Commit 700dadfe authored by Robert Jarzmik's avatar Robert Jarzmik Committed by Mark Brown

ASoC: wm9713: convert to regmap

Convert the Wolfson WM9713 to regmap API. This will leverage all the
regmap functions (debug, registers update, etc ...).

As a bonus, this will pave the path to gpio chip introduction, and
devicetree support. This was tested on the mioa701 board, pxa27x based,
in PCM playback, and through suspend/resume.
Signed-off-by: default avatarRobert Jarzmik <robert.jarzmik@free.fr>
Reviewed-by: default avatarCharles Keepax <ckeepax@opensource.wolfsonmicro.com>
Signed-off-by: default avatarMark Brown <broonie@kernel.org>
parent 8005c49d
......@@ -891,6 +891,7 @@ config SND_SOC_WM9712
config SND_SOC_WM9713
tristate
select REGMAP_AC97
# Amp
config SND_SOC_LM4857
......
......@@ -19,6 +19,7 @@
#include <linux/slab.h>
#include <linux/module.h>
#include <linux/device.h>
#include <linux/regmap.h>
#include <sound/core.h>
#include <sound/pcm.h>
#include <sound/ac97_codec.h>
......@@ -39,33 +40,15 @@ struct wm9713_priv {
struct mutex lock;
};
static unsigned int ac97_read(struct snd_soc_codec *codec,
unsigned int reg);
static int ac97_write(struct snd_soc_codec *codec,
unsigned int reg, unsigned int val);
/*
* WM9713 register cache
* Reg 0x3c bit 15 is used by touch driver.
*/
static const u16 wm9713_reg[] = {
0x6174, 0x8080, 0x8080, 0x8080,
0xc880, 0xe808, 0xe808, 0x0808,
0x00da, 0x8000, 0xd600, 0xaaa0,
0xaaa0, 0xaaa0, 0x0000, 0x0000,
0x0f0f, 0x0040, 0x0000, 0x7f00,
0x0405, 0x0410, 0xbb80, 0xbb80,
0x0000, 0xbb80, 0x0000, 0x4523,
0x0000, 0x2000, 0x7eff, 0xffff,
0x0000, 0x0000, 0x0080, 0x0000,
0x0000, 0x0000, 0xfffe, 0xffff,
0x0000, 0x0000, 0x0000, 0xfffe,
0x4000, 0x0000, 0x0000, 0x0000,
0xb032, 0x3e00, 0x0000, 0x0000,
0x0000, 0x0000, 0x0000, 0x0000,
0x0000, 0x0000, 0x0000, 0x0006,
0x0001, 0x0000, 0x574d, 0x4c13,
};
static unsigned int ac97_read(struct snd_soc_codec *codec, unsigned int reg)
{
return snd_soc_read(codec, reg);
}
static int ac97_write(struct snd_soc_codec *codec, unsigned int reg,
unsigned int val)
{
return snd_soc_write(codec, reg, val);
}
#define HPL_MIXER 0
#define HPR_MIXER 1
......@@ -674,39 +657,97 @@ static const struct snd_soc_dapm_route wm9713_audio_map[] = {
{"Capture Mono Mux", "Right", "Right Capture Source"},
};
static unsigned int ac97_read(struct snd_soc_codec *codec,
unsigned int reg)
static bool wm9713_readable_reg(struct device *dev, unsigned int reg)
{
struct wm9713_priv *wm9713 = snd_soc_codec_get_drvdata(codec);
u16 *cache = codec->reg_cache;
if (reg == AC97_RESET || reg == AC97_GPIO_STATUS ||
reg == AC97_VENDOR_ID1 || reg == AC97_VENDOR_ID2 ||
reg == AC97_CD)
return soc_ac97_ops->read(wm9713->ac97, reg);
else {
reg = reg >> 1;
if (reg >= (ARRAY_SIZE(wm9713_reg)))
return -EIO;
return cache[reg];
switch (reg) {
