iio: light: add MAX30100 oximeter driver support

MAX30100 is an heart rate and pulse oximeter sensor that works using
two LEDS of different wavelengths, and detecting the light reflected
back.

This patchset adds support for both IR and RED LED channels which can
be processed in userspace to determine heart rate and blood oxygen
levels.
Signed-off-by: Matt Ranostay <mranostay@gmail.com>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>

Documentation/devicetree/bindings/iio/health/max30100.txt

+Maxim MAX30100 heart rate and pulse oximeter sensor
+
+* https://datasheets.maximintegrated.com/en/ds/MAX30100.pdf
+
+Required properties:
+  - compatible: must be "maxim,max30100"
+  - reg: the I2C address of the sensor
+  - interrupt-parent: should be the phandle for the interrupt controller
+  - interrupts: the sole interrupt generated by the device
+
+  Refer to interrupt-controller/interrupts.txt for generic
+  interrupt client node bindings.
+
+Example:
+
+max30100@057 {
+	compatible = "maxim,max30100";
+	reg = <57>;
+	interrupt-parent = <&gpio1>;
+	interrupts = <16 2>;
+};

drivers/iio/Kconfig

@@ -69,6 +69,7 @@ source "drivers/iio/dac/Kconfig"
 source "drivers/iio/dummy/Kconfig"
 source "drivers/iio/frequency/Kconfig"
 source "drivers/iio/gyro/Kconfig"
+source "drivers/iio/health/Kconfig"
 source "drivers/iio/humidity/Kconfig"
 source "drivers/iio/imu/Kconfig"
 source "drivers/iio/light/Kconfig"

drivers/iio/Makefile

@@ -21,6 +21,7 @@ obj-y += dac/
 obj-y += dummy/
 obj-y += gyro/
 obj-y += frequency/
+obj-y += health/
 obj-y += humidity/
 obj-y += imu/
 obj-y += light/

drivers/iio/health/Kconfig

+#
+# Health sensors
+#
+# When adding new entries keep the list in alphabetical order
+
+menu "Health sensors"
+
+config MAX30100
+	tristate "MAX30100 heart rate and pulse oximeter sensor"
+	depends on I2C
+	select REGMAP_I2C
+	select IIO_BUFFER
+	select IIO_KFIFO_BUF
+	help
+	  Say Y here to build I2C interface support for the Maxim
+	  MAX30100 heart rate, and pulse oximeter sensor.
+
+	  To compile this driver as a module, choose M here: the
+	  module will be called max30100.
+
+endmenu

drivers/iio/health/Makefile

+#
+# Makefile for IIO Health sensors
+#
+
+# When adding new entries keep the list in alphabetical order
+
+obj-$(CONFIG_MAX30100)		+= max30100.o