agp: efficeon-agp: do not use PCI resources before pci_enable_device()

IRQ and resource[] may not have correct values until
after PCI hotplug setup occurs at pci_enable_device() time.

The semantic match that finds this problem is as follows:

// <smpl>
@@
identifier x;
identifier request ~= "pci_request.*|pci_resource.*";
@@

(
* x->irq
|
* x->resource
|
* request(x, ...)
)
 ...
*pci_enable_device(x)
// </smpl>
Signed-off-by: Kulikov Vasiliy <segooon@gmail.com>
Signed-off-by: Dave Airlie <airlied@redhat.com>

drivers/char/agp/efficeon-agp.c

@@ -372,29 +372,29 @@ static int __devinit agp_efficeon_probe(struct pci_dev *pdev,
 	bridge->capndx = cap_ptr;
 
 	/*
-	* The following fixes the case where the BIOS has "forgotten" to
-	* provide an address range for the GART.
+	* If the device has not been properly setup, the following will catch
+	* the problem and should stop the system from crashing.
 	* 20030610 - hamish@zot.org
 	*/
-	r = &pdev->resource[0];
-	if (!r->start && r->end) {
-		if (pci_assign_resource(pdev, 0)) {
-			printk(KERN_ERR PFX "could not assign resource 0\n");
+	if (pci_enable_device(pdev)) {
+		printk(KERN_ERR PFX "Unable to Enable PCI device\n");
 		agp_put_bridge(bridge);
 		return -ENODEV;
 	}
-	}
 
 	/*
-	* If the device has not been properly setup, the following will catch
-	* the problem and should stop the system from crashing.
+	* The following fixes the case where the BIOS has "forgotten" to
+	* provide an address range for the GART.
 	* 20030610 - hamish@zot.org
 	*/
-	if (pci_enable_device(pdev)) {
-		printk(KERN_ERR PFX "Unable to Enable PCI device\n");
+	r = &pdev->resource[0];
+	if (!r->start && r->end) {
+		if (pci_assign_resource(pdev, 0)) {
+			printk(KERN_ERR PFX "could not assign resource 0\n");
 			agp_put_bridge(bridge);
 			return -ENODEV;
 		}
+	}
 
 	/* Fill in the mode register */
 	if (cap_ptr) {