iwlwifi: pcie: disable L1 Active after pci_enable_device

As Arjan pointed out, we mustn't do anything related to PCI
configuration until the device is properly enabled with
pci_enable_device().

Cc: stable@vger.kernel.org
Reported-by: Arjan van de Ven <arjan@linux.intel.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

drivers/net/wireless/iwlwifi/pcie/trans.c

@@ -1502,16 +1502,16 @@ struct iwl_trans *iwl_trans_pcie_alloc(struct pci_dev *pdev,
 	spin_lock_init(&trans_pcie->reg_lock);
 	init_waitqueue_head(&trans_pcie->ucode_write_waitq);
 
-	/* W/A - seems to solve weird behavior. We need to remove this if we
-	 * don't want to stay in L1 all the time. This wastes a lot of power */
-	pci_disable_link_state(pdev, PCIE_LINK_STATE_L0S | PCIE_LINK_STATE_L1 |
-			       PCIE_LINK_STATE_CLKPM);
-
 	if (pci_enable_device(pdev)) {
 		err = -ENODEV;
 		goto out_no_pci;
 	}
 
+	/* W/A - seems to solve weird behavior. We need to remove this if we
+	 * don't want to stay in L1 all the time. This wastes a lot of power */
+	pci_disable_link_state(pdev, PCIE_LINK_STATE_L0S | PCIE_LINK_STATE_L1 |
+			       PCIE_LINK_STATE_CLKPM);
+
 	pci_set_master(pdev);
 
 	err = pci_set_dma_mask(pdev, DMA_BIT_MASK(36));