Merge branch 'upstream-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-dev

* 'upstream-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jgarzik/libata-dev:
  libata: Power off empty ports
  libata-pmp: add support for Thermaltake BlackX Duet esata drive dock
  ATA: Don't powerdown Compaq Triflex IDE device on suspend
  libata: Use Maximum Write Same Length to report discard size limit
  drivers/ata/acard-ahci.c: fix enum warning
  pata_at91: SMC settings calculation bugfixes, support for t6z and IORDY
  libata-sff: prevent irq descriptions for dummy ports
  pata_cm64x: fix boot crash on parisc

drivers/ata/acard-ahci.c

@@ -417,7 +417,7 @@ static int acard_ahci_init_one(struct pci_dev *pdev, const struct pci_device_id
 
 	VPRINTK("ENTER\n");
 
-	WARN_ON(ATA_MAX_QUEUE > AHCI_MAX_CMDS);
+	WARN_ON((int)ATA_MAX_QUEUE > AHCI_MAX_CMDS);
 
 	if (!printed_version++)
 		dev_printk(KERN_DEBUG, &pdev->dev, "version " DRV_VERSION "\n");

drivers/ata/libata-core.c

@@ -3619,8 +3619,14 @@ int sata_link_scr_lpm(struct ata_link *link, enum ata_lpm_policy policy,
 		scontrol |= (0x2 << 8);
 		break;
 	case ATA_LPM_MIN_POWER:
+		if (ata_link_nr_enabled(link) > 0)
 			/* no restrictions on LPM transitions */
 			scontrol &= ~(0x3 << 8);
+		else {
+			/* empty port, power off */
+			scontrol &= ~0xf;
+			scontrol |= (0x1 << 2);
+		}
 		break;
 	default:
 		WARN_ON(1);

drivers/ata/libata-eh.c

@@ -3423,7 +3423,7 @@ static int ata_eh_set_lpm(struct ata_link *link, enum ata_lpm_policy policy,
 	return rc;
 }
 
-static int ata_link_nr_enabled(struct ata_link *link)
+int ata_link_nr_enabled(struct ata_link *link)
 {
 	struct ata_device *dev;
 	int cnt = 0;

drivers/ata/libata-pmp.c

@@ -449,6 +449,16 @@ static void sata_pmp_quirks(struct ata_port *ap)
 		 * otherwise.  Don't try hard to recover it.
 		 */
 		ap->pmp_link[ap->nr_pmp_links - 1].flags |= ATA_LFLAG_NO_RETRY;
+	} else if (vendor == 0x197b && devid == 0x2352) {
+		/* chip found in Thermaltake BlackX Duet, jmicron JMB350? */
+		ata_for_each_link(link, ap, EDGE) {
+			/* SRST breaks detection and disks get misclassified
+			 * LPM disabled to avoid potential problems
+			 */
+			link->flags |= ATA_LFLAG_NO_LPM |
+				       ATA_LFLAG_NO_SRST |
+				       ATA_LFLAG_ASSUME_ATA;
+		}
 	}
 }
 

drivers/ata/libata-scsi.c

@@ -2138,7 +2138,7 @@ static unsigned int ata_scsiop_inq_b0(struct ata_scsi_args *args, u8 *rbuf)
 	 * with the unmap bit set.
 	 */
 	if (ata_id_has_trim(args->id)) {
-		put_unaligned_be32(65535 * 512 / 8, &rbuf[20]);
+		put_unaligned_be64(65535 * 512 / 8, &rbuf[36]);
 		put_unaligned_be32(1, &rbuf[28]);
 	}
 

drivers/ata/libata-sff.c

@@ -2447,13 +2447,18 @@ int ata_pci_sff_activate_host(struct ata_host *host,
 		return -ENOMEM;
 
 	if (!legacy_mode && pdev->irq) {
+		int i;
+
 		rc = devm_request_irq(dev, pdev->irq, irq_handler,
 				      IRQF_SHARED, drv_name, host);
 		if (rc)
 			goto out;
 
-		ata_port_desc(host->ports[0], "irq %d", pdev->irq);
-		ata_port_desc(host->ports[1], "irq %d", pdev->irq);
+		for (i = 0; i < 2; i++) {
+			if (ata_port_is_dummy(host->ports[i]))
+				continue;
+			ata_port_desc(host->ports[i], "irq %d", pdev->irq);
+		}
 	} else if (legacy_mode) {
 		if (!ata_port_is_dummy(host->ports[0])) {
 			rc = devm_request_irq(dev, ATA_PRIMARY_IRQ(pdev),

