bonding: ensure that TLB mode's active slave has correct mac filter

Currently, in TLB mode we change mac addresses only by memcpy-ing the to
net_device->dev_addr, without actually setting them via
dev_set_mac_address(). This permits us to receive all the traffic always on
one mac address.

However, in case the interface flips, some drivers might enforce the
mac filtering for its FW/HW based on current ->dev_addr, and thus we won't
be able to receive traffic on that interface, in case it will be selected
as active in TLB mode.

Fix it by setting the mac address forcefully on every new active slave that
we select in TLB mode.

CC: Jay Vosburgh <fubar@us.ibm.com>
CC: Andy Gospodarek <andy@greyhouse.net>
CC: Yuval Mintz <yuvalmin@broadcom.com>
Reported-by: Yuval Mintz <yuvalmin@broadcom.com>
Tested-by: Yuval Mintz <yuvalmin@broadcom.com>
Signed-off-by: Veaceslav Falico <vfalico@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/bonding/bond_alb.c

@@ -1699,6 +1699,23 @@ void bond_alb_handle_active_change(struct bonding *bond, struct slave *new_slave
 
 	ASSERT_RTNL();
 
+	/* in TLB mode, the slave might flip down/up with the old dev_addr,
+	 * and thus filter bond->dev_addr's packets, so force bond's mac
+	 */
+	if (bond->params.mode == BOND_MODE_TLB) {
+		struct sockaddr sa;
+		u8 tmp_addr[ETH_ALEN];
+
+		memcpy(tmp_addr, new_slave->dev->dev_addr, ETH_ALEN);
+
+		memcpy(sa.sa_data, bond->dev->dev_addr, bond->dev->addr_len);
+		sa.sa_family = bond->dev->type;
+		/* we don't care if it can't change its mac, best effort */
+		dev_set_mac_address(new_slave->dev, &sa);
+
+		memcpy(new_slave->dev->dev_addr, tmp_addr, ETH_ALEN);
+	}
+
 	/* curr_active_slave must be set before calling alb_swap_mac_addr */
 	if (swap_slave) {
 		/* swap mac address */