Commit 76591910 authored by Lothar Waßmann's avatar Lothar Waßmann Committed by Shawn Guo

ARM: dts: imx6qdl-tx6: add ENET_OUT clock to fec node

ENET_OUT is used as reference clock for the ethernet PHY on the Ka-Ro
TX6 modules. Specify this clock in DTB to let it be managed correctly
by the driver.
Signed-off-by: default avatarLothar Waßmann <LW@KARO-electronics.de>
Signed-off-by: default avatarShawn Guo <shawnguo@kernel.org>
parent 43ffc19e
...@@ -227,6 +227,11 @@ spidev1: spi@1 { ...@@ -227,6 +227,11 @@ spidev1: spi@1 {
&fec { &fec {
pinctrl-names = "default"; pinctrl-names = "default";
pinctrl-0 = <&pinctrl_enet>; pinctrl-0 = <&pinctrl_enet>;
clocks = <&clks IMX6QDL_CLK_ENET>,
<&clks IMX6QDL_CLK_ENET>,
<&clks IMX6QDL_CLK_ENET_REF>,
<&clks IMX6QDL_CLK_ENET_REF>;
clock-names = "ipg", "ahb", "ptp", "enet_out";
phy-mode = "rmii"; phy-mode = "rmii";
phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_HIGH>; phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_HIGH>;
phy-supply = <&reg_3v3_etn>; phy-supply = <&reg_3v3_etn>;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment