- 20 Feb, 2020 6 commits
-
-
Dan Murphy authored
Add the tlv320adcx140 codec driver family. The TLV320ADCx140 is a Burr-Brown
™ highperformance, audio analog-to-digital converter (ADC) that supports simultaneous sampling of up to four analog channels or eight digital channels for the pulse density modulation (PDM) microphone input. The device supports line and microphone inputs, and allows for both single-ended and differential input configurations. Signed-off-by:Dan Murphy <dmurphy@ti.com> Link: https://lore.kernel.org/r/20200220210759.31466-3-dmurphy@ti.comSigned-off-by:
Mark Brown <broonie@kernel.org>
-
Dan Murphy authored
Add dt bindings for the TLV320ADCx140 Burr-Brown ADC. The initial support is for the following: TLV320ADC3140 - http://www.ti.com/lit/gpn/tlv320adc3140 TLV320ADC5140 - http://www.ti.com/lit/gpn/tlv320adc5140 TLV320ADC6140 - http://www.ti.com/lit/gpn/tlv320adc6140Signed-off-by:
-
Kai Vehmanen authored
Add support to configure the HDA controller with an external HDA codec even if iDisp codec in i915 is not available. This can happen for multiple reasons: - internal graphics is disabled on the system - i915 driver is not enabled in kernel or it fails to init - i915 codec reports error in HDA codec probe - HDA codec driver probe fails Address all these scenarios, but keep using the existing topology. In case failures occur, HDMI PCM nodes are created, but they will report error if application tries to use them. No ALSA mixer controls are created. If the external HDA codec init fails as well, SOF probe will return error as before. Signed-off-by:
Kai Vehmanen <kai.vehmanen@linux.intel.com> Reviewed-by:
Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com> Reviewed-by:
Ranjani Sridharan <ranjani.sridharan@linux.intel.com> BugLink: https://bugzilla.kernel.org/show_bug.cgi?id=206085 BugLink: https://bugzilla.opensuse.org/show_bug.cgi?id=1163677 BugLink: https://github.com/thesofproject/linux/issues/1658 Link: https://lore.kernel.org/r/20200220171028.22023-3-kai.vehmanen@linux.intel.comSigned-off-by:
-
Kai Vehmanen authored
Extend the generic HDA driver to support systems where iDisp/HDMI audio codecs are disabled for some reason. Switch codecs to SoC dummy in the affected DAI links. This allows to reuse existing topologies for this case. Signed-off-by:
-
Charles Keepax authored
Currently it is possible to get the following bad config: WARNING: unmet direct dependencies detected for SND_SOC_WM5110 Depends on [n]: SOUND [=y] && !UML && SND [=y] && SND_SOC [=y] && MFD_WM5110 [=n] commit ea00d952 ("ASoC: Use imply for SND_SOC_ALL_CODECS") commit d8dd3f92 ("ASoC: Fix SND_SOC_ALL_CODECS imply misc fallout") After these two patches the machine drivers still selects the SND_SOC_WM5110 symbol which doesn't take account of the dependency added on the MFD_WM5110 symbol, fix this by also adding a dependency on MFD_WM5110 itself. Reported-by:
Randy Dunlap <rdunlap@infradead.org> Signed-off-by:
Charles Keepax <ckeepax@opensource.cirrus.com> Link: https://lore.kernel.org/r/20200220125654.7064-1-ckeepax@opensource.cirrus.comSigned-off-by:
-
Jerome Brunet authored
Now that dpcm_get_be() is used in dpcm_end_walk_at_be(), it is not a error if this function does not find a BE for the provided widget. Remove the related dev_err() trace which is confusing since things might be working as expected. When called from dpcm_add_paths(), it is an error if dpcm_get_be() fails to find a BE for the provided widget. The necessary error trace is already done in this case. Fixes: 027a4838 ("ASoC: soc-pcm: use dpcm_get_be() at dpcm_end_walk_at_be()") Signed-off-by:
Jerome Brunet <jbrunet@baylibre.com> Tested-by:
Kuninori Morimoto <kuninori.morimoto.gx@renesas.com> Cc: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com> Link: https://lore.kernel.org/r/20200219115048.934678-1-jbrunet@baylibre.comSigned-off-by:
-
- 19 Feb, 2020 16 commits
-
-
Olivier Moysan authored
Convert the STM32 I2S bindings to DT schema format using json-schema. Signed-off-by:
Olivier Moysan <olivier.moysan@st.com> Reviewed-by:
Rob Herring <robh@kernel.org> Link: https://lore.kernel.org/r/20200207120345.24672-1-olivier.moysan@st.comSigned-off-by:
-
Jerome Brunet authored
Add the codec driver of the internal DAC found on Amlogic gxl, g12a and sm1 family. Signed-off-by:
-
Jerome Brunet authored
Add the DT binding documention of the internal DAC found in the Amlogic gxl, g12a and sm1 SoC family. Signed-off-by:
-
Robin Murphy authored
The RK3328 reference design uses an external line driver IC as a buffer on the analog codec output, enabled by the GPIO_MUTE pin, and such a configuration is currently assumed in the codec driver's direct poking of GRF_SOC_CON10 to control the GPIO_MUTE output value. However, some boards wire up analog audio yet use that pin for some other purpose, so that assumption doesn't always hold. Update this functionality to rely on an explicit GPIO descriptor, such that it can be managed at the board level. Signed-off-by:
Robin Murphy <robin.murphy@arm.com> Link: https://lore.kernel.org/r/5bc383ed1832f0f5d1dcb3c97ad92fd68e5217e3.1581376744.git.robin.murphy@arm.comSigned-off-by:
-
Robin Murphy authored
