- 04 Jan, 2013 22 commits
-
-
Jiri Pirko authored
Nobody uses this now. Remove it. Signed-off-by:
Jiri Pirko <jiri@resnulli.us> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Jiri Pirko authored
Signed-off-by:
-
Jiri Pirko authored
Benefit from new upper dev list and free bonding from dev->master usage. Signed-off-by:
-
Jiri Pirko authored
Signed-off-by:
-
Jiri Pirko authored
Also, since all users call __vlan_find_dev_deep() with rcu_read_lock, make no possibility to call this with rtnl mutex held only. Signed-off-by:
-
Jiri Pirko authored
Also benefit from rcu_read_lock held and use __in_dev_get_rcu() in ipv4 case. Signed-off-by:
-
Jiri Pirko authored
rcu_read_lock was missing here Signed-off-by:
Sony Chacko <sony.chacko@qlogic.com> Signed-off-by:
-
Jiri Pirko authored
Signed-off-by:
-
Jiri Pirko authored
Signed-off-by:
-
Jiri Pirko authored
Signed-off-by:
-
Jiri Pirko authored
Signed-off-by:
-
Jiri Pirko authored
Signed-off-by:
-
Jiri Pirko authored
Signed-off-by:
-
Jiri Pirko authored
Signed-off-by:
-
Jiri Pirko authored
This lists are supposed to serve for storing pointers to all upper devices. Eventually it will replace dev->master pointer which is used for bonding, bridge, team but it cannot be used for vlan, macvlan where there might be multiple upper present. In case the upper link is replacement for dev->master, it is marked with "master" flag. New upper device list resolves this limitation. Also, the information stored in lists is used for preventing looping setups like "bond->somethingelse->samebond" Signed-off-by:
-
Jiri Pirko authored
Previously, when invalid address was passed to ndo_set_mac_address, random mac was generated and set. Fix this by returning -EADDRNOTAVAIL in this situation. Also polish the code around a bit. Signed-off-by:
-
Jiri Pirko authored
Also remove unused "mac" from uml_net struct. Signed-off-by:
-
Jiri Pirko authored
NET_ADDR_SET is set in dev_set_mac_address() no need to alter dev->addr_assign_type value in drivers. Signed-off-by:
-
Jiri Pirko authored
This is the way to indicate that mac address of a device has been set by dev_set_mac_address() Signed-off-by:
-
Jiri Pirko authored
Not a bitfield, but a plain value. Signed-off-by:
-
Jiri Pirko authored
Signed-off-by:
-
Jiri Pirko authored
Benefit from existence of dev_set_mac_address() and remove duplicate code. Signed-off-by:
-
- 03 Jan, 2013 3 commits
-
-
Flavio Leitner authored
Update master's carrier state when there is any change with its ports. Signed-off-by:
Flavio Leitner <fbl@redhat.com> Acked-by:
-
Sony Chacko authored
Fix the following error reported by kbuild test robot. static declaration of 'qlcnic_restore_indev_addr' follows non-static declaration. Signed-off-by:
Shahed Shaikh <shahed.shaikh@qlogic.com> Signed-off-by:
-
Stephen Rothwell authored
Signed-off-by:
Stephen Rothwell <sfr@canb.auug.org.au> Signed-off-by:
-
- 02 Jan, 2013 15 commits
-
-
Signed-off-by: Sony Chacko authored
Signed-off-by:
-
Shahed Shaikh authored
Signed-off-by:
-
Sony Chacko authored
83xx ethtool interface routines Signed-off-by:
Anirban Chakraborty <anirban.chakraborty@qlogic.com> Signed-off-by:
Sucheta Chakraborty <sucheta.chakraborty@qlogic.com> Signed-off-by:
Jitendra Kalsaria <jitendra.kalsaria@qlogic.com> Signed-off-by:
-
Sony Chacko authored
Add 83xx register dump routines Update 82xx register dump routines Signed-off-by:
Rajesh Borundia <rajesh.borundia@qlogic.com> Signed-off-by:
Sritej Velaga <sritej.velaga@qlogic.com> Signed-off-by:
-
Sony Chacko authored
Enable 83xx virtual NIC mode Signed-off-by:
-
Sony Chacko authored
Flash template provides instructions to stop, restart and initalize the firmware. These instructions are abstracted as a series of read, write and poll operations on hardware registers. Register information and operation specifics are not exposed to the driver. Driver reads the template from flash and executes the instructions located at pre-defined offsets. Template based firmware reset recovery and initialization mechanism minimize driver changes as firmware evolves. Signed-off-by:
-
Sony Chacko authored
Inter Driver Communication (IDC) module. CNA function drivers(ISCSI, FCOE and NIC) which shares the adapter relies on IDC mechanism for gracefull shut down, restart and firmware error recovery. Signed-off-by:
-
Sony Chacko authored
83xx adapter flash memory map, data structures and interface routines Signed-off-by:
Himanshu Madhani <himanshu.madhani@qlogic.com> Signed-off-by:
-
Sony Chacko authored
Add 83xx sysfs interface routines Update 82xx sysfs interface routines Signed-off-by:
-
Sony Chacko authored
Enable base 83xx adapter driver. Common driver interface routines like probe, interface up/down routines, irq and resource allocation routines are modified to add support for 83xx adapter. Signed-off-by:
-
Sony Chacko authored
Add 83xx adapter data path routines Update few 82xx adapter data path routines Modify datapath resource allocation routines Signed-off-by:
-
Sony Chacko authored
83xx adapter register map. 83xx hardware interface routines. Signed-off-by:
-
Himanshu Madhani authored
Refactor 82xx driver to support new adapter - Qlogic 83XX CNA Use QLC_SHARED_REG_RD32 and QLC__SHARED_REG_WR32 macros for 82xx and 83xx common register access. Signed-off-by:
-
Sony Chacko authored
Refactor 82xx driver to support new adapter - Qlogic 83XX CNA Create adapter abstraction layer and seperate 82xx hardware access routines. Create mailbox based HW interface mechanism Signed-off-by:
-
Ariel Elior authored
Add the various VF device ids (of all supported hardware) Add the calls to enable_sriov and disable_sriov to enable the SR-IOV feature. This patch also advances the version and release date of the bnx2x module. Signed-off-by:
Ariel Elior <ariele@broadcom.com> Signed-off-by:
Eilon Greenstein <eilong@broadcom.com> Signed-off-by:
-
