Commit b87fd2f7 authored by Sebastian Andrzej Siewior's avatar Sebastian Andrzej Siewior Committed by Felipe Balbi

usb: musb: core: check link status on resume

The am335x-evmsk support two kinds of suspend:
- standby
  the USB device remains powered while the system goes into suspend

- mem
  the USB device becomes powerless while the system goes into suspend.

In the "standby" case the device resumes quickly. In the "mem" case the
system hangs for a few seconds. It seems to me that the USB-device has
no address (it was disconnected) and the USB stack thinks that it is
fully operational and GetPortStatus returns the status from before the
suspend so it is not a big help here.

This adds a check in the resume path to see if the device mode (A or B)
and the speed is the same. If the device went missing between
suspend/resume (VBUS went down) then MUSB seems to go into B mode and
HS/FS bits are cleared. In that case we clear the port1_status bits and
assume a disconnect. Once the stack learns this it does a "logical
disconnect" and removes the USB-device quickly. Should the device remain
connected during the suspend then MUSB will receives a "CONNECT" interrupt.
Signed-off-by: default avatarSebastian Andrzej Siewior <bigeasy@linutronix.de>
Signed-off-by: default avatarFelipe Balbi <balbi@ti.com>
parent b4c9f578
...@@ -2300,6 +2300,8 @@ static int musb_suspend(struct device *dev) ...@@ -2300,6 +2300,8 @@ static int musb_suspend(struct device *dev)
static int musb_resume(struct device *dev) static int musb_resume(struct device *dev)
{ {
struct musb *musb = dev_to_musb(dev); struct musb *musb = dev_to_musb(dev);
u8 devctl;
u8 mask;
/* /*
* For static cmos like DaVinci, register values were preserved * For static cmos like DaVinci, register values were preserved
...@@ -2313,6 +2315,10 @@ static int musb_resume(struct device *dev) ...@@ -2313,6 +2315,10 @@ static int musb_resume(struct device *dev)
musb_restore_context(musb); musb_restore_context(musb);
devctl = musb_readb(musb->mregs, MUSB_DEVCTL);
mask = MUSB_DEVCTL_BDEVICE | MUSB_DEVCTL_FSDEV | MUSB_DEVCTL_LSDEV;
if ((devctl & mask) != (musb->context.devctl & mask))
musb->port1_status = 0;
return 0; return 0;
} }
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment