- 26 Nov, 2015 27 commits
-
-
Ondrej Zary authored
Add remaining 870 support to is885(): - different synw, no synuw - synu[4] = 0x0c - atp_writeb_io(dev, c, 0x04, 0x00); instead of atp_writeb_io(dev, c, 0x14, 0x00); (isn't that a bug?) - atp_writeb_io(dev, c, 0x14, 0xff); instead of atp_writeb_io(dev, c, 0x14, 0x06); - different mbuf[3] and mbuf[4] checks Signed-off-by:
Ondrej Zary <linux@rainbow-software.org> Reviewed-by:
Hannes Reinicke <hare@suse.de> Acked-by:
Christoph Hellwig <hch@lst.de> Signed-off-by:
Martin K. Petersen <martin.petersen@oracle.com>
-
Ondrej Zary authored
Don't check chip_ver in is870() but add wide_chip parameter for that. Then add the non-wide support to is885(). Signed-off-by:
-
Ondrej Zary authored
Now that is880() and is885() are almost identical (except for some cpu_relax() calls and debug printks), remove is880() and use is885() instead. Signed-off-by:
-
Ondrej Zary authored
Move few chip-specifis lines out of is880() and is885() so they become almost identical. Signed-off-by:
-
Ondrej Zary authored
Add channel parameter to is870() and is880() functions to simplify comparing them with is885(). Signed-off-by:
-
Ondrej Zary authored
Unify code formatting in is870(), is880() and is885() functions to simplify comparing them. Signed-off-by:
-
Ondrej Zary authored
Signed-off-by:
-
Ondrej Zary authored
Subtract 0x40 to use _io access wrappers. Now it's obvious that is870() and is880() are very similar. Signed-off-by:
-
Ondrej Zary authored
Signed-off-by:
-
Ondrej Zary authored
Introduce *_read? and *_write? wrappers to improve code readability. Also make sure that baseport is always initialized, not only for ATP880. Signed-off-by:
-
Ondrej Zary authored
Signed-off-by:
-
Ondrej Zary authored
Signed-off-by:
-
Ondrej Zary authored
Signed-off-by:
-
Ondrej Zary authored
Signed-off-by:
-
Ondrej Zary authored
Signed-off-by:
-
Ondrej Zary authored
Untangle the tmpcip crap so it becomes obvious what ports are accessed. Signed-off-by:
-
Ondrej Zary authored
Untangle the tmpcip crap so it becomes obvious what ports are accessed. Signed-off-by:
-
Ondrej Zary authored
Untangle the tmport crap so it becomes obvious what ports are accessed. Signed-off-by:
-
Ondrej Zary authored
Untangle the tmport crap so it becomes obvious what ports are accessed. Signed-off-by:
-
Ondrej Zary authored
Untangle the tmport crap so it becomes obvious what ports are accessed. Signed-off-by:
-
Ondrej Zary authored
Untangle the tmport crap so it becomes obvious what ports are accessed. Signed-off-by:
-
Ondrej Zary authored
Untangle the tmport crap so it becomes obvious what ports are accessed. Signed-off-by:
-
Ondrej Zary authored
Untangle the tmport crap so it becomes obvious what ports are accessed. Signed-off-by:
-
Ondrej Zary authored
Untangle the tmport crap so it becomes obvious what ports are accessed. Signed-off-by:
-
Ondrej Zary authored
Untangle the tmport crap so it becomes obvious what ports are accessed. Signed-off-by:
-
Ondrej Zary authored
Remove tmport1 temporary variable to simplify the code. Signed-off-by:
-
Ondrej Zary authored
Remove workport temporary variable to simplify the code. Signed-off-by:
-
- 20 Nov, 2015 1 commit
-
-
Arnd Bergmann authored
The initio driver has for many years had two copies of the same module device table. One of them is also used for registering the other driver, the other one is entirely useless after the large scale cleanup that Alan Cox did back in 2007. The compiler warns about this whenever the driver is built-in: drivers/scsi/initio.c:131:29: warning: 'i91u_pci_devices' defined but not used [-Wunused-variable] This removes the extraneous table and the warning. Signed-off-by:
