut definitions */
/***********************************************************/
......@@ -5954,8 +5957,12 @@ int bnx2x_set_led(struct link_params *params,
REG_WR(bp, NIG_REG_LED_CONTROL_OVERRIDE_TRAFFIC_P0 + port*4, 0);
/* Set blinking rate to ~15.9Hz */
REG_WR(bp, NIG_REG_LED_CONTROL_BLINK_RATE_P0 + port*4,
LED_BLINK_RATE_VAL);
if (CHIP_IS_E3(bp))
REG_WR(bp, NIG_REG_LED_CONTROL_BLINK_RATE_P0 + port*4,
LED_BLINK_RATE_VAL_E3);
else
REG_WR(bp, NIG_REG_LED_CONTROL_BLINK_RATE_P0 + port*4,
LED_BLINK_RATE_VAL_E1X_E2);
REG_WR(bp, NIG_REG_LED_CONTROL_BLINK_RATE_ENA_P0 +
port*4, 1);
tmp = EMAC_RD(bp, EMAC_REG_EMAC_LED);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment