hwmon: (k8temp) Remove superfluous CPU family check

The family check in k8temp is not required because the driver is
already bound to a northbridge device only used with K8 CPUs.
Signed-off-by: Andreas Herrmann <andreas.herrmann3@amd.com>
Signed-off-by: Jean Delvare <khali@linux-fr.org>

drivers/hwmon/k8temp.c

@@ -191,8 +191,6 @@ static int __devinit k8temp_probe(struct pci_dev *pdev,
 	model = boot_cpu_data.x86_model;
 	stepping = boot_cpu_data.x86_mask;
 
-	switch (boot_cpu_data.x86) {
-	case 0xf:
 	/* feature available since SH-C0, exclude older revisions */
 	if (((model == 4) && (stepping == 0)) ||
 	    ((model == 5) && (stepping <= 1))) {
@@ -206,22 +204,17 @@ static int __devinit k8temp_probe(struct pci_dev *pdev,
 	 */
 	if (model >= 0x40) {
 		data->swap_core_select = 1;
-			dev_warn(&pdev->dev, "Temperature readouts might be "
-				 "wrong - check erratum #141\n");
+		dev_warn(&pdev->dev, "Temperature readouts might be wrong - "
+			 "check erratum #141\n");
 	}
 
-		if (is_rev_g_desktop(model)) {
 	/*
-			 * RevG desktop CPUs (i.e. no socket S1G1 or
-			 * ASB1 parts) need additional offset,
-			 * otherwise reported temperature is below
+	 * RevG desktop CPUs (i.e. no socket S1G1 or ASB1 parts) need
+	 * additional offset, otherwise reported temperature is below
 	 * ambient temperature
 	 */
+	if (is_rev_g_desktop(model))
 		data->temp_offset = 21000;
-		}
-
-		break;
-	}
 
 	pci_read_config_byte(pdev, REG_TEMP, &scfg);
 	scfg &= ~(SEL_PLACE | SEL_CORE);		/* Select sensor 0, core0 */