mtd: nand: initialize bitflip_threshold prior to BBT scanning

As of edbc454 [mtd: driver _read() returns max_bitflips; mtd_read()
returns -EUCLEAN], 'mtd->bitflip_threshold' must be set for mtd devices
having ECC, prior any 'mtd_read()' call.
Otherwise, 'mtd_read()' will falsely return -EUCLEAN.

Normally, 'mtd->bitflip_threshold' is initialized when the MTD is added.

However, this is too late for NAND MTDs, as 'scan_bbt()' is invoked
prior the existing initialization of 'mtd->bitflip_threshold'.

This is a problem since 'scan_bbt()' calls 'mtd_read()', in the case
of a flash-based bad block table.
It resulted in a falsely reported bitflips indication during BBT read,
which lead to constant scrubbing of the flash BBT blocks.

Initialize 'mtd->bitflip_threshold' to its default value (if not already
set by the driver), prior to invocation of 'scan_bbt()'.
Reported-by: Sascha Hauer <s.hauer@pengutronix.de>
Tested-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Shmulik Ladkani <shmulik.ladkani@gmail.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>

drivers/mtd/nand/nand_base.c

@@ -3501,6 +3501,13 @@ int nand_scan_tail(struct mtd_info *mtd)
 	/* propagate ecc info to mtd_info */
 	mtd->ecclayout = chip->ecc.layout;
 	mtd->ecc_strength = chip->ecc.strength;
+	/*
+	 * Initialize bitflip_threshold to its default prior scan_bbt() call.
+	 * scan_bbt() might invoke mtd_read(), thus bitflip_threshold must be
+	 * properly set.
+	 */
+	if (!mtd->bitflip_threshold)
+		mtd->bitflip_threshold = mtd->ecc_strength;
 
 	/* Check, if we should skip the bad block table scan */
 	if (chip->options & NAND_SKIP_BBTSCAN)