Commit 44b1d42a authored by Kevin Hilman's avatar Kevin Hilman

ARM: OMAP2: UART: fix console UART mismatched runtime PM status

The runtime PM framework assumes that the hardware state of devices
when initialized is disabled.  For all omap_devices, we idle/disable
device by default.  However, the console uart uses a "no idle" option
during omap_device init in order to allow earlyprintk usage to work
seamlessly during boot.

Because the hardware is left partially enabled after init (whatever
the bootloader settings were), the omap_device should later be fully
initialized (including mux) and the runtime PM framework should be
told that the device is active, and not disabled so that the hardware
state is in sync with runtime PM state.

To fix, after the device has been created/registered, call
omap_device_enable() to finialize init and use pm_runtime_set_active()
to tell the runtime PM core the device is enabled.

Tested on 2420/n810, 3530/Overo, 3530/Beagle, 3730/OveroSTORM,
3730/Beagle-xM, 4460/PandaES.
Suggested-by: default avatarRussell King <rmk+kernel@arm.linux.org.uk>
Cc: Felipe Balbi <balbi@ti.com>
Cc: Sourav Poddar <sourav.poddar@ti.com>
Signed-off-by: default avatarKevin Hilman <khilman@ti.com>
parent 856c3c5b
...@@ -329,6 +329,11 @@ void __init omap_serial_init_port(struct omap_board_data *bdata, ...@@ -329,6 +329,11 @@ void __init omap_serial_init_port(struct omap_board_data *bdata,
oh->mux = omap_hwmod_mux_init(bdata->pads, bdata->pads_cnt); oh->mux = omap_hwmod_mux_init(bdata->pads, bdata->pads_cnt);
if (console_uart_id == bdata->id) {
omap_device_enable(pdev);
pm_runtime_set_active(&pdev->dev);
}
oh->dev_attr = uart; oh->dev_attr = uart;
if (((cpu_is_omap34xx() || cpu_is_omap44xx()) && bdata->pads) if (((cpu_is_omap34xx() || cpu_is_omap44xx()) && bdata->pads)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment