[media] media: platform: rcar_drif: Add DRIF support

This patch adds Digital Radio Interface (DRIF) support to R-Car Gen3 SoCs.
The driver exposes each instance of DRIF as a V4L2 SDR device. A DRIF
device represents a channel and each channel can have one or two
sub-channels respectively depending on the target board.

DRIF supports only Rx functionality. It receives samples from a RF
frontend tuner chip it is interfaced with. The combination of DRIF and the
tuner device, which is registered as a sub-device, determines the receive
sample rate and format.

In order to be compliant as a V4L2 SDR device, DRIF needs to bind with
the tuner device, which can be provided by a third party vendor. DRIF acts
as a slave device and the tuner device acts as a master transmitting the
samples. The driver allows asynchronous binding of a tuner device that
is registered as a v4l2 sub-device. The driver can learn about the tuner
it is interfaced with based on port endpoint properties of the device in
device tree. The V4L2 SDR device inherits the controls exposed by the
tuner device.

The device can also be configured to use either one or both of the data
pins at runtime based on the master (tuner) configuration.
Signed-off-by: Ramesh Shanmugasundaram <ramesh.shanmugasundaram@bp.renesas.com>
Signed-off-by: Hans Verkuil <hansverk@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>

drivers/media/platform/Kconfig

@@ -550,3 +550,28 @@ config VIDEO_STM32_HDMI_CEC
          between compatible devices.
 
 endif #CEC_PLATFORM_DRIVERS
+
+menuconfig SDR_PLATFORM_DRIVERS
+	bool "SDR platform devices"
+	depends on MEDIA_SDR_SUPPORT
+	default n
+	---help---
+	  Say Y here to enable support for platform-specific SDR Drivers.
+
+if SDR_PLATFORM_DRIVERS
+
+config VIDEO_RCAR_DRIF
+	tristate "Renesas Digitial Radio Interface (DRIF)"
+	depends on VIDEO_V4L2 && HAS_DMA
+	depends on ARCH_RENESAS || COMPILE_TEST
+	select VIDEOBUF2_VMALLOC
+	---help---
+	  Say Y if you want to enable R-Car Gen3 DRIF support. DRIF is Digital
+	  Radio Interface that interfaces with an RF front end chip. It is a
+	  receiver of digital data which uses DMA to transfer received data to
+	  a configured location for an application to use.
+
+	  To compile this driver as a module, choose M here; the module
+	  will be called rcar_drif.
+
+endif # SDR_PLATFORM_DRIVERS

drivers/media/platform/Makefile

@@ -54,6 +54,7 @@ obj-$(CONFIG_VIDEO_SH_VOU)		+= sh_vou.o
 
 obj-$(CONFIG_SOC_CAMERA)		+= soc_camera/
 
+obj-$(CONFIG_VIDEO_RCAR_DRIF)		+= rcar_drif.o
 obj-$(CONFIG_VIDEO_RENESAS_FCP) 	+= rcar-fcp.o
 obj-$(CONFIG_VIDEO_RENESAS_FDP1)	+= rcar_fdp1.o
 obj-$(CONFIG_VIDEO_RENESAS_JPU) 	+= rcar_jpu.o