arm: dts: meson: Fix IRQ trigger type for macirq

A long running stress test on a custom board shipping an AXG SoCs and a
Realtek RTL8211F PHY revealed that after a few hours the connection
speed would drop drastically, from ~1000Mbps to ~3Mbps. At the same time
the 'macirq' (eth0) IRQ would stop being triggered at all and as
consequence the GMAC IRQs never ACKed.

After a painful investigation the problem seemed to be due to a wrong
defined IRQ type for the GMAC IRQ that should be LEVEL_HIGH instead of
EDGE_RISING.

The change in the macirq IRQ type also solved another long standing
issue affecting this SoC/PHY where EEE was causing the network
connection to die after stressing it with iperf3 (even though much
sooner). It's now possible to remove the 'eee-broken-1000t' quirk as
well.

Fixes: 9c15795a ("ARM: dts: meson8b-odroidc1: ethernet support")
Signed-off-by: Carlo Caione <ccaione@baylibre.com>
Reviewed-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Tested-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>

arch/arm/boot/dts/meson.dtsi

@@ -274,7 +274,7 @@ ethmac: ethernet@c9410000 {
 			compatible = "amlogic,meson6-dwmac", "snps,dwmac";
 			reg = <0xc9410000 0x10000
 			       0xc1108108 0x4>;
-			interrupts = <GIC_SPI 8 IRQ_TYPE_EDGE_RISING>;
+			interrupts = <GIC_SPI 8 IRQ_TYPE_LEVEL_HIGH>;
 			interrupt-names = "macirq";
 			status = "disabled";
 		};

arch/arm/boot/dts/meson8b-odroidc1.dts

@@ -221,7 +221,6 @@ mdio {
 		/* Realtek RTL8211F (0x001cc916) */
 		eth_phy: ethernet-phy@0 {
 			reg = <0>;
-			eee-broken-1000t;
 			interrupt-parent = <&gpio_intc>;
 			/* GPIOH_3 */
 			interrupts = <17 IRQ_TYPE_LEVEL_LOW>;