power: reset: ltc2952: Remove bogus hrtimer_start() return value checks

The return value of hrtimer_start() tells whether the timer was
inactive or active already when hrtimer_start() was called.

The code emits a bogus warning if the timer was active already
claiming that the timer could not be started.

Remove it along with the bogus comment in the else path.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Acked-by: Frans Klaver <frans.klaver@xsens.com>
Cc: Sebastian Reichel <sre@kernel.org>
Cc: Dmitry Eremin-Solenikov <dbaryshkov@gmail.com>
Cc: David Woodhouse <dwmw2@infradead.org>
Cc: Wolfram Sang <wsa@the-dreams.de>
Cc: linux-pm@vger.kernel.org

drivers/power/reset/ltc2952-poweroff.c

@@ -120,18 +120,7 @@ static enum hrtimer_restart ltc2952_poweroff_timer_wde(struct hrtimer *timer)
 
 static void ltc2952_poweroff_start_wde(struct ltc2952_poweroff *data)
 {
-	if (hrtimer_start(&data->timer_wde, data->wde_interval,
-			  HRTIMER_MODE_REL)) {
-		/*
-		 * The device will not toggle the watchdog reset,
-		 * thus shut down is only safe if the PowerPath controller
-		 * has a long enough time-off before triggering a hardware
-		 * power-off.
-		 *
-		 * Only sending a warning as the system will power-off anyway
-		 */
-		dev_err(data->dev, "unable to start the timer\n");
-	}
+	hrtimer_start(&data->timer_wde, data->wde_interval, HRTIMER_MODE_REL);
 }
 
 static enum hrtimer_restart
@@ -165,12 +154,10 @@ static irqreturn_t ltc2952_poweroff_handler(int irq, void *dev_id)
 	}
 
 	if (gpiod_get_value(data->gpio_trigger)) {
-		if (hrtimer_start(&data->timer_trigger, data->trigger_delay,
-				  HRTIMER_MODE_REL))
-			dev_err(data->dev, "unable to start the wait timer\n");
+		hrtimer_start(&data->timer_trigger, data->trigger_delay,
+			      HRTIMER_MODE_REL);
 	} else {
 		hrtimer_cancel(&data->timer_trigger);
-		/* omitting return value check, timer should have been valid */
 	}
 	return IRQ_HANDLED;
 }