drivers/ata/pata_cmd64x.c

@@ -41,6 +41,9 @@
 enum {
 	CFR 		= 0x50,
 		CFR_INTR_CH0  = 0x04,
+	CNTRL		= 0x51,
+		CNTRL_CH0     = 0x04,
+		CNTRL_CH1     = 0x08,
 	CMDTIM 		= 0x52,
 	ARTTIM0 	= 0x53,
 	DRWTIM0 	= 0x54,
@@ -328,9 +331,19 @@ static int cmd64x_init_one(struct pci_dev *pdev, const struct pci_device_id *id)
 			.port_ops = &cmd648_port_ops
 		}
 	};
-	const struct ata_port_info *ppi[] = { &cmd_info[id->driver_data], NULL };
-	u8 mrdmode;
+	const struct ata_port_info *ppi[] = { 
+		&cmd_info[id->driver_data],
+		&cmd_info[id->driver_data],
+		NULL
+	};
+	u8 mrdmode, reg;
 	int rc;
+	struct pci_dev *bridge = pdev->bus->self;
+	/* mobility split bridges don't report enabled ports correctly */
+	int port_ok = !(bridge && bridge->vendor ==
+			PCI_VENDOR_ID_MOBILITY_ELECTRONICS);
+	/* all (with exceptions below) apart from 643 have CNTRL_CH0 bit */
+	int cntrl_ch0_ok = (id->driver_data != 0);
 
 	rc = pcim_enable_device(pdev);
 	if (rc)
@@ -341,11 +354,18 @@ static int cmd64x_init_one(struct pci_dev *pdev, const struct pci_device_id *id)
 
 	if (pdev->device == PCI_DEVICE_ID_CMD_646) {
 		/* Does UDMA work ? */
-		if (pdev->revision > 4)
+		if (pdev->revision > 4) {
 			ppi[0] = &cmd_info[2];
+			ppi[1] = &cmd_info[2];
+		}
 		/* Early rev with other problems ? */
-		else if (pdev->revision == 1)
+		else if (pdev->revision == 1) {
 			ppi[0] = &cmd_info[3];
+			ppi[1] = &cmd_info[3];
+		}
+		/* revs 1,2 have no CNTRL_CH0 */
+		if (pdev->revision < 3)
+			cntrl_ch0_ok = 0;
 	}
 
 	pci_write_config_byte(pdev, PCI_LATENCY_TIMER, 64);
@@ -354,6 +374,20 @@ static int cmd64x_init_one(struct pci_dev *pdev, const struct pci_device_id *id)
 	mrdmode |= 0x02;	/* Memory read line enable */
 	pci_write_config_byte(pdev, MRDMODE, mrdmode);
 
+	/* check for enabled ports */
+	pci_read_config_byte(pdev, CNTRL, &reg);
+	if (!port_ok)
+		dev_printk(KERN_NOTICE, &pdev->dev, "Mobility Bridge detected, ignoring CNTRL port enable/disable\n");
+	if (port_ok && cntrl_ch0_ok && !(reg & CNTRL_CH0)) {
+		dev_printk(KERN_NOTICE, &pdev->dev, "Primary port is disabled\n");
+		ppi[0] = &ata_dummy_port_info;
+		
+	}
+	if (port_ok && !(reg & CNTRL_CH1)) {
+		dev_printk(KERN_NOTICE, &pdev->dev, "Secondary port is disabled\n");
+		ppi[1] = &ata_dummy_port_info;
+	}
+
 	/* Force PIO 0 here.. */
 
 	/* PPC specific fixup copied from old driver */

drivers/ata/pata_triflex.c

@@ -210,13 +210,34 @@ static const struct pci_device_id triflex[] = {
 	{ },
 };
 
+#ifdef CONFIG_PM
+static int triflex_ata_pci_device_suspend(struct pci_dev *pdev, pm_message_t mesg)
+{
+	struct ata_host *host = dev_get_drvdata(&pdev->dev);
+	int rc = 0;
+
+	rc = ata_host_suspend(host, mesg);
+	if (rc)
+		return rc;
+
+	/*
+	 * We must not disable or powerdown the device.
+	 * APM bios refuses to suspend if IDE is not accessible.
+	 */
+	pci_save_state(pdev);
+
+	return 0;
+}
+
+#endif
+
 static struct pci_driver triflex_pci_driver = {
 	.name 		= DRV_NAME,
 	.id_table	= triflex,
 	.probe 		= triflex_init_one,
 	.remove		= ata_pci_remove_one,
 #ifdef CONFIG_PM
-	.suspend	= ata_pci_device_suspend,
+	.suspend	= triflex_ata_pci_device_suspend,
 	.resume		= ata_pci_device_resume,
 #endif
 };

include/linux/libata.h

@@ -1151,6 +1151,7 @@ extern void ata_do_eh(struct ata_port *ap, ata_prereset_fn_t prereset,
 		      ata_reset_fn_t softreset, ata_reset_fn_t hardreset,
 		      ata_postreset_fn_t postreset);
 extern void ata_std_error_handler(struct ata_port *ap);
+extern int ata_link_nr_enabled(struct ata_link *link);
 
 /*
  * Base operations to inherit from and initializers for sht

include/linux/pci_ids.h

@@ -608,6 +608,8 @@
 #define PCI_DEVICE_ID_MATROX_G550	0x2527
 #define PCI_DEVICE_ID_MATROX_VIA	0x4536
 
+#define PCI_VENDOR_ID_MOBILITY_ELECTRONICS	0x14f2
+
 #define PCI_VENDOR_ID_CT		0x102c
 #define PCI_DEVICE_ID_CT_69000		0x00c0
 #define PCI_DEVICE_ID_CT_65545		0x00d8