bnx2x: utilize FW 7.8.19

    This new firmware fixes following bugs:
     1. HW attention appears and traffic stops when iSCSI firmware tries to
        retransmit iSCSI login command when the iSCSI login is carrying data
        not aligned to 4-bytes.
     2. FCoE traffic fails to run when running in switch-independent multi-function
        mode and there's more than one interface supporting FCoE on a given port.
     3. While two ports are running FCoE with at least one of them has a function
        number (>1) on the same engine in a 4-port device a zeroed CQE is given,
        causing FCoE traffic to stop.
Signed-off-by: Dmitry Kravkov <dmitry@broadcom.com>
Signed-off-by: Yuval Mintz <yuvalmin@broadcom.com>
Signed-off-by: Ariel Elior <ariele@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/bnx2x/bnx2x.h

@@ -26,8 +26,8 @@
  * (you will need to reboot afterwards) */
 /* #define BNX2X_STOP_ON_ERROR */
 
-#define DRV_MODULE_VERSION      "1.78.17-0"
-#define DRV_MODULE_RELDATE      "2013/04/11"
+#define DRV_MODULE_VERSION      "1.78.19-0"
+#define DRV_MODULE_RELDATE      "2014/02/10"
 #define BNX2X_BC_VER            0x040200
 
 #if defined(CONFIG_DCB)

drivers/net/ethernet/broadcom/bnx2x/bnx2x_hsi.h

@@ -2848,7 +2848,7 @@ struct afex_stats {
 
 #define BCM_5710_FW_MAJOR_VERSION			7
 #define BCM_5710_FW_MINOR_VERSION			8
-#define BCM_5710_FW_REVISION_VERSION		17
+#define BCM_5710_FW_REVISION_VERSION		19
 #define BCM_5710_FW_ENGINEERING_VERSION		0
 #define BCM_5710_FW_COMPILE_FLAGS			1