ext4: Return after ext4_error in case of failures

This fix some instances where we were continuing after calling
ext4_error. ext4_error call panic only if errors=panic mount option is
set. So we need to make sure we return correctly after ext4_error call

Reported by: Adrian Bunk <bunk@kernel.org>
Signed-off-by: Aneesh Kumar K.V <aneesh.kumar@linux.vnet.ibm.com>

fs/ext4/balloc.c

@@ -587,11 +587,13 @@ void ext4_free_blocks_sb(handle_t *handle, struct super_block *sb,
 	    in_range(ext4_inode_bitmap(sb, desc), block, count) ||
 	    in_range(block, ext4_inode_table(sb, desc), sbi->s_itb_per_group) ||
 	    in_range(block + count - 1, ext4_inode_table(sb, desc),
-		     sbi->s_itb_per_group))
+		     sbi->s_itb_per_group)) {
 		ext4_error (sb, "ext4_free_blocks",
 			    "Freeing blocks in system zones - "
 			    "Block = %llu, count = %lu",
 			    block, count);
+		goto error_return;
+	}
 
 	/*
 	 * We are about to start releasing blocks in the bitmap,
@@ -1690,11 +1692,13 @@ ext4_fsblk_t ext4_new_blocks(handle_t *handle, struct inode *inode,
 	    in_range(ret_block, ext4_inode_table(sb, gdp),
 		     EXT4_SB(sb)->s_itb_per_group) ||
 	    in_range(ret_block + num - 1, ext4_inode_table(sb, gdp),
-		     EXT4_SB(sb)->s_itb_per_group))
+		     EXT4_SB(sb)->s_itb_per_group)) {
 		ext4_error(sb, "ext4_new_block",
 			    "Allocating block in system zone - "
 			    "blocks from %llu, length %lu",
 			     ret_block, num);
+		goto out;
+	}
 
 	performed_allocation = 1;