pinctrl/amd: Configure GPIO register using BIOS settings

In the function amd_gpio_irq_set_type, use the settings provided by
the BIOS,when the LevelTrig is Edge and activeLevel is HIGH, to configure
the GPIO registers. Ignore the settings from client.
Reviewed-by: Pankaj Sen <Pankaj.Sen@amd.com>
Signed-off-by: Nitesh Kumar Agrawal <Nitesh-kumar.Agrawal@amd.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/pinctrl/pinctrl-amd.c

@@ -403,12 +403,27 @@ static int amd_gpio_irq_set_type(struct irq_data *d, unsigned int type)
 	int ret = 0;
 	u32 pin_reg;
 	unsigned long flags;
+	u32 level_trig;
+	u32 active_level;
 	struct gpio_chip *gc = irq_data_get_irq_chip_data(d);
 	struct amd_gpio *gpio_dev = gpiochip_get_data(gc);
 
 	spin_lock_irqsave(&gpio_dev->lock, flags);
 	pin_reg = readl(gpio_dev->base + (d->hwirq)*4);
 
+	/*
+	 * When level_trig is set EDGE and active_level is set HIGH in BIOS
+	 * default settings, ignore incoming settings from client and use
+	 * BIOS settings to configure GPIO register.
+	 */
+	level_trig = pin_reg & (LEVEL_TRIGGER << LEVEL_TRIG_OFF);
+	active_level = pin_reg & (ACTIVE_LEVEL_MASK << ACTIVE_LEVEL_OFF);
+
+	if((!level_trig) &&
+	   ((active_level >> ACTIVE_LEVEL_OFF) == ACTIVE_HIGH)) {
+		type = IRQ_TYPE_EDGE_FALLING;
+	}
+
 	switch (type & IRQ_TYPE_SENSE_MASK) {
 	case IRQ_TYPE_EDGE_RISING:
 		pin_reg &= ~BIT(LEVEL_TRIG_OFF);