serial: sh-sci: Improve interrupts description

Describe interrupts property in more detail, especially when there are
more than one interrupt.
Signed-off-by: Chris Brandt <chris.brandt@renesas.com>
Reviewed-by: Geert Uytterhoeven <geert+renesas@glider.be>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Documentation/devicetree/bindings/serial/renesas,sci-serial.txt

@@ -73,7 +73,21 @@ Required properties:
     family-specific and/or generic versions.
 
   - reg: Base address and length of the I/O registers used by the UART.
-  - interrupts: Must contain an interrupt-specifier for the SCIx interrupt.
+  - interrupts: Must contain one or more interrupt-specifiers for the SCIx.
+                If a single interrupt is expressed, then all events are
+                multiplexed into this single interrupt.
+
+                If multiple interrupts are provided by the hardware, the order
+                in which the interrupts are listed must match order below. Note
+                that some HW interrupt events may be muxed together resulting
+                in duplicate entries.
+                The interrupt order is as follows:
+                  1. Error (ERI)
+                  2. Receive buffer full (RXI)
+                  3. Transmit buffer empty (TXI)
+                  4. Break (BRI)
+                  5. Data Ready (DRI)
+                  6. Transmit End (TEI)
 
   - clocks: Must contain a phandle and clock-specifier pair for each entry
     in clock-names.