The macro FILL_RX_POOLS_IN_BH is never been used, in order to avoid
the compiler reports error because of the usage of function INIT_WORK,
we just delete the marco.

Cc: Chas Williams <chas@cmf.nrl.navy.mil>
Cc: linux-atm-general@lists.sourceforge.net
Signed-off-by: Wang Shaoyan <wangshaoyan.pt@taobao.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

There is no need to check for the address being a multicast address in
the netdev_for_each_mc_addr loop, so remove it. This patch covers all
remaining network drivers still containing such a check.

Cc: Joe Perches <joe@perches.com>
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

We need to release "dcb_lock" which we took on the previous line.
Signed-off-by: Dan Carpenter <error27@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Change references to SysKonnect in Kconfig to Marvell since
SysKonnect was acquired by Marvell back in 2002.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Since new hardware chip support was added bump version.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

This is a backport from the vendor driver of support for the newer Optima
(Prime and 2) chipsets. It also includes some setup changes for the
current Optima chip as well. The code and comments intentionally
mirror the vendor sk98lin driver to allow for easier maintenance.

Although this adds support for new chip id's, these chip id's are not
used by any of the current PCI device id's listed in the driver.
The patch is just to get initial infrastructure in place to handle them
when they come.

I don't have access to any of this hardware to actually test it yet.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

This is another fix picked out of the vendor driver. The IPG value
in the serial mode register is supposed to be programmed differently
at lower speeds.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Found when reviewing the vendor driver. Apparently some chip versions
require receive checksumming to be enabled in order for RSS to work.

Also, if fix_features has to change some settings; put in message
in log in similar manner to netdev_fix_features.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

In case of tt_crc mismatching for a certain orig_node after applying the
changes, the node must request the full table immediately.
Signed-off-by: Antonio Quartulli <ordex@autistici.org>
Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>

To keep consistency of other originator tables, new clients detected as
roamed, are kept in the global table but are marked as TT_CLIENT_PENDING
They are purged only when the new ttvn is received by the corresponding
originator. Moreover they need to be considered as removed in case of global
transtable lookup.
Signed-off-by: Antonio Quartulli <ordex@autistici.org>
Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>

To keep transtable consistency among all the nodes, an originator must
not send not yet announced clients within a full table TT_RESPONSE.
Instead, deleted client have to be kept in the table in order to be sent
within an immediate TT_RESPONSE. In this way all the nodes in the
network will always provide the same response for the same request.

All the modification are committed at the next ttvn increment event.
Signed-off-by: Antonio Quartulli <ordex@autistici.org>
Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>

The last_ttvn and tt_crc fields of the orig_node structure were not
initialised causing an immediate TT_REQ/RES dialogue even if not needed.
Signed-off-by: Antonio Quartulli <ordex@autistici.org>
Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>

af_packet.c:(.text+0x3d130): undefined reference to `ip_defrag'
or
ERROR: "ip_defrag" [net/packet/af_packet.ko] undefined!
Reported-by: Randy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

fanout_add() might return with fanout_mutex held.

Reduce indentation level while we are at it
Signed-off-by: Eric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

In process and sleep allowed context, favor GFP_KERNEL allocations over
GFP_ATOMIC ones.
Signed-off-by: Eric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

This patch adds a dcbnl notification to the bnx2x. The notification is
sent to user mode clients following a change in the dcb negotiated
parameters as resolved by the embedded DCBX stack. 
Signed-off-by: Shmulik Ravid <shmulikr@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Reduce the number of variables modified by the loop in do_csum() by 1,
which seems like a good idea.  On Nios II (a RISC CPU with 3-operand
instruction set) it reduces the loop from 7 to 6 instructions, including
the conditional branch.
Signed-off-by: Ian Abbott <abbotti@mev.co.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

Only 128 bytes is copied, the rest of data is DMA mapped directly from
userspace.
Signed-off-by: Shirley Ma <xma@...ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

This patch adds userspace buffers support in skb shared info. A new
struct skb_ubuf_info is needed to maintain the userspace buffers
argument and index, a callback is used to notify userspace to release
the buffers once lower device has done DMA (Last reference to that skb
has gone).

If there is any userspace apps to reference these userspace buffers,
then these userspaces buffers will be copied into kernel. This way we
can prevent userspace apps from holding these userspace buffers too long.

Use destructor_arg to point to the userspace buffer info; a new tx flags
SKBTX_DEV_ZEROCOPY is added for zero-copy buffer check.
Signed-off-by: Shirley Ma <xma@...ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Shirley Ma <xma@us.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

This patch:
# improves readability of some gianfar nfc code
Signed-off-by: Sebastian Poehn <sebastian.poehn@belden.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

RFC 6164 requires that routers MUST disable Subnet-Router anycast
for the prefix when /127 prefixes are used.

