Merge bk://kernel.bkbits.net/acme/misc-2.5

into penguin.transmeta.com:/home/penguin/torvalds/repositories/kernel/linux

drivers/atm/ambassador.c

@@ -795,7 +795,6 @@ static inline void drain_rx_pool (amb_dev * dev, unsigned char pool) {
   return;
 }
 
-#ifdef MODULE
 static void drain_rx_pools (amb_dev * dev) {
   unsigned char pool;
   
@@ -803,10 +802,7 @@ static void drain_rx_pools (amb_dev * dev) {
   
   for (pool = 0; pool < NUM_RX_POOLS; ++pool)
     drain_rx_pool (dev, pool);
-  
-  return;
 }
-#endif
 
 static inline void fill_rx_pool (amb_dev * dev, unsigned char pool, int priority) {
   rx_in rx;

drivers/atm/ambassador.h

@@ -627,7 +627,7 @@ typedef struct {
 
 struct amb_dev {
   u8               irq;
-  u8               flags;
+  long		   flags;
   u32              iobase;
   u32 *            membase;
 

drivers/atm/horizon.c

@@ -603,8 +603,7 @@ static int make_rate (const hrz_dev * dev, u32 c, rounding r,
   
   // note: rounding the rate down means rounding 'p' up
   
-  const unsigned long br = test_bit (ultra, (hrz_flags *) &dev->flags) ?
-    BR_ULT : BR_HRZ;
+  const unsigned long br = test_bit(ultra, &dev->flags) ? BR_ULT : BR_HRZ;
   
   u32 div = CR_MIND;
   u32 pre;
@@ -1106,9 +1105,9 @@ static inline void rx_bus_master_complete_handler (hrz_dev * dev) {
 
 static inline int tx_hold (hrz_dev * dev) {
   while (test_and_set_bit (tx_busy, &dev->flags)) {
-    PRINTD (DBG_TX, "sleeping at tx lock %p %u", dev, dev->flags);
+    PRINTD (DBG_TX, "sleeping at tx lock %p %lu", dev, dev->flags);
     interruptible_sleep_on (&dev->tx_queue);
-    PRINTD (DBG_TX, "woken at tx lock %p %u", dev, dev->flags);
+    PRINTD (DBG_TX, "woken at tx lock %p %lu", dev, dev->flags);
     if (signal_pending (current))
       return -1;
   }

drivers/atm/horizon.h

@@ -429,7 +429,7 @@ struct hrz_dev {
 #endif
 
   u8                  irq;
-  u8                  flags;
+  long		      flags;
   u8                  tx_last;
   u8                  tx_idle;
 

drivers/char/mxser.c

@@ -328,13 +328,7 @@ struct mxser_hwconf mxsercfg[MXSER_BOARDS];
  * static functions:
  */
 
-#ifdef MODULE
-int init_module(void);
-void cleanup_module(void);
-#endif
-
 static void mxser_getcfg(int board, struct mxser_hwconf *hwconf);
-int mxser_init(void);
 static int mxser_get_ISA_conf(int, struct mxser_hwconf *);
 static int mxser_get_PCI_conf(struct pci_dev *, int, struct mxser_hwconf *);
 static void mxser_do_softint(void *);
@@ -373,21 +367,7 @@ static int mxser_set_modem_info(struct mxser_struct *, unsigned int, unsigned in
  * The MOXA C168/C104 serial driver boot-time initialization code!
  */
 
-
-#ifdef MODULE
-int init_module(void)
-{
-	int ret;
-
-	if (verbose)
-		printk("Loading module mxser ...\n");
-	ret = mxser_init();
-	if (verbose)
-		printk("Done.\n");
-	return (ret);
-}
-
-void cleanup_module(void)
+static void __exit mxser_module_exit(void)
 {
 	int i, err = 0;
 
@@ -411,8 +391,6 @@ void cleanup_module(void)
 		printk("Done.\n");
 
 }
-#endif
-
 
 int mxser_initbrd(int board, struct mxser_hwconf *hwconf)
 {
@@ -510,7 +488,7 @@ static int mxser_get_PCI_conf(struct pci_dev *pdev, int board_type, struct mxser
 	return (0);
 }
 
-int mxser_init(void)
+static int __init mxser_module_init(void)
 {
 	int i, m, retval, b;
 	int n, index;
@@ -2493,3 +2471,6 @@ static void mxser_normal_mode(int port)
 	}
 	outb(0x00, port + 4);
 }
+
+module_init(mxser_module_init);
+module_exit(mxser_module_exit);

drivers/char/sx.h

@@ -44,7 +44,7 @@ struct sx_board {
   int poll;
   int ta_type;
   struct timer_list       timer;
-  int                     locks;
+  long                    locks;
 };
 
 struct vpd_prom {

drivers/net/fealnx.c

@@ -1155,8 +1155,8 @@ static void netdev_timer(unsigned long data)
 	unsigned int old_linkok = np->linkok;
 
 	if (debug)
-		printk(KERN_DEBUG "%s: Media selection timer tick, status %8.8lx "
-		       "config %8.8lx.\n", dev->name, readl(ioaddr + ISR),
+		printk(KERN_DEBUG "%s: Media selection timer tick, status %8.8x "
+		       "config %8.8x.\n", dev->name, readl(ioaddr + ISR),
 		       readl(ioaddr + TCRRCR));
 
 	if (np->flags == HAS_MII_XCVR) {
@@ -1184,7 +1184,7 @@ static void tx_timeout(struct net_device *dev)
 	long ioaddr = dev->base_addr;
 	int i;
 
