Commit 5f8d17f6 authored by Stefan Richter's avatar Stefan Richter

ieee1394: ohci1394: proper log messages in suspend and resume

 - correct thinko in one of my last commits: cannot use PRINT macro with
   ohci == NULL
 - add log messages on ohci == NULL and on pci_enable_device != 0
 - update log macros from patch "revert fail on error in suspend" to use
   PRINT and DBGMSG where possible
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
parent 2a3f8ad3
......@@ -3537,9 +3537,12 @@ static int ohci1394_pci_suspend(struct pci_dev *pdev, pm_message_t state)
printk(KERN_INFO "%s does not fully support suspend and resume yet\n",
OHCI1394_DRIVER_NAME);
PRINT(KERN_DEBUG, "suspend called");
if (!ohci)
if (!ohci) {
printk(KERN_ERR "%s: tried to suspend nonexisting host\n",
OHCI1394_DRIVER_NAME);
return -ENXIO;
}
DBGMSG("suspend called");
/* Clear the async DMA contexts and stop using the controller */
hpsb_bus_reset(ohci->host);
......@@ -3562,16 +3565,12 @@ static int ohci1394_pci_suspend(struct pci_dev *pdev, pm_message_t state)
err = pci_save_state(pdev);
if (err) {
printk(KERN_ERR "%s: pci_save_state failed with %d\n",
OHCI1394_DRIVER_NAME, err);
PRINT(KERN_ERR, "pci_save_state failed with %d", err);
return err;
}
err = pci_set_power_state(pdev, pci_choose_state(pdev, state));
#ifdef OHCI1394_DEBUG
if (err)
printk(KERN_DEBUG "%s: pci_set_power_state failed with %d\n",
OHCI1394_DRIVER_NAME, err);
#endif /* OHCI1394_DEBUG */
DBGMSG("pci_set_power_state failed with %d", err);
/* PowerMac suspend code comes last */
#ifdef CONFIG_PPC_PMAC
......@@ -3593,9 +3592,12 @@ static int ohci1394_pci_resume(struct pci_dev *pdev)
int err;
struct ti_ohci *ohci = pci_get_drvdata(pdev);
PRINT(KERN_DEBUG, "resume called");
if (!ohci)
if (!ohci) {
printk(KERN_ERR "%s: tried to resume nonexisting host\n",
OHCI1394_DRIVER_NAME);
return -ENXIO;
}
DBGMSG("resume called");
/* PowerMac resume code comes first */
#ifdef CONFIG_PPC_PMAC
......@@ -3612,8 +3614,10 @@ static int ohci1394_pci_resume(struct pci_dev *pdev)
pci_set_power_state(pdev, PCI_D0);
pci_restore_state(pdev);
err = pci_enable_device(pdev);
if (err)
if (err) {
PRINT(KERN_ERR, "pci_enable_device failed with %d", err);
return err;
}
/* See ohci1394_pci_probe() for comments on this sequence */
ohci_soft_reset(ohci);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment