sky2: document GPHY_CTRL bits

Add documentation of GPHY_CTRL register bits even if driver
is not using them (yet).
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

drivers/net/sky2.h

@@ -1850,6 +1850,28 @@ enum {
 
 /*	GPHY_CTRL		32 bit	GPHY Control Reg (YUKON only) */
 enum {
+	GPC_TX_PAUSE	= 1<<30, /* Tx pause enabled (ro) */
+	GPC_RX_PAUSE	= 1<<29, /* Rx pause enabled (ro) */
+	GPC_SPEED	= 3<<27, /* PHY speed (ro) */
+	GPC_LINK	= 1<<26, /* Link up (ro) */
+	GPC_DUPLEX	= 1<<25, /* Duplex (ro) */
+	GPC_CLOCK	= 1<<24, /* 125Mhz clock stable (ro) */
+
+	GPC_PDOWN	= 1<<23, /* Internal regulator 2.5 power down */
+	GPC_TSTMODE	= 1<<22, /* Test mode */
+	GPC_REG18	= 1<<21, /* Reg18 Power down */
+	GPC_REG12SEL	= 3<<19, /* Reg12 power setting */
+	GPC_REG18SEL	= 3<<17, /* Reg18 power setting */
+	GPC_SPILOCK	= 1<<16, /* SPI lock (ASF) */
+
+	GPC_LEDMUX	= 3<<14, /* LED Mux */
+	GPC_INTPOL	= 1<<13, /* Interrupt polarity */
+	GPC_DETECT	= 1<<12, /* Energy detect */
+	GPC_1000HD	= 1<<11, /* Enable 1000Mbit HD */
+	GPC_SLAVE	= 1<<10, /* Slave mode */
+	GPC_PAUSE	= 1<<9, /* Pause enable */
+	GPC_LEDCTL	= 3<<6, /* GPHY Leds */
+
 	GPC_RST_CLR	= 1<<1,	/* Clear GPHY Reset */
 	GPC_RST_SET	= 1<<0,	/* Set   GPHY Reset */
 };