Existing RK3328 codec drivers have overloaded the GRF phandle to assume implicit control of the limited-function GPIO_MUTE pin, which is usually used to enable an external audio line driver IC. Since this pin has a proper binding of its own (see gpio/rockchip,rk3328-grf-gpio.txt), make a GPIO explicit in the codec binding too. This will help avoid ambiguity on boards that use that pin for some other purpose. (and while touching the example, enforce the "don't include status" rule) Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Dan Murphy authored
Add additional support for ISENSE and VSENSE feature for the TAS2562. This feature monitors the output to the loud speaker attempts to eliminate IR drop errors due to packaging. This feature is defined in Section 8.4.5 IV Sense of the data sheet. Signed-off-by:
-
Tzung-Bi Shih authored
Uses SND_SOC_DAPM_PINCTRL in TDM out to simplify code. Signed-off-by:
Tzung-Bi Shih <tzungbi@google.com> Link: https://lore.kernel.org/r/20200219170951.2.I7ed16ef57d9e0bcafc37e766142f68cbad5b54c6@changeidSigned-off-by:
-
Tzung-Bi Shih authored
Selects sleep_state when initializing PINCTRL widget. Signed-off-by:
-
Jerome Brunet authored
This reverts commit b2354e40. This change might have been desirable to ensure the uniqueness of the component name. It would have helped to better support linux devices which register multiple components, something is which more common than initially thought. However, some card driver are directly using dev_name() to fill the component names of the dai_link which is a problem if want to change the way ASoC generates the component names. Until we figure out the appropriate way to deal with this, revert the change and keep the names as they were. There might be a couple of warning related to debugfs (which were already present before the change) but it is still better than breaking working audio cards. Signed-off-by:
Marek Szyprowski <m.szyprowski@samsung.com> Cc: Marek Szyprowski <m.szyprowski@samsung.com> Link: https://lore.kernel.org/r/20200219102526.692126-1-jbrunet@baylibre.comSigned-off-by:
-
Jeff Chang authored
1. add mt6660_component_settign for Component INIT Setting Signed-off-by:
Jeff Chang <jeff_chang@richtek.com> Link: https://lore.kernel.org/r/1582103064-25088-1-git-send-email-richtek.jeff.chang@gmail.comSigned-off-by:
-
- 18 Feb, 2020 18 commits
-
-
Kuninori Morimoto authored
Signed-off-by:
Takashi Iwai <tiwai@suse.de> Reviewed-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
Signed-off-by:
-
Kuninori Morimoto authored
ALSA code has SNDRV_PCM_STREAM_PLAYBACK/CAPTURE everywhere. Having for_each_xxxx macro is useful. This patch adds for_each_pcm_streams() for it. Signed-off-by:
-
Kuninori Morimoto authored
DAI has playback_active and capture_active to care usage count. OTOH, we have SNDRV_PCM_STREAM_PLAYBACK/CAPTURE. But because of this kind of implementation mismatch, ALSA SoC has many verbose code. To solve this issue, this patch merge playback_active/capture_active into stream_active[2]; Signed-off-by:
-
Kuninori Morimoto authored
When we use some kind of lock, we need to do unlock. In that time, multi unlock/return is not good implementation. This patch add label and use goto at dpcm_fe_dai_open() to reduce such code. Signed-off-by:
-
Kuninori Morimoto authored
Below functions are doing very similar things, the difference is used state only. snd_soc_dpcm_can_be_free_stop() snd_soc_dpcm_can_be_params() This patch adds common snd_soc_dpcm_check_state(), and use it from snd_soc_dpcm_can_be_free_stop() / snd_soc_dpcm_can_be_params(). It can reduce duplicate code. Signed-off-by:
-
Kuninori Morimoto authored
No one is using snd_soc_dpcm_be_get/set_state(). If it exists only by assumption that "it may be necessary someday", let's remove it now. Otherwise code maintenance will be difficult. We can revive it when we really needed it. Let's remove it, so far. Signed-off-by:
-
Kuninori Morimoto authored
No one is using soc_dpcm_be_digital_mute(). If it exists only by assumption that "it may be necessary someday", let's remove it now. Otherwise code maintenance will be difficult. We can revive it when we really needed it. Let's remove it, so far. Signed-off-by:
-
Kuninori Morimoto authored
dpcm_end_walk_at_be() and dpcm_get_be() are almost same code. This patch uses dpcm_get_be() from dpcm_end_walk_at_be(). Signed-off-by:
-
Kuninori Morimoto authored
dpcm_end_walk_at_be() has very duplicate code. dpcm_end_walk_at_be() { ... if (stream == SNDRV_PCM_STREAM_PLAYBACK) { (1) /* code for Playback */ } else { (2) /* code for Capture */ } } The difference between Playback (1) and Capture (2) code is pointer only (= "playback_widget" or "caputre_widget"). OTOH, now we already has dai_get_widget() for it. This means we can merge (1) and (2). This patch do it and remove duplicated code. Signed-off-by: -
Kuninori Morimoto authored
dpcm_get_be() has very duplicate code. dpcm_get_be() { ... if (stream == SNDRV_PCM_STREAM_PLAYBACK) { (1) /* code for Playback */ } else { (2) /* code for Capture */ } } The difference between Playback (1) and Capture (2) code is pointer only (= "playback_widget" or "caputre_widget"). OTOH, now we already has dai_get_widget() for it. This means we can merge (1) and (2). This patch do it and remove duplicated code. Signed-off-by: -
Kuninori Morimoto authored
This patch moves dai_get_widget() to top side. This is prepare for cleanup soc-pcm.c Signed-off-by:
-
