stmmac: add GMAC4 core support

This is the initial support for GMAC4 that includes
the main callbacks to setup the core module: including
Csum, basic filtering, mac address and interrupt (MMC,
MTL, PMT) No LPI added.
Signed-off-by: Alexandre TORGUE <alexandre.torgue@st.com>
Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/stmicro/stmmac/Makefile

@@ -3,7 +3,7 @@ stmmac-objs:= stmmac_main.o stmmac_ethtool.o stmmac_mdio.o ring_mode.o	\
 	      chain_mode.o dwmac_lib.o dwmac1000_core.o dwmac1000_dma.o	\
 	      dwmac100_core.o dwmac100_dma.o enh_desc.o norm_desc.o	\
 	      mmc_core.o stmmac_hwtstamp.o stmmac_ptp.o dwmac4_descs.o	\
-	      dwmac4_dma.o dwmac4_lib.o $(stmmac-y)
+	      dwmac4_dma.o dwmac4_lib.o dwmac4_core.o $(stmmac-y)
 
 # Ordering matters. Generic driver must be last.
 obj-$(CONFIG_STMMAC_PLATFORM)	+= stmmac-platform.o

drivers/net/ethernet/stmicro/stmmac/common.h

@@ -527,15 +527,21 @@ struct mac_device_info *dwmac1000_setup(void __iomem *ioaddr, int mcbins,
 					int perfect_uc_entries,
 					int *synopsys_id);
 struct mac_device_info *dwmac100_setup(void __iomem *ioaddr, int *synopsys_id);
-
+struct mac_device_info *dwmac4_setup(void __iomem *ioaddr, int mcbins,
+				     int perfect_uc_entries, int *synopsys_id);
 
 void stmmac_set_mac_addr(void __iomem *ioaddr, u8 addr[6],
 			 unsigned int high, unsigned int low);
 void stmmac_get_mac_addr(void __iomem *ioaddr, unsigned char *addr,
 			 unsigned int high, unsigned int low);
-
 void stmmac_set_mac(void __iomem *ioaddr, bool enable);
 
+void stmmac_dwmac4_set_mac_addr(void __iomem *ioaddr, u8 addr[6],
+				unsigned int high, unsigned int low);
+void stmmac_dwmac4_get_mac_addr(void __iomem *ioaddr, unsigned char *addr,
+				unsigned int high, unsigned int low);
+void stmmac_dwmac4_set_mac(void __iomem *ioaddr, bool enable);
+
 void dwmac_dma_flush_tx_fifo(void __iomem *ioaddr);
 extern const struct stmmac_mode_ops ring_mode_ops;
 extern const struct stmmac_mode_ops chain_mode_ops;

drivers/net/ethernet/stmicro/stmmac/dwmac4.h

@@ -221,4 +221,35 @@ enum power_event {
 /* To dump the core regs excluding  the Address Registers */
 #define	GMAC_REG_NUM	132
 
+/*  MTL debug */
+#define MTL_DEBUG_TXSTSFSTS		BIT(5)
+#define MTL_DEBUG_TXFSTS		BIT(4)
+#define MTL_DEBUG_TWCSTS		BIT(3)
+
+/* MTL debug: Tx FIFO Read Controller Status */
+#define MTL_DEBUG_TRCSTS_MASK		GENMASK(2, 1)
+#define MTL_DEBUG_TRCSTS_SHIFT		1
+#define MTL_DEBUG_TRCSTS_IDLE		0
+#define MTL_DEBUG_TRCSTS_READ		1
+#define MTL_DEBUG_TRCSTS_TXW		2
+#define MTL_DEBUG_TRCSTS_WRITE		3
+#define MTL_DEBUG_TXPAUSED		BIT(0)
+
+/* MAC debug: GMII or MII Transmit Protocol Engine Status */
+#define MTL_DEBUG_RXFSTS_MASK		GENMASK(5, 4)
+#define MTL_DEBUG_RXFSTS_SHIFT		4
+#define MTL_DEBUG_RXFSTS_EMPTY		0
+#define MTL_DEBUG_RXFSTS_BT		1
+#define MTL_DEBUG_RXFSTS_AT		2
+#define MTL_DEBUG_RXFSTS_FULL		3
+#define MTL_DEBUG_RRCSTS_MASK		GENMASK(2, 1)
+#define MTL_DEBUG_RRCSTS_SHIFT		1
+#define MTL_DEBUG_RRCSTS_IDLE		0
+#define MTL_DEBUG_RRCSTS_RDATA		1
+#define MTL_DEBUG_RRCSTS_RSTAT		2
+#define MTL_DEBUG_RRCSTS_FLUSH		3
+#define MTL_DEBUG_RWCSTS		BIT(0)
+
+extern const struct stmmac_dma_ops dwmac4_dma_ops;
+extern const struct stmmac_dma_ops dwmac410_dma_ops;
 #endif /* __DWMAC4_H__ */