KVM: x86: Update APICv on APIC reset

In kvm_apic_set_state() we update the hardware virtualized APIC after
the full APIC state has been overwritten. Do the same, when the full
APIC state has been reset in kvm_lapic_reset().

This updates some hardware state that was previously forgotten, as
far as I can tell. Also, this allows removing some APIC-related reset
code from vmx_vcpu_reset().
Signed-off-by: Jan H. Schönherr <jschoenh@amazon.de>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

arch/x86/kvm/lapic.c

@@ -1992,6 +1992,11 @@ void kvm_lapic_reset(struct kvm_vcpu *vcpu, bool init_event)
 				vcpu->arch.apic_base | MSR_IA32_APICBASE_BSP);
 	vcpu->arch.pv_eoi.msr_val = 0;
 	apic_update_ppr(apic);
+	if (vcpu->arch.apicv_active) {
+		kvm_x86_ops->apicv_post_state_restore(vcpu);
+		kvm_x86_ops->hwapic_irr_update(vcpu, -1);
+		kvm_x86_ops->hwapic_isr_update(vcpu, -1);
+	}
 
 	vcpu->arch.apic_arb_prio = 0;
 	vcpu->arch.apic_attention = 0;

arch/x86/kvm/vmx.c

@@ -5619,11 +5619,6 @@ static void vmx_vcpu_reset(struct kvm_vcpu *vcpu, bool init_event)
 
 	kvm_make_request(KVM_REQ_APIC_PAGE_RELOAD, vcpu);
 
-	if (kvm_vcpu_apicv_active(vcpu)) {
-		pi_clear_on(&vmx->pi_desc);
-		memset(vmx->pi_desc.pir, 0, sizeof(vmx->pi_desc.pir));
-	}
-
 	if (vmx->vpid != 0)
 		vmcs_write16(VIRTUAL_PROCESSOR_ID, vmx->vpid);