Arnd Bergmann <arnd@arndb.de> Fixes: 72d39fea ("[SCSI] initio: Convert into a real Linux driver and update to modern style") Reviewed-by:
-
- 18 Nov, 2015 2 commits
-
-
Himanshu Madhani authored
Remove firmware binary names for the ISPs, which are not submitted to linux-firmware. Signed-off-by:
Himanshu Madhani <himanshu.madhani@qlogic.com> Signed-off-by:
Giridhar Malavali <giridhar.malavali@qlogic.com> Reviewed-by:
Julian Calaby <julian.calaby@gmail.com> Reviewed-by:
Xose Vazquez Perez <xose.vazquez@gmail.com> Cc: Hannes Reinecke <hare@suse.de> Signed-off-by:
-
Geert Uytterhoeven authored
Its last user was removed 10 years ago, in commit 8b05b773 ("[SCSI] convert st to use scsi_execute_async"). Signed-off-by:
Geert Uytterhoeven <geert@linux-m68k.org> Reviewed-by:
Ewan D. Milne <emilne@redhat.com> Acked-by:
Kai Mäkisara <kai.makisara@kolumbus.fi> Signed-off-by:
-
- 17 Nov, 2015 10 commits
-
-
git://git.kernel.org/pub/scm/linux/kernel/git/davem/netLinus Torvalds authored
Pull networking fixes from David Miller: 1) Fix list tests in netfilter ingress support, from Florian Westphal. 2) Fix reversal of input and output interfaces in ingress hook invocation, from Pablo Neira Ayuso. 3) We have a use after free in r8169, caught by Dave Jones, fixed by Francois Romieu. 4) Splice use-after-free fix in AF_UNIX frmo Hannes Frederic Sowa. 5) Three ipv6 route handling bug fixes from Martin KaFai Lau: a) Don't create clone routes not managed by the fib6 tree b) Don't forget to check expiration of DST_NOCACHE routes. c) Handle rt->dst.from == NULL properly. 6) Several AF_PACKET fixes wrt transport header setting and SKB protocol setting, from Daniel Borkmann. 7) Fix thunder driver crash on shutdown, from Pavel Fedin. 8) Several Mellanox driver fixes (max MTU calculations, use of correct DMA unmap in TX path, etc.) from Saeed Mahameed, Tariq Toukan, Doron Tsur, Achiad Shochat, Eran Ben Elisha, and Noa Osherovich. 9) Several mv88e6060 DSA driver fixes (wrong bit definitions for certain registers, etc.) from Neil Armstrong. 10) Make sure to disable preemption while updating per-cpu stats of ip tunnels, from Jason A. Donenfeld. 11) Various ARM64 bpf JIT fixes, from Yang Shi. 12) Flush icache properly in ARM JITs, from Daniel Borkmann. 13) Fix masking of RX and TX interrupts in ravb driver, from Masaru Nagai. 14) Fix netdev feature propagation for devices not implementing ->ndo_set_features(). From Nikolay Aleksandrov. 15) Big endian fix in vmxnet3 driver, from Shrikrishna Khare. 16) RAW socket code increments incorrect SNMP counters, fix from Ben Cartwright-Cox. 17) IPv6 multicast SNMP counters are bumped twice, fix from Neil Horman. 18) Fix handling of VLAN headers on stacked devices when REORDER is disabled. From Vlad Yasevich. 19) Fix SKB leaks and use-after-free in ipvlan and macvlan drivers, from Sabrina Dubroca. * git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (83 commits) MAINTAINERS: Update Mellanox's Eth NIC driver entries net/core: revert "net: fix __netdev_update_features return.." and add comment af_unix: take receive queue lock while appending new skb rtnetlink: fix frame size warning in rtnl_fill_ifinfo net: use skb_clone to avoid alloc_pages failure. packet: Use PAGE_ALIGNED macro packet: Don't check frames_per_block against negative