arm64: dts: r8a7795: salvator-x: Set drive-strength for ravb pins

The EthernetAVB should not depend on the bootloader to setup correct
drive-strength values. Values for drive-strength where found by
examining the registers after the bootloader has configured the
registers and successfully used the EthernetAVB.
Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se>
Reviewed-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Simon Horman <horms+renesas@verge.net.au>

arch/arm64/boot/dts/renesas/r8a7795-salvator-x.dts

@@ -247,10 +247,24 @@ i2c2_pins: i2c2 {
 	};
 
 	avb_pins: avb {
-		groups = "avb_mdc";
+		mux {
+			groups = "avb_link", "avb_phy_int", "avb_mdc",
+				 "avb_mii";
 			function = "avb";
 		};
 
+		pins_mdc {
+			groups = "avb_mdc";
+			drive-strength = <24>;
+		};
+
+		pins_mii_tx {
+			pins = "PIN_AVB_TX_CTL", "PIN_AVB_TXC", "PIN_AVB_TD0",
+			       "PIN_AVB_TD1", "PIN_AVB_TD2", "PIN_AVB_TD3";
+			drive-strength = <12>;
+		};
+	};
+
 	du_pins: du {
 		groups = "du_rgb888", "du_sync", "du_oddf", "du_clk_out_0";
 		function = "du";