Merge branch 'dt-bindings-net-mdio.yaml-fixes'

Florian Fainelli says:

====================
dt-bindings: net: mdio.yaml fixes

This patch series documents some common MDIO devices properties such as
resets (and delays) and broken-turn-around. The second patch also
rephrases some descriptions to be more general towards MDIO devices and
not specific towards Ethernet PHYs.

Changes in v3:

- corrected wording of 'broken-turn-around' in ethernet-phy.yaml and
  mdio.yaml, add Andrew's R-b tag to patch #3
====================
Signed-off-by: David S. Miller <davem@davemloft.net>

Documentation/devicetree/bindings/net/ethernet-phy.yaml

@@ -81,7 +81,8 @@ properties:
     $ref: /schemas/types.yaml#definitions/flag
     description:
       If set, indicates the PHY device does not correctly release
-      the turn around line low at the end of a MDIO transaction.
+      the turn around line low at end of the control phase of the
+      MDIO transaction.
 
   enet-phy-lane-swap:
     $ref: /schemas/types.yaml#definitions/flag

Documentation/devicetree/bindings/net/mdio.yaml

@@ -31,13 +31,13 @@ properties:
     maxItems: 1
     description:
       The phandle and specifier for the GPIO that controls the RESET
-      lines of all PHYs on that MDIO bus.
+      lines of all devices on that MDIO bus.
 
   reset-delay-us:
     description:
-      RESET pulse width in microseconds. It applies to all PHY devices
-      and must therefore be appropriately determined based on all PHY
-      requirements (maximum value of all per-PHY RESET pulse widths).
+      RESET pulse width in microseconds. It applies to all MDIO devices
+      and must therefore be appropriately determined based on all devices
+      requirements (maximum value of all per-device RESET pulse widths).
 
   clock-frequency:
     description:
@@ -60,7 +60,35 @@ patternProperties:
         minimum: 0
         maximum: 31
         description:
-          The ID number for the PHY.
+          The ID number for the device.
+
+      broken-turn-around:
+        $ref: /schemas/types.yaml#definitions/flag
+        description:
+          If set, indicates the MDIO device does not correctly release
+          the turn around line low at end of the control phase of the
+          MDIO transaction.
+
+      resets:
+        maxItems: 1
+
+      reset-names:
+        const: phy
+
+      reset-gpios:
+        maxItems: 1
+        description:
+          The GPIO phandle and specifier for the MDIO reset signal.
+
+      reset-assert-us:
+        description:
+          Delay after the reset was asserted in microseconds. If this
+          property is missing the delay will be skipped.
+
+      reset-deassert-us:
+        description:
+          Delay after the reset was deasserted in microseconds. If
+          this property is missing the delay will be skipped.
 
     required:
       - reg