No need for matching code in addrconf_leave_anycast() as it
will silently ignore any attempt to leave an unknown anycast
address.
Signed-off-by: Bjørn Mork <bjorn@mork.no>
Signed-off-by: David S. Miller <davem@davemloft.net>

These intefaces haven't existed since 2.2.x
Signed-off-by: David S. Miller <davem@davemloft.net>

Update version number, and take "New" off the config information
since old sk98lin has been gone for a couple years.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

The GENESIS boards are really old PCI-X boards that are rare.
Marvell has dropped support for this hardware and there is no reason
for most users to have to have this code.

Rather than riddling code with ifdef's make one macro and let
the compiler do the dead code elimination.  This saves about 15%
of the text size.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

See also: https://bugzilla.kernel.org/show_bug.cgi?id=38862

Reported-by: jameshenderson@ruggedcom.com
Signed-off-by: David S. Miller <davem@davemloft.net>

The PCI table was using mix of defines for device id and hard coded
hex values. This patch change it to all hex values. It also adds
comments based on the names provided in the vendor driver table.

There is NO CHANGE to the actual resulting table.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Fix following warning in ifenslave.c with gcc version 4.5.2 (Ubuntu/Linaro 4.5.2-8ubuntu4).

Documentation/networking/ifenslave.c:263:4: warning: format not a string literal and no format arguments
Documentation/networking/ifenslave.c:271:3: warning: format not a string literal and no format arguments
Documentation/networking/ifenslave.c:277:3: warning: format not a string literal and no format arguments
Documentation/networking/ifenslave.c:285:3: warning: format not a string literal and no format arguments
Documentation/networking/ifenslave.c:291:3: warning: format not a string literal and no format arguments
Documentation/networking/ifenslave.c:292:3: warning: format not a string literal and no format arguments
Documentation/networking/ifenslave.c:312:4: warning: format not a string literal and no format arguments
Documentation/networking/ifenslave.c:323:3: warning: format not a string literal and no format arguments
Documentation/networking/ifenslave.c:342:4: warning: format not a string literal and no format arguments
Signed-off-by: Shan Wei <shanwei@cn.fujitsu.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

net-next-2.6/drivers/net/bnx2x/bnx2x_sp.c: 19 linux/version.h not needed.
net-next-2.6/drivers/net/caif/caif_hsi.c: 9 linux/version.h not needed.
Signed-off-by: Shan Wei <shanwei@cn.fujitsu.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

When we clone the SKB, we forget about the original
one.  Avoid this problem by using skb_share_check().
Reported-by: Penttilä Mika <mika.penttila@ixonos.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: Eric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Unfortunately we have to use a real modulus here as
the multiply trick won't work as effectively with cpu
numbers as it does with rxhash values.
Signed-off-by: David S. Miller <davem@davemloft.net>

Followup to commit f82528bc (Exclude duplicated checking for
iface-up) : We no longer need percpu tx_dropped field.
Signed-off-by: Eric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Signed-off-by: David S. Miller <davem@davemloft.net>

This patch add an unsolicited notification of the DCBX negotiated
parameters for the CEE flavor of the DCBX protocol. The notification
message is identical to the aggregated CEE get operation and holds all
the pertinent local and peer information. The notification routine is
exported so it can be invoked by drivers supporting an embedded DCBX
stack.
Signed-off-by: Shmulik Ravid <shmulikr@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

The following couple of patches add dcbnl an unsolicited notification of
the the DCB configuration for the CEE flavor of the DCBX protocol. This
is useful when the user-mode DCB client is not responsible for
conducting and resolving the DCBX negotiation (either because the DCBX
stack is embedded in the HW or the negotiation is handled by another
agent in the host), but still needs to get the negotiated parameters.
This functionality already exists for the IEEE flavor of the DCBX
protocol and these patches add it to the older CEE flavor.

The first patch extends the CEE attribute GET operation to include not
only the peer information, but also all the pertinent local
configuration (negotiated parameters). The second patch adds and export
a CEE specific notification routine.
Signed-off-by: Shmulik Ravid <shmulikr@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Convert a printk with a static to pr_<level>_once
Add and use DRV_DESCRIPTION to reduce string duplication.
Remove now unused version.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Just add GSO to vlan_features initialization, and update comments.

When we set offload features, vlan_dev_fix_features() will do more check.
In vlan_dev_fix_features(), final features is decided by
features of real device and vlan_features of real device.
Signed-off-by: Shan Wei <shanwei@cn.fujitsu.com>
Signed-off-by: David S. Miller <davem@davemloft.net>