[MIPS] SB1250: Fix bugs/warnings by creative use of volatile.

Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

arch/mips/mm/pg-sb1.c

@@ -218,8 +218,7 @@ void sb1_dma_init(void)
 	for (i = 0; i < DM_NUM_CHANNELS; i++) {
 		const u64 base_val = CPHYSADDR(&page_descr[i]) |
 				     V_DM_DSCR_BASE_RINGSZ(1);
-		volatile void *base_reg =
-			IOADDR(A_DM_REGISTER(i, R_DM_DSCR_BASE));
+		void *base_reg = IOADDR(A_DM_REGISTER(i, R_DM_DSCR_BASE));
 
 		__raw_writeq(base_val, base_reg);
 		__raw_writeq(base_val | M_DM_DSCR_BASE_RESET, base_reg);

arch/mips/pci/pci-bcm1480.c

@@ -216,7 +216,7 @@ static int __init bcm1480_pcibios_init(void)
 	/*
 	 * See if the PCI bus has been configured by the firmware.
 	 */
-	reg = *((volatile uint64_t *) IOADDR(A_SCD_SYSTEM_CFG));
+	reg = __raw_readq(IOADDR(A_SCD_SYSTEM_CFG));
 	if (!(reg & M_BCM1480_SYS_PCI_HOST)) {
 		bcm1480_bus_status |= PCI_DEVICE_MODE;
 	} else {

arch/mips/pci/pci-sb1250.c

@@ -228,7 +228,7 @@ static int __init sb1250_pcibios_init(void)
 	/*
 	 * See if the PCI bus has been configured by the firmware.
 	 */
-	reg = *((volatile uint64_t *) IOADDR(A_SCD_SYSTEM_CFG));
+	reg = __raw_readq(IOADDR(A_SCD_SYSTEM_CFG));
 	if (!(reg & M_SYS_PCI_HOST)) {
 		sb1250_bus_status |= PCI_DEVICE_MODE;
 	} else {

arch/mips/sibyte/bcm1480/smp.c

@@ -34,21 +34,21 @@ extern void smp_call_function_interrupt(void);
  * independent of board/firmware
  */
 
-static volatile void *mailbox_0_set_regs[] = {
+static void *mailbox_0_set_regs[] = {
 	IOADDR(A_BCM1480_IMR_CPU0_BASE + R_BCM1480_IMR_MAILBOX_0_SET_CPU),
 	IOADDR(A_BCM1480_IMR_CPU1_BASE + R_BCM1480_IMR_MAILBOX_0_SET_CPU),
 	IOADDR(A_BCM1480_IMR_CPU2_BASE + R_BCM1480_IMR_MAILBOX_0_SET_CPU),
 	IOADDR(A_BCM1480_IMR_CPU3_BASE + R_BCM1480_IMR_MAILBOX_0_SET_CPU),
 };
 
-static volatile void *mailbox_0_clear_regs[] = {
+static void *mailbox_0_clear_regs[] = {
 	IOADDR(A_BCM1480_IMR_CPU0_BASE + R_BCM1480_IMR_MAILBOX_0_CLR_CPU),
 	IOADDR(A_BCM1480_IMR_CPU1_BASE + R_BCM1480_IMR_MAILBOX_0_CLR_CPU),
 	IOADDR(A_BCM1480_IMR_CPU2_BASE + R_BCM1480_IMR_MAILBOX_0_CLR_CPU),
 	IOADDR(A_BCM1480_IMR_CPU3_BASE + R_BCM1480_IMR_MAILBOX_0_CLR_CPU),
 };
 
-static volatile void *mailbox_0_regs[] = {
+static void *mailbox_0_regs[] = {
 	IOADDR(A_BCM1480_IMR_CPU0_BASE + R_BCM1480_IMR_MAILBOX_0_CPU),
 	IOADDR(A_BCM1480_IMR_CPU1_BASE + R_BCM1480_IMR_MAILBOX_0_CPU),
 	IOADDR(A_BCM1480_IMR_CPU2_BASE + R_BCM1480_IMR_MAILBOX_0_CPU),

arch/mips/sibyte/swarm/setup.c

@@ -169,17 +169,19 @@ void __init plat_mem_setup(void)
 #define LEDS_PHYS MLEDS_PHYS
 #endif
 
-#define setled(index, c) \
-  ((unsigned char *)(IOADDR(LEDS_PHYS)+0x20))[(3-(index))<<3] = (c)
 void setleds(char *str)
 {
+	void *reg;
 	int i;
+
 	for (i = 0; i < 4; i++) {
-		if (!str[i]) {
-			setled(i, ' ');
-		} else {
-			setled(i, str[i]);
-		}
+		reg = IOADDR(LEDS_PHYS) + 0x20 + ((3 - i) << 3);
+
+		if (!str[i])
+			writeb(' ', reg);
+		else
+			writeb(str[i], reg);
 	}
 }
-#endif
+
+#endif /* LEDS_PHYS */

drivers/net/sb1250-mac.c

@@ -243,7 +243,7 @@ struct sbmac_softc {
 	 * Controller-specific things
 	 */
 
-	volatile void __iomem *sbm_base;          /* MAC's base address */
+	void __iomem		*sbm_base;          /* MAC's base address */
 	sbmac_state_t    sbm_state;         /* current state */
 
 	volatile void __iomem	*sbm_macenable;	/* MAC Enable Register */

include/asm-mips/sibyte/sb1250.h

@@ -67,6 +67,6 @@ extern void bcm1480_smp_finish(void);
 
 #endif
 
-#define IOADDR(a) ((volatile void __iomem *)(IO_BASE + (a)))
+#define IOADDR(a) ((void __iomem *)(IO_BASE + (a)))
 
 #endif