values net: phy: Use interrupts when available in NOLINK state phy: marvell: Add support for 88E1540 PHY arm64: bpf: make BPF prologue and epilogue align with ARM64 AAPCS macvlan: fix leak in macvlan_handle_frame ipvlan: fix use after free of skb ipvlan: fix leak in ipvlan_rcv_frame vlan: Do not put vlan headers back on bridge and macvlan ports vlan: Fix untag operations of stacked vlans with REORDER_HEADER off via-velocity: unconditionally drop frames with bad l2 length ipg: Remove ipg driver dl2k: Add support for IP1000A-based cards snmp: Remove duplicate OUTMCAST stat increment net: thunder: Check for driver data in nicvf_remove() ... -
Or Gerlitz authored
Eugenia (Jenny) Emantayev is replacing Amir Vadai as the mlx4 Ethernet driver maintainer. Saeed Mahameed is assigned to maintain mlx5 Eth functionality. Signed-off-by:
Or Gerlitz <ogerlitz@mellanox.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Nikolay Aleksandrov authored
This reverts commit 00ee5927 ("net: fix __netdev_update_features return on ndo_set_features failure") and adds a comment explaining why it's okay to return a value other than 0 upon error. Some drivers might actually change flags and return an error so it's better to fire a spurious notification rather than miss these. CC: Michał Mirosław <mirq-linux@rere.qmqm.pl> Signed-off-by:
Nikolay Aleksandrov <nikolay@cumulusnetworks.com> Signed-off-by:
-
Hannes Frederic Sowa authored
While possibly in future we don't necessarily need to use sk_buff_head.lock this is a rather larger change, as it affects the af_unix fd garbage collector, diag and socket cleanups. This is too much for a stable patch. For the time being grab sk_buff_head.lock without disabling bh and irqs, so don't use locked skb_queue_tail. Fixes: 869e7c62 ("net: af_unix: implement stream sendpage support") Cc: Eric Dumazet <edumazet@google.com> Signed-off-by:
Hannes Frederic Sowa <hannes@stressinduktion.org> Reported-by:
Eric Dumazet <edumazet@google.com> Acked-by:
-
Hannes Frederic Sowa authored
Fix the following warning: CC net/core/rtnetlink.o net/core/rtnetlink.c: In function ‘rtnl_fill_ifinfo’: net/core/rtnetlink.c:1308:1: warning: the frame size of 2864 bytes is larger than 2048 bytes [-Wframe-larger-than=] } ^ by splitting up the huge rtnl_fill_ifinfo into some smaller ones, so we don't have the huge frame allocations at the same time. Cc: Eric Dumazet <edumazet@google.com> Signed-off-by:
-
Martin Zhang authored
1. new skb only need dst and ip address(v4 or v6). 2. skb_copy may need high order pages, which is very rare on long running server. Signed-off-by:
Junwei Zhang <linggao.zjw@alibaba-inc.com> Signed-off-by:
Martin Zhang <martinbj2008@gmail.com> Acked-by:
-
Tobias Klauser authored
Use PAGE_ALIGNED(...) instead of open-coding it. Signed-off-by:
Tobias Klauser <tklauser@distanz.ch> Signed-off-by:
-
Tobias Klauser authored
rb->frames_per_block is an unsigned int, thus can never be negative. Also fix spacing in the calculation of frames_per_block. Signed-off-by:
-
Andrew Lunn authored
The NOLINK state will poll the phy once a second to see if the link has come up. If the phy has an interrupt line, this polling can be skipped, since the phy should interrupt when the link returns. Signed-off-by:
Andrew Lunn <andrew@lunn.ch> Signed-off-by:
-
Andrew Lunn authored
The 88E1540 can be found embedded in the Marvell 88E6352 switch. It is compatible with the 88E1510, so add support for it, using the 88E1510 specific functions. Signed-off-by:
-