case AC97_RESET ... AC97_PCM_SURR_DAC_RATE:
case AC97_PCM_LR_ADC_RATE:
case AC97_CENTER_LFE_MASTER:
case AC97_SPDIF ... AC97_LINE1_LEVEL:
case AC97_GPIO_CFG ... 0x5c:
case AC97_CODEC_CLASS_REV ... AC97_PCI_SID:
case 0x74 ... AC97_VENDOR_ID2:
return true;
default:
return false;
}
}
static int ac97_write(struct snd_soc_codec *codec, unsigned int reg,
unsigned int val)
static bool wm9713_writeable_reg(struct device *dev, unsigned int reg)
{
struct wm9713_priv *wm9713 = snd_soc_codec_get_drvdata(codec);
switch (reg) {
case AC97_VENDOR_ID1:
case AC97_VENDOR_ID2:
return false;
default:
return wm9713_readable_reg(dev, reg);
}
}
u16 *cache = codec->reg_cache;
soc_ac97_ops->write(wm9713->ac97, reg, val);
reg = reg >> 1;
if (reg < (ARRAY_SIZE(wm9713_reg)))
cache[reg] = val;
static const struct reg_default wm9713_reg_defaults[] = {
{ 0x02, 0x8080 }, /* Speaker Output Volume */
{ 0x04, 0x8080 }, /* Headphone Output Volume */
{ 0x06, 0x8080 }, /* Out3/OUT4 Volume */
{ 0x08, 0xc880 }, /* Mono Volume */
{ 0x0a, 0xe808 }, /* LINEIN Volume */
{ 0x0c, 0xe808 }, /* DAC PGA Volume */
{ 0x0e, 0x0808 }, /* MIC PGA Volume */
{ 0x10, 0x00da }, /* MIC Routing Control */
{ 0x12, 0x8000 }, /* Record PGA Volume */
{ 0x14, 0xd600 }, /* Record Routing */
{ 0x16, 0xaaa0 }, /* PCBEEP Volume */
{ 0x18, 0xaaa0 }, /* VxDAC Volume */
{ 0x1a, 0xaaa0 }, /* AUXDAC Volume */
{ 0x1c, 0x0000 }, /* Output PGA Mux */
{ 0x1e, 0x0000 }, /* DAC 3D control */
{ 0x20, 0x0f0f }, /* DAC Tone Control*/
{ 0x22, 0x0040 }, /* MIC Input Select & Bias */
{ 0x24, 0x0000 }, /* Output Volume Mapping & Jack */
{ 0x26, 0x7f00 }, /* Powerdown Ctrl/Stat*/
{ 0x28, 0x0405 }, /* Extended Audio ID */
{ 0x2a, 0x0410 }, /* Extended Audio Start/Ctrl */
{ 0x2c, 0xbb80 }, /* Audio DACs Sample Rate */
{ 0x2e, 0xbb80 }, /* AUXDAC Sample Rate */
{ 0x32, 0xbb80 }, /* Audio ADCs Sample Rate */
{ 0x36, 0x4523 }, /* PCM codec control */
{ 0x3a, 0x2000 }, /* SPDIF control */
{ 0x3c, 0xfdff }, /* Powerdown 1 */
{ 0x3e, 0xffff }, /* Powerdown 2 */
{ 0x40, 0x0000 }, /* General Purpose */
{ 0x42, 0x0000 }, /* Fast Power-Up Control */
{ 0x44, 0x0080 }, /* MCLK/PLL Control */
{ 0x46, 0x0000 }, /* MCLK/PLL Control */
{ 0x4c, 0xfffe }, /* GPIO Pin Configuration */
{ 0x4e, 0xffff }, /* GPIO Pin Polarity / Type */
{ 0x50, 0x0000 }, /* GPIO Pin Sticky */
{ 0x52, 0x0000 }, /* GPIO Pin Wake-Up */
/* GPIO Pin Status */
{ 0x56, 0xfffe }, /* GPIO Pin Sharing */
{ 0x58, 0x4000 }, /* GPIO PullUp/PullDown */
{ 0x5a, 0x0000 }, /* Additional Functions 1 */
{ 0x5c, 0x0000 }, /* Additional Functions 2 */
{ 0x60, 0xb032 }, /* ALC Control */
{ 0x62, 0x3e00 }, /* ALC / Noise Gate Control */
{ 0x64, 0x0000 }, /* AUXDAC input control */
{ 0x74, 0x0000 }, /* Digitiser Reg 1 */
{ 0x76, 0x0006 }, /* Digitiser Reg 2 */
{ 0x78, 0x0001 }, /* Digitiser Reg 3 */