-	printk(KERN_WARNING "%s: Transmit timed out, status %8.8lx,"
+	printk(KERN_WARNING "%s: Transmit timed out, status %8.8x,"
 	       " resetting...\n", dev->name, readl(ioaddr + ISR));
 
 	{
@@ -1554,7 +1554,7 @@ static void intr_handler(int irq, void *dev_instance, struct pt_regs *rgs)
 	np->stats.rx_crc_errors += (readl(ioaddr + TALLY) & 0x7fff0000) >> 16;
 
 	if (debug)
-		printk(KERN_DEBUG "%s: exiting interrupt, status=%#4.4lx.\n",
+		printk(KERN_DEBUG "%s: exiting interrupt, status=%#4.4x.\n",
 		       dev->name, readl(ioaddr + ISR));
 
 	writel(np->imrvalue, ioaddr + IMR);

drivers/net/lance.c

@@ -390,7 +390,7 @@ int __init lance_probe(struct net_device *dev)
 static int __init lance_probe1(struct net_device *dev, int ioaddr, int irq, int options)
 {
 	struct lance_private *lp;
-	short dma_channels;					/* Mark spuriously-busy DMA channels */
+	long dma_channels;			/* Mark spuriously-busy DMA channels */
 	int i, reset_val, lance_version;
 	const char *chipname;
 	/* Flags for specific chips or boards. */

drivers/net/ni65.c

@@ -184,11 +184,41 @@ static struct card {
 	short addr_offset;
 	unsigned char *vendor_id;
 	char *cardname;
-	unsigned char config;
+	long config;
 } cards[] = {
-	{ NI65_ID0,NI65_ID1,0x0e,0x10,0x0,0x8,ni_vendor,"ni6510", 0x1 } ,
-	{ NI65_EB_ID0,NI65_EB_ID1,0x0e,0x18,0x10,0x0,ni_vendor,"ni6510 EtherBlaster", 0x2 } ,
-	{ NE2100_ID0,NE2100_ID1,0x0e,0x18,0x10,0x0,NULL,"generic NE2100", 0x0 }
+	{
+		.id0	     = NI65_ID0,
+		.id1	     = NI65_ID1,
+		.id_offset   = 0x0e,
+		.total_size  = 0x10,
+		.cmd_offset  = 0x0,
+		.addr_offset = 0x8,
+		.vendor_id   = ni_vendor,
+		.cardname    = "ni6510",
+		.config	     = 0x1,
+       	},
+	{
+		.id0	     = NI65_EB_ID0,
+		.id1	     = NI65_EB_ID1,
+		.id_offset   = 0x0e,
+		.total_size  = 0x18,
+		.cmd_offset  = 0x10,
+		.addr_offset = 0x0,
+		.vendor_id   = ni_vendor,
+		.cardname    = "ni6510 EtherBlaster",
+		.config	     = 0x2,
+       	},
+	{
+		.id0	     = NE2100_ID0,
+		.id1	     = NE2100_ID1,
+		.id_offset   = 0x0e,
+		.total_size  = 0x18,
+		.cmd_offset  = 0x10,
+		.addr_offset = 0x0,
+		.vendor_id   = NULL,
+		.cardname    = "generic NE2100",
+		.config	     = 0x0,
+	},
 };
 #define NUM_CARDS 3
 
@@ -415,7 +445,8 @@ static int __init ni65_probe1(struct net_device *dev,int ioaddr)
 	else {
 		if(dev->dma == 0) {
 		/* 'stuck test' from lance.c */
-			int dma_channels = ((inb(DMA1_STAT_REG) >> 4) & 0x0f) | (inb(DMA2_STAT_REG) & 0xf0);
+			long dma_channels = ((inb(DMA1_STAT_REG) >> 4) & 0x0f) |
+					    (inb(DMA2_STAT_REG) & 0xf0);
 			for(i=1;i<5;i++) {
 				int dma = dmatab[i];
 				if(test_bit(dma,&dma_channels) || request_dma(dma,"ni6510"))

drivers/net/setup.c

@@ -142,14 +142,13 @@ static void __init network_ldisc_init(void)
 static void __init special_device_init(void)
 {
 #ifdef CONFIG_NET_SB1000
-	{
-		extern int sb1000_probe(struct net_device *dev);
-		static struct net_device sb1000_dev = 
-		{
-			"cm0" __PAD3, 0x0, 0x0, 0x0, 0x0, 0, 0, 0, 0, 0, NULL, sb1000_probe 
-		};
-		register_netdev(&sb1000_dev);
-	}
+	extern int sb1000_probe(struct net_device *dev);
+
+	static struct net_device sb1000_dev = {
+		.name = "cm0" __PAD3,
+		.init = sb1000_probe,
+	};
+	register_netdev(&sb1000_dev);
 #endif
 }
 

include/linux/hdlcdrv.h

@@ -214,7 +214,7 @@ struct hdlcdrv_state {
 
 	struct hdlcdrv_hdlctx {
 		struct hdlcdrv_hdlcbuffer hbuf;
-		int in_hdlc_tx;
+		long in_hdlc_tx;
 		/*
 		 * 0 = send flags
 		 * 1 = send txtail (flags)