{ 0x7a, 0x0000 }, /* Digitiser Read Back */
};
return 0;
}
static const struct regmap_config wm9713_regmap_config = {
.reg_bits = 16,
.reg_stride = 2,
.val_bits = 16,
.max_register = 0x7e,
.cache_type = REGCACHE_RBTREE,
.reg_defaults = wm9713_reg_defaults,
.num_reg_defaults = ARRAY_SIZE(wm9713_reg_defaults),
.volatile_reg = regmap_ac97_default_volatile,
.readable_reg = wm9713_readable_reg,
.writeable_reg = wm9713_writeable_reg,
};
/* PLL divisors */
struct _pll_div {
......@@ -1173,8 +1214,7 @@ static int wm9713_soc_suspend(struct snd_soc_codec *codec)
static int wm9713_soc_resume(struct snd_soc_codec *codec)
{
struct wm9713_priv *wm9713 = snd_soc_codec_get_drvdata(codec);
int i, ret;
u16 *cache = codec->reg_cache;
int ret;
ret = snd_ac97_reset(wm9713->ac97, true, WM9713_VENDOR_ID,
WM9713_VENDOR_ID_MASK);
......@@ -1189,12 +1229,8 @@ static int wm9713_soc_resume(struct snd_soc_codec *codec)
/* only synchronise the codec if warm reset failed */
if (ret == 0) {
for (i = 2; i < ARRAY_SIZE(wm9713_reg) << 1; i += 2) {
if (i == AC97_POWERDOWN || i == AC97_EXTENDED_MID ||
i == AC97_EXTENDED_MSTATUS || i > 0x66)
continue;
soc_ac97_ops->write(wm9713->ac97, i, cache[i>>1]);
}
regcache_mark_dirty(codec->component.regmap);
snd_soc_cache_sync(codec);
}
return ret;
......@@ -1203,6 +1239,7 @@ static int wm9713_soc_resume(struct snd_soc_codec *codec)
static int wm9713_soc_probe(struct snd_soc_codec *codec)
{
struct wm9713_priv *wm9713 = snd_soc_codec_get_drvdata(codec);
struct regmap *regmap;
int reg;
wm9713->ac97 = snd_soc_new_ac97_codec(codec, WM9713_VENDOR_ID,
......@@ -1210,6 +1247,14 @@ static int wm9713_soc_probe(struct snd_soc_codec *codec)
if (IS_ERR(wm9713->ac97))
return PTR_ERR(wm9713->ac97);
regmap = devm_regmap_init_ac97(wm9713->ac97, &wm9713_regmap_config);
if (IS_ERR(regmap)) {
snd_soc_free_ac97_codec(wm9713->ac97);
return PTR_ERR(regmap);
}
snd_soc_codec_init_regmap(codec, regmap);
/* unmute the adc - move to kcontrol */
reg = ac97_read(codec, AC97_CD) & 0x7fff;
ac97_write(codec, AC97_CD, reg);
......@@ -1221,6 +1266,7 @@ static int wm9713_soc_remove(struct snd_soc_codec *codec)
{
struct wm9713_priv *wm9713 = snd_soc_codec_get_drvdata(codec);
snd_soc_codec_exit_regmap(codec);
snd_soc_free_ac97_codec(wm9713->ac97);
return 0;
}
......@@ -1230,13 +1276,7 @@ static struct snd_soc_codec_driver soc_codec_dev_wm9713 = {
.remove = wm9713_soc_remove,
.suspend = wm9713_soc_suspend,
.resume = wm9713_soc_resume,
.read = ac97_read,
.write = ac97_write,
.set_bias_level = wm9713_set_bias_level,
.reg_cache_size = ARRAY_SIZE(wm9713_reg),
.reg_word_size = sizeof(u16),
.reg_cache_step = 2,
.reg_cache_default = wm9713_reg,
.controls = wm9713_snd_ac97_controls,
.num_controls = ARRAY_SIZE(wm9713_snd_ac97_